![](http://datasheet.mmic.net.cn/330000/MB15F73UL_datasheet_16435541/MB15F73UL_3.png)
3
MB15F73UL
Dec. 2000
Edition 2.0
n
PIN DESCRIPTIONS
Pin No.
Pin
name
I/O
Descriptions
TSSOP
BCC
1
19
OSC
IN
I
The programmable reference divider input. TCXO should be connected
with a AC coupling capacitor.
2
20
GND
-
Ground for OSC input buffer and the shift registor circuit.
3
1
fin
IF
I
Prescaler input pin for the IF-PLL section.
Connection to an external VCO should be AC coupling.
4
2
Xfin
IF
I
Prescaler complimentary input for the IF-PLL section.
This pin should be grounded via a capacitor.
5
3
GND
IF
-
Ground for the IF-PLL section.
6
4
Vcc
IF
-
Power supply voltage input pin for the IF-PLL section(except for the
charge pump circuit), the shift register and the oscillator input buffer.
When power is OFF, latched data of IF-PLL is lost.
7
5
PS
IF
I
Power saving mode control for the IF-PLL section. This pin must be set
at ”L” Power-ON. (Open is prohibited.)
PS
IF
= ”H” ; Normal mode PS
IF
= ”L” ; Power saving mode
8
6
Vp
IF
-
Power supply voltage input pin for the IF-PLL charge pump.
9
7
Do
IF
O
Charge pump output for the IF-PLL section.
Phase characteristics of the phase detector can be reversed by FC-bit.
10
8
LD/fout
O
Lock detect signal output(LD)/ phase comparator monitoring outut
(fout). The output signal is selected by a LDS bit in a serial data.
LDS bit = "1" ; outputs fout signal LDS bit = "0" ; outputs LD sihnal
11
9
Do
RF
O
Charge pump output for the RF-PLL section.
Phase characteristics of the phase detector can be reversed by FC-bit.
12
10
Vp
RF
-
Power supply voltage input pin for the RF-PLL charge pump.
13
11
PS
RF
I
Power saving mode control for the RF-PLL section. This pin must be
set at ”L” Power-ON. (Open is prohibited.)
PS
RF
= ”H” ; Normal mode PS
RF
= ”L” ; Power saving mode
14
12
Vcc
RF
-
Power supply voltage input pin for the RF-PLL section(except for the
charge pump circuit).
15
13
GND
RF
-
Ground for the RF-PLL section.
16
14
Xfin
RF
I
Prescaler complimentary input for the RF-PLL section.
This pin should be grounded via a capacitor.
17
15
fin
RF
I
Prescaler input pin for the RF-PLL.
Connction to an external VCO should be AC coupling.
18
16
LE
I
Load enable signal input (with the schmitt trigger circuit.)
When LE is set "H", data in the shift register is transferred to the corre-
sponding latch according to the control bit in a serial data.
19
17
Data
I
Serial data input (with the schmitt trigger circuit.)
A data is transferred to the corresponding latch (IF-ref counter, IF-prog.
counter, RF-ref. counter, RF-prog. counter) according to the control bit
in a serial data.
20
18
Clock
I
Clock input for the 23-bit shift register (with the schmitt trigger circuit.)
One bit data is shifted into the shift register on a rising edge of the
clock.