1. 參數資料
        型號: MAX6681MEE+
        廠商: Maxim Integrated
        文件頁數: 15/17頁
        文件大?。?/td> 242K
        描述: IC TEMP SENSOR SMBUS 16-QSOP
        產品培訓模塊: Lead (SnPb) Finish for COTS
        Obsolescence Mitigation Program
        標準包裝: 100
        功能: 溫度計,恒溫計
        傳感器類型: 內部和外部
        感應溫度: -55°C ~ 125°C,外部傳感器
        精確度: ±5°C 本地(最大),±3°C 遠程(最大)
        拓?fù)洌?/td> ADC,多路復用器,寄存器庫
        輸出類型: I²C?/SMBus?
        輸出警報:
        輸出風扇:
        電源電壓: 3 V ~ 5.5 V
        工作溫度: -55°C ~ 125°C
        安裝類型: 表面貼裝
        封裝/外殼: 16-SSOP(0.154",3.90mm 寬)
        供應商設備封裝: 16-QSOP
        包裝: 管件
        reside on the same bus without address conflicts
        (Table 9).
        The address pin states are checked at POR and RESET
        only, and the address data stays latched to reduce qui-
        escent supply current due to the bias current needed
        for high-Z state detection. The MAX6680/MAX6681 also
        respond to the SMBus Alert Response slave address
        (see the Alert Response Address section).
        POR and UVLO
        The MAX6680/MAX6681 have a volatile memory. To
        prevent unreliable power-supply conditions from cor-
        rupting the data in memory and causing erratic behav-
        ior, a POR voltage detector monitors V
        CC
        and clears the
        memory if V
        CC
        falls below 1.91V (typ, see Electrical
        Characteristics). When power is first applied and V
        CC
        rises above 2.0V (typ), the logic blocks begin operating,
        although reads and writes at V
        CC
        levels below 3.0V are
        not recommended. A second V
        CC
        comparator, the ADC
        UVLO comparator, prevents the ADC from converting
        until there is sufficient headroom (V
        CC
        = 2.8V typ).
        Power-Up Defaults
        "  Interrupt latch is cleared.
        "  Address select pin is sampled.
        "  ADC begins autoconverting at a 1Hz rate (legacy
        resolution).
        "  Command register is set to 00h to facilitate quick
        internal Receive Byte queries.
        "  T
        HIGH
        and T
        LOW
        registers are set to max and min
        limits, respectively.
        "  Hysteresis is set to 6癈.
        "  Transistor type is set to a substrate or common-col-
        lector PNP.
        Temperature Offset
        The MAX6680/MAX6681 are designed to provide ?癈
        accuracy for common microprocessors and discrete
        transistors. To accommodate processes that differ sig-
        nificantly in their ideality factor, the user can
        increase/decrease the Remote Temperature Sensor
        Data register with an offset by writing to the External
        Offset High and Low Byte registers (11h and 12h,
        respectively). The offset temperature data is represent-
        ed as a 10 bits + sign with a 0.125LSB resolution.
        ?癈 Fail-Safe Remote/Local Temperature
        Sensors with SMBus Interface
        ______________________________________________________________________________________   15
        DATA
        CONVERSION RATE (Hz)
        00h
        0.0625
        01h
        0.125
        02h
        0.25
        03h
        0.5
        04h
        1
        05h
        2
        06h
        4
        07h
        8
        Table 8. Conversion-Rate Control Byte
        Note: If extended resolution is selected using bit 4 of the
        Configuration register, the extended conversion is limited to a
        maximum of 4Hz.
        ADD0
        ADD1
        ADDRESS
        GND
        GND
        0011 000
        GND
        HIGH-Z
        0011 001
        GND
        V
        CC
        0011 010
        HIGH-Z
        GND
        0101 001
        HIGH-Z
        HIGH-Z
        0101 010
        HIGH-Z
        V
        CC
        0101 011
        V
        CC
        GND
        1001 100
        V
        CC
        HIGH-Z
        1001 101
        V
        CC
        V
        CC
        1001 110
        Table 9. POR Slave Address Decoding
        (ADD0 and ADD1)
        Chip Information
        TRANSISTOR COUNT: 17,150
        PROCESS: BiCMOS
        相關PDF資料
        PDF描述
        MAX6689UP34+ IC 7CH PREC TEMP MONITOR 20TSSOP
        MAX6690MEE+ IC TEMP SENSOR SMBUS 16-QSOP
        MAX6692YMSA+ IC SENSOR REMOTE SMBUS 8SOIC
        MAX6693UP9A+T IC TEMP MONITOR 7CH 20-TSSOP
        MAX6694TE9A+T IC TEMP MONITOR 5CH 16TQFN
        相關代理商/技術參數
        參數描述
        MAX6681MEE+ 功能描述:板上安裝溫度傳感器 Fail-Safe Temperature Sensor RoHS:否 制造商:Omron Electronics 輸出類型:Digital 配置: 準確性:+/- 1.5 C, +/- 3 C 溫度閾值: 數字輸出 - 總線接口:2-Wire, I2C, SMBus 電源電壓-最大:5.5 V 電源電壓-最小:4.5 V 最大工作溫度:+ 50 C 最小工作溫度:0 C 關閉: 安裝風格: 封裝 / 箱體: 設備功能:Temperature and Humidity Sensor
        MAX6681MEE+T 功能描述:板上安裝溫度傳感器 Fail-Safe Temperature Sensor RoHS:否 制造商:Omron Electronics 輸出類型:Digital 配置: 準確性:+/- 1.5 C, +/- 3 C 溫度閾值: 數字輸出 - 總線接口:2-Wire, I2C, SMBus 電源電壓-最大:5.5 V 電源電壓-最小:4.5 V 最大工作溫度:+ 50 C 最小工作溫度:0 C 關閉: 安裝風格: 封裝 / 箱體: 設備功能:Temperature and Humidity Sensor
        MAX6681MEE-T 功能描述:板上安裝溫度傳感器 RoHS:否 制造商:Omron Electronics 輸出類型:Digital 配置: 準確性:+/- 1.5 C, +/- 3 C 溫度閾值: 數字輸出 - 總線接口:2-Wire, I2C, SMBus 電源電壓-最大:5.5 V 電源電壓-最小:4.5 V 最大工作溫度:+ 50 C 最小工作溫度:0 C 關閉: 安裝風格: 封裝 / 箱體: 設備功能:Temperature and Humidity Sensor
        MAX6682MUA 功能描述:數據轉換 IC - 多種 RoHS:否 制造商:Texas Instruments 轉換器數量:1 分辨率:8 bit 工作電源電壓:2.7 V to 5.5 V 功耗: 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:MSOP-10 封裝:Reel
        MAX6682MUA+ 功能描述:數據轉換 IC - 多種 Thermistor to Digital Converter RoHS:否 制造商:Texas Instruments 轉換器數量:1 分辨率:8 bit 工作電源電壓:2.7 V to 5.5 V 功耗: 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:MSOP-10 封裝:Reel