- 您現在的位置：買賣IC網 > PDF目錄8575 > MAX9512ATE+T (Maxim Integrated Products)IC VIDEO FILTER AMP 16-TQFN PDF資料下載
參數資料
| 型號： | MAX9512ATE+T |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 6/19頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC VIDEO FILTER AMP 16-TQFN |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 1 |
| 應用： | 濾波器 |
| 電路數： | 1 |
| 電流 - 電源： | 13mA |
| 電壓 - 電源，單路/雙路(±)： | 2.7 V ~ 3.6 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-WFQFN 裸露焊盤 |
| 供應商設備封裝： | 16-TQFN-EP（3x3） |
| 包裝： | 標準包裝 |
| 產品目錄頁面： | 1424 (CN2011-ZH PDF) |
| 其它名稱： | MAX9512ATE+TDKR |
第1頁第2頁第3頁第4頁第5頁當前第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁
MAX9512
Video Filter Amplifier with SmartSleep
and Y/C Mixer Circuit
14
______________________________________________________________________________________
Inputs
The MAX9512 video inputs YIN and CIN should be
directly connected to the output of the video current
DAC. DC-coupling ensures that the input signals are
ground referenced such that the sync tip of the luma
signal is within 50mV of ground and the blank level of
the chroma signal is between 0.5V and 0.65V.
Video Reconstruction Filter
The MAX9512 filter passband is 6.75MHz, which makes
the device suitable for the higher bandwidth video sig-
nals from a DVD chip. Broadcast video signals actually
require less bandwidth because of channel limitations:
NTSC signals have 4.2MHz bandwidth, and PAL signals
have 5MHz bandwidth. Video signals from a DVD player
are not channel limited; therefore, the bandwidth of DVD
video signals can push right against the Nyquist limit of
6.75MHz. (Recommendation ITU-R BT.601-5 specifies
13.5MHz as the sampling rate for standard-definition
video). Therefore, the maximum bandwidth of the signal
is 6.75MHz. To ease the filtering requirements, most
modern video systems oversample by two times, clock-
ing the video current DAC at 27MHz.
Y/C Mixer
The Y/C mixer adds the luma and chroma signals
together to create a composite video signal. Since
chroma is a phase modulated carrier at 3.58MHz for
NTSC and 4.43MHz for PAL, the chroma signal is AC-
coupled into the Y/C mixer so that the variation in blank
level from one video source to another video source
does not affect the DC bias of the composite video sig-
nal. The highpass corner frequency of the chroma AC-
coupling circuit is 300kHz.
Outputs
The video output amplifiers can both source and sink
load current, allowing output loads to be DC- or AC-
coupled. The amplifier output stage needs about
300mV of headroom from either supply rail. The
MAX9512 has an internal level shift circuit that positions
the sync tip at approximately 300mV at the output. The
blank level of the chroma output is positioned at
approximately 1.3V if the blank level of the chroma
input signal is 0.5V. The blank level of the chroma out-
put is positioned at approximately 1.5V if the blank level
of the chroma input signal is 0.6V.
If the supply voltage is greater than 3.135V (5% below
a 3.3V supply), each amplifier can drive two DC-cou-
pled video loads to ground. If the supply is less than
3.135V, each amplifier can drive only one DC-coupled
or AC-coupled video load.
Shutdown
When
SHDN is low, the MAX9512 draws less than 1A
supply current. All the amplifier outputs become high
impedance. The effective output resistance at the video
outputs is 28kΩ, due to the internal feedback resistors
to ground.
Applications Information
Reducing Power Consumption in
the Video DACs
YIN and CIN have high-impedance input buffers and
can work with source resistances as high as 300Ω. To
reduce power dissipation in the video DACs, the DAC
output resistor can be scaled up in value. The refer-
ence resistor that sets the reference current inside the
video DACs must also be similarly scaled up. For
instance, if the output resistor is 37.5Ω, the DAC must
source 26.7mA when the output is 1V. If the output
resistor is increased to 300Ω, the DAC only needs to
source 3.33mA when the output is 1V.
There is parasitic capacitance from the DAC output to
ground. That capacitance in parallel with the DAC out-
put resistor forms a pole that can potentially roll off the
frequency response of the video signal. For example,
300Ω in parallel with 50pF creates a pole at 10.6MHz.
To minimize this capacitance, reduce the area of the
signal trace attached to the DAC output as much as
possible, and place the MAX9512 as close to the video
DAC outputs as possible.
相關PDF資料 |
PDF描述 |
|---|---|
| VI-23X-IV-F2 | CONVERTER MOD DC/DC 5.2V 150W |
| VI-B5L-MU | CONVERTER MOD DC/DC 28V 200W |
| VI-23V-IV-F2 | CONVERTER MOD DC/DC 5.8V 150W |
| VI-23T-IV-F1 | CONVERTER MOD DC/DC 6.5V 150W |
| VI-23P-IV-F3 | CONVERTER MOD DC/DC 13.8V 150W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX9513ATE+ | 功能描述:視頻放大器 CVBS Video Filter Amplifier RoHS:否 制造商:ON Semiconductor 通道數量:4 電源類型: 工作電源電壓:3.3 V, 5 V 電源電流: 最小工作溫度: 最大工作溫度: 封裝 / 箱體:TSSOP-14 封裝:Reel |
| MAX9513ATE+T | 功能描述:視頻放大器 CVBS Video Filter Amplifier RoHS:否 制造商:ON Semiconductor 通道數量:4 電源類型: 工作電源電壓:3.3 V, 5 V 電源電流: 最小工作溫度: 最大工作溫度: 封裝 / 箱體:TSSOP-14 封裝:Reel |
| MAX9513EVKIT+ | 制造商:Maxim Integrated Products 功能描述:MAX9513 EVAL KIT - Rail/Tube |
| MAX9515ABS+T | 功能描述:視頻放大器 Video Filter Amp RoHS:否 制造商:ON Semiconductor 通道數量:4 電源類型: 工作電源電壓:3.3 V, 5 V 電源電流: 最小工作溫度: 最大工作溫度: 封裝 / 箱體:TSSOP-14 封裝:Reel |
| MAX9515ABS+TG45 | 制造商:Maxim from Components Direct 功能描述:MAXIM MAX9515ABS+TG45 VIDEO AMPLIFIERS - Tape and Reel 制造商:Maxim 功能描述:Maxim MAX9515ABS+TG45 Video Amplifiers |
發布緊急采購，3分鐘左右您將得到回復。