- 您現在的位置：買賣IC網 > PDF目錄385550 > MAX791 (Maxim Integrated Products, Inc.) Microprocessor Supervisory Circuit(微處理器監控電路) PDF資料下載
參數資料
| 型號： | MAX791 |
| 廠商： | Maxim Integrated Products, Inc. |
| 英文描述： | Microprocessor Supervisory Circuit(微處理器監控電路) |
| 中文描述： | 微處理器監控電路 |
| 文件頁數： | 14/20頁 |
| 文件大小： | 198K |
| 代理商： | MAX791 |
M
Low-Battery Monitor
The MAX791 low-battery voltage function monitors
VBATT. Low-battery detection of 2.0V ±0.15V is moni-
tored only during the reset-timeout period (200ms) that
occurs either after a normal power-up sequence or
after the MR reset input has been returned to its high
state. If the battery voltage is below 2.0V, the second
CE pulse is inhibited after reset timeout. If the battery
voltage is above 2.0V, all CE pulses are allowed
through the CE gate after the reset timeout period. To
use this function, after the 200ms reset delay, write 00
(HEX) to a location using the first CE pulse, and write
FF (HEX) to the same location using the second CE
pulse following RESET going inactive on power-up. The
contents of the memory then indicates a good battery
(FF) or a low battery (00) (Figure 11).
__________Applic ations Information
The MAX791 is not short-circuit protected. Shorting
V
OUT
to ground, other than power-up transients such
as charging a decoupling capacitor, destroys the
device.
All open-circuit outputs swing between V
OUT
and GND
rather than V
CC
and GND.
If long leads connect to the chip inputs, ensure that
these lines are free from ringing and other conditions
that would forward bias the chip’s protection diodes.
There are three distinct modes of operation:
1)
Normal operating mode with all circuitry powered
up. Typical supply current from V
CC
is 60μA, while
only leakage currents flow from the battery.
2)
Battery-backup mode where V
CC
is typically within
0.7V below VBATT. All circuitry is powered up and
the supply current from the battery is typically less
than 60μA.
3)
Battery-backup mode where V
CC
is less than
VBATT by at least 0.7V. VBATT supply current is
than 1μA max.
Mic roproc essor S upervisory Circ uit
14
______________________________________________________________________________________
MAX791
V
OUT
GND
CE IN
CE
CE
CE OUT
CE
CE
CE
CE
CE
CE
*MAXIMUM Rp VALUE DEPENDS ON
THE NUMBER OF RAMS.
MINIMUM Rp VALUE IS 1k
ACTIVE-HIGH CE
LINES FROM LOGIC
RAM 1
RAM 2
RAM 3
RAM 4
Rp*
Figure 13. Alternate CE Gating
MAX791
1
0.47F
1N4148
+5V
2
3
V
CC
GND
VBATT
4
V
OUT
Figure 12. SuperCap or MaxCap on VBATT
相關PDF資料 |
PDF描述 |
|---|---|
| MAX792R | Microprocessor and Non-Volatile Memory Supervisory Circuits(復位門限2.61V,微處理器和非易失存儲器監控電路) |
| MAX792S | Microprocessor and Non-Volatile Memory Supervisory Circuits(復位門限1.91V,微處理器和非易失存儲器監控電路) |
| MAX792T | Microprocessor and Non-Volatile Memory Supervisory Circuits(復位門限3.06V,微處理器和非易失存儲器監控電路) |
| MAX793 | 3.0V/3.3V Adjustable Microprocessor Supervisory Circuits(具有監控器、芯片使能和支持備用電池的復位器) |
| MAX794 | 3.0V/3.3V Adjustable Microprocessor Supervisory Circuits(具有可調閾值監控器、芯片使能和支持備用電池的復位器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX791C/D | 功能描述:監控電路 RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| MAX791CPE | 功能描述:監控電路 RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| MAX791CPE+ | 功能描述:監控電路 MPU Supervisor RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| MAX791CSE | 功能描述:監控電路 RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| MAX791CSE+ | 功能描述:監控電路 MPU Supervisor RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。