- 您現在的位置：買賣IC網 > PDF目錄10460 > MAX9713ETJ+ (Maxim Integrated Products)IC AMP AUDIO PWR 8W MONO 32TQFN PDF資料下載
參數資料
| 型號： | MAX9713ETJ+ |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 17/18頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC AMP AUDIO PWR 8W MONO 32TQFN |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 60 |
| 類型： | D 類 |
| 輸出類型： | 1-通道（單聲道） |
| 在某負載時最大輸出功率 x 通道數量： | 8W x 1 @ 16 歐姆 |
| 電源電壓： | 10 V ~ 25 V |
| 特點： | 消除爆音，差分輸入，靜音，短路和熱保護，關機 |
| 安裝類型： | 表面貼裝 |
| 供應商設備封裝： | 32-TQFN-EP（5x5） |
| 封裝/外殼： | 32-WFQFN 裸露焊盤 |
| 包裝： | 管件 |
| 產品目錄頁面： | 1392 (CN2011-ZH PDF) |
MAX9713/MAX9714
Detailed Description
The MAX9713/MAX9714 filterless, Class D audio power
amplifiers feature several improvements to switch-
mode amplifier technology. The MAX9713 is a mono
amplifier, the MAX9714 is a stereo amplifier. These
devices offer Class AB performance with Class D effi-
ciency, while occupying minimal board space. A
unique filterless modulation scheme and spread-spec-
trum switching mode create a compact, flexible, low-
noise, efficient audio power amplifier. The differential
input architecture reduces common-mode noise pick-
up, and can be used without input-coupling capacitors.
The devices can also be configured as a single-ended
input amplifier.
Comparators monitor the device inputs and compare
the complementary input voltages to the triangle wave-
form. The comparators trip when the input magnitude of
the triangle exceeds their corresponding input voltage.
Operating Modes
Fixed-Frequency Modulation (FFM) Mode
The MAX9713/MAX9714 feature three FFM modes with
different switching frequencies (Table 1). In FFM mode,
the frequency spectrum of the Class D output consists of
the fundamental switching frequency and its associated
harmonics (see the Wideband Output Spectrum (FFM
Mode) graph in the Typical Operating Characteristics).
The MAX9713/ MAX9714 allow the switching frequency
to be changed by
±35%, should the frequency of one or
more of the harmonics fall in a sensitive band. This can
be done at any time and not affect audio reproduction.
Spread-Spectrum Modulation (SSM) Mode
The MAX9713/MAX9714 feature a unique spread-spec-
trum mode that flattens the wideband spectral compo-
nents, improving EMI emissions that may be radiated
by the speaker and cables. This mode is enabled by
setting FS1 = FS2 = H. In SSM mode, the switching fre-
quency varies randomly by
±1.7%kHz around the cen-
ter frequency (335kHz). The modulation scheme
remains the same, but the period of the triangle wave-
form changes from cycle to cycle. Instead of a large
amount of spectral energy present at multiples of the
switching frequency, the energy is now spread over a
bandwidth that increases with frequency. Above a few
megahertz, the wideband spectrum looks like white
noise for EMI purposes (Figure 2).
Efficiency
Efficiency of a Class D amplifier is attributed to the
region of operation of the output stage transistors. In a
Class D amplifier, the output transistors act as current-
steering switches and consume negligible additional
power. Any power loss associated with the Class D out-
put stage is mostly due to the I2R loss of the MOSFET
on-resistance, and quiescent current overhead.
The theoretical best efficiency of a linear amplifier is
78%, however that efficiency is only exhibited at peak
output powers. Under normal operating levels (typical
music reproduction levels), efficiency falls below 30%,
whereas the MAX9714 still exhibits >80% efficiencies
under the same conditions (Figure 3).
Shutdown
The MAX9713/MAX9714 have a shutdown mode that
reduces power consumption and extends battery life.
Driving
SHDN low places the device in low-power
(0.2A) shutdown mode. Connect
SHDN to a logic high
for normal operation.
Click-and-Pop Suppression
The MAX9713/MAX9714 feature comprehensive click-
and-pop suppression that eliminates audible transients
on startup and shutdown. While in shutdown, the H-
bridge is pulled to GND through 300k
Ω. During startup,
6W, Filterless, Spread-Spectrum
Mono/Stereo Class D Amplifiers
8
_______________________________________________________________________________________
Table 1. Operating Modes
FS1
FS2
SWITCHING MODE
(kHz)
L
335
L
H
460
H
L
236
H
335
±7%
Figure 1. MAX9714 Outputs with No Input Signal Applied
VIN = 0V
OUT-
OUT+
相關PDF資料 |
PDF描述 |
|---|---|
| VE-21V-IW-F1 | CONVERTER MOD DC/DC 5.8V 100W |
| MAX9703ETJ+ | IC AMP AUDIO PWR 18W MONO 32TQFN |
| VI-251-IU | CONVERTER MOD DC/DC 12V 200W |
| VJ1206Y151MXGAT5Z | CAP CER 150PF 1KV 20% X7R 1206 |
| VE-25P-IU | CONVERTER MOD DC/DC 13.8V 200W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX9713ETJ+ | 功能描述:音頻放大器 6W Filterless Class D Amplifier RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| MAX9713ETJ+T | 功能描述:音頻放大器 6W Filterless Class D Amplifier RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| MAX9713ETJ-T | 功能描述:音頻放大器 RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| MAX9713EVKIT | 功能描述:音頻放大器 Evaluation Kit for the MAX9713 RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| MAX9714ETJ | 功能描述:音頻放大器 RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。