- 您現在的位置：買賣IC網 > PDF目錄10346 > MAX9725BETC+T (Maxim Integrated Products)IC AMP AUDIO .025W STER 12TQFN PDF資料下載
參數資料
| 型號： | MAX9725BETC+T |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 17/17頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC AMP AUDIO .025W STER 12TQFN |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 2,500 |
| 系列： | DirectDrive® |
| 類型： | AB 類 |
| 輸出類型： | 耳機，2-通道（立體聲） |
| 在某負載時最大輸出功率 x 通道數量： | 25mW x 2 @ 16 歐姆 |
| 電源電壓： | 900 mV ~ 1.8 V |
| 特點： | 消除爆音，短路保護，關機 |
| 安裝類型： | 表面貼裝 |
| 供應商設備封裝： | 12-TQFN-EP（4x4） |
| 封裝/外殼： | 12-WQFN 裸露焊盤 |
| 包裝： | 帶卷 (TR) |
MAX9725
Low-Frequency Response
Large DC-blocking capacitors limit the amplifier’s low-
frequency response and can distort the audio signal:
1) The impedance of the headphone load and the DC-
blocking capacitor forms a highpass filter with the
-3dB point set by:
where RL is the impedance of the headphone and
COUT is the value of the DC-blocking capacitor. The
highpass filter is required by conventional single-
ended, single power-supply headphone drivers to
block the midrail DC-bias component of the audio
signal from the headphones. The drawback to the
filter is that it can attenuate low-frequency signals.
Larger values of COUT reduce this effect but result
in physically larger, more expensive capacitors.
Figure 2 shows the relationship between the size of
COUT and the resulting low-frequency attenuation.
Note that the -3dB point for a 16
Ω headphone with
a 100F blocking capacitor is 100Hz, well within the
normal audio band, resulting in low-frequency
attenuation of the reproduced signal.
2) The voltage coefficient of the DC-blocking capacitor
contributes distortion to the reproduced audio signal
as the capacitance value varies when the function of
the voltage across the capacitor changes. At low
frequencies, the reactance of the capacitor domi-
nates at frequencies below the -3dB point and the
voltage coefficient appears as frequency-dependent
distortion. Figure 3 shows the THD+N introduced by
two different capacitor dielectric types. Note that
below 100Hz, THD+N increases rapidly.
The combination of low-frequency attenuation and fre-
quency-dependent distortion compromises audio
reproduction in portable audio equipment that empha-
sizes low-frequency effects such as multimedia lap-
tops, as well as MP3, CD, and DVD players. These
low-frequency, capacitor-related deficiencies are elimi-
nated by using DirectDrive technology.
Charge Pump
The MAX9725 features a low-noise charge pump. The
580kHz switching frequency is well beyond the audio
range, and does not interfere with the audio signals.
The switch drivers feature a controlled switching speed
that minimizes noise generated by turn-on and turn-off
transients. The di/dt noise caused by the parasitic bond
wire and trace inductance is minimized by limiting the
turn-on/off speed of the charge pump. Additional high-
frequency noise attenuation can be achieved by
increasing the size of C2 (see the
Functional Diagrams).
Extra noise attenuation is not typically required.
Shutdown
The MAX9725’s low-power shutdown mode reduces
supply current to 0.6A. Driving
SHDN low disables the
amplifiers and charge pump. The driver’s output imped-
ance
is
typically
50k
Ω (MAX9725A), 37.5kΩ
(MAX9725B), 25k
Ω (MAX9725C), 100kΩ (MAX9725D),
or RF (MAX9725E) when in shutdown mode.
f
2R C
-3dB
L OUT
=
1
π
Figure 2. Low-Frequency Attenuation for Common DC-Blocking
Capacitor Values
LF ROLLOFF (16
Ω LOAD)
FREQUENCY (Hz)
ATTENUATION
(dB)
100
-30
-25
-20
-10
-3dB CORNER FOR
100
μF IS 100Hz
-15
-5
-3
0
-35
10
1k
33
μF
330
μF
220
μF
100
μF
Figure 3. Distortion Contributed By DC-Blocking Capacitors
ADDITIONAL THD+N DUE
TO DC-BLOCKING CAPACITORS
FREQUENCY (Hz)
THD+N
(%)
10k
1k
100
0.001
0.01
0.1
1
10
0.0001
10
100k
TANTALUM
ALUM/ELEC
1V, Low-Power, DirectDrive, Stereo Headphone
Amplifier with Shutdown
_______________________________________________________________________________________
9
相關PDF資料 |
PDF描述 |
|---|---|
| VI-B1T-MW-S | CONVERTER MOD DC/DC 6.5V 100W |
| VI-21R-MX-S | CONVERTER MOD DC/DC 7.5V 75W |
| MS27497T22A55P | CONN RCPT 55POS WALL MNT W/PINS |
| MAX9725DETC+T | IC AMP AUDIO .025W STER 12TQFN |
| MS3100A20-29S | CONN RCPT 17POS WALL MNT W/SCKT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX9725CEBC | 制造商:Maxim Integrated Products 功能描述:1V LOW-POWER DIRECTDRIVE STEREO - Rail/Tube |
| MAX9725CEBC+ | 制造商:Maxim Integrated Products 功能描述:AUD AMP HDPH 2CH STEREO 0.025W CLS-AB 12UCSP - Rail/Tube |
| MAX9725CEBC+T | 制造商:Maxim Integrated Products 功能描述:AUD AMP HDPH 2CH STEREO 0.025W CLS-AB 12UCSP - Tape and Reel |
| MAX9725CEBC+TG45 | 功能描述:音頻放大器 1V DirectDrive Headphone Amplifier RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| MAX9725CEBC-T | 制造商:Maxim Integrated Products 功能描述:1V, LOW-POWER, DIRECTDRIVE, STEREO HEADPHONE - Tape and Reel |
發布緊急采購，3分鐘左右您將得到回復。