- 您現在的位置：買賣IC網 > PDF目錄377879 > MB3789 (Fujitsu Limited) RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS PDF資料下載
參數資料
| 型號： | MB3789 |
| 廠商： | Fujitsu Limited |
| 元件分類： | 基準電壓源/電流源 |
| 英文描述： | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
| 中文描述： | 抗輻射高效，5安培開關穩壓器 |
| 文件頁數： | 5/28頁 |
| 文件大?。?/td> | 214K |
| 代理商： | MB3789 |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
5
MB3789
I
FUNCTIONAL DESCRIPTION
1.
Switching Regulator Functions
(1) Reference voltage generator
The reference voltage generator uses the voltage supplied from the power supply pin (pin 1) to generate a
temperature-compensated, reference voltage (about 2.50 V) as the reference supply voltage for the IC’s internal
circuitry.
The reference voltage can be output, up to 50
μ
A, to an external device through the V
REF
pin (pin 2).
This regulated reference voltage can be used as the reference voltage for the switching regulator and also
used for setting the dead time.
(2) Sawtooth waveform oscillator
With a timing capacitor and a timing resistor connected to the C
T
pin (pin 3), the sawtooth waveform oscillator
generates a sawtooth wave which remains stable even with supply voltage variations or temperature changes.
The sawtooth wave is input to the PWM comparator. The amplitude of oscillating waveform is 0.3 V to 0.9 V.
In addition, the oscillator can be used for external synchronization, where it generates a sawtooth waveform
synchronous to the input signal from the SYNC pin (pin 4).
(3) Error amplifiers
The error amplifiers detect the output voltage from the switching regulator and outputs the PWM control signal.
Since they support a wide range of in-phase input voltages from –0.2 V to “V
CC
– 1.8 V”, they can be set easily
from an external power supply.
An arbitrary loop gain can be set by connecting a feedback resistor and capacitor from the error amplifier output
pin to the inverting input pin, enabling stable phase compensation to the system.
The MB3789 can make a current-regulated DC/DC converter using the two internal error amplifiers respectively
for voltage control and current control.
(4) PWM comparator
The PWM comparator is a voltage comparator with one inverting input and three noninverting inputs, serving
as a voltage-pulse width converter for controlling the output duty depending on the input voltage.
The PWM comparator turns on the output transistor during the interval in which the sawtooth wave voltage
level is lower than the voltage levels at all of the error amplifier output pins, the SCP pin (pin 5), and at the
DTC pin (pin 12).
(5) Output circuit
The output circuit is a power MOSFET driven, output circuit in a totem-pole configuration. It can drive the gate
voltage up to near the supply voltage with a bootstrap capacitor connected between the OUT pin (pin 15) and
CB pin (pin 13). (See “
I
SETTING THE BOOTSTRAP CAPACITOR (C
BS
).”)
2.
Protection Functions
(1) Timer-latch short-circuit protection circuit
SCP comparator 1 detects the output voltage levels of error amplifiers 1 and 2. When the output voltage level
of either (or both) of the two error amplifiers reaches 1.25 V, the timer circuit is actuated to start charging the
external protection-enable capacitor connected to the SCP pin (pin 5).
If the error amplifier output is not restored to the normal voltage level before the capacitor voltage reaches
1.8 V, the latch circuit is actuated to turn off the output transistor while making the dead time 100%.
To reset the actuated protection circuit, turn the power supply on back. (See “
I
SETTING THE SOFT START/
SHORT-CIRCUIT DETECTION TIME.”)
相關PDF資料 |
PDF描述 |
|---|---|
| MB3789PFV | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
| MB3790PF | Battery Backup IC |
| MB3790 | DIODE SCHOTTKY SINGLE 25V 200mW 0.32V-vf 200mA-IFM 1mA-IF 2uA-IR SOT-23 3K/REEL |
| MB3790PFT | Battery Backup IC |
| MB3793-27A | Power Voltage Monitoring IC with Watchdog Timer |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MB3789PFV | 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:Switching Regulator Controller (Supporting External Synchronization) |
| MB3789PFV-G-BND(E1) | 制造商:Fujitsu 功能描述: |
| MB-379 | 制造商:Maxxtro 功能描述: |
| MB3790 | 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:Battery Backup IC |
| MB3790PF | 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:Battery Backup IC |
發布緊急采購，3分鐘左右您將得到回復。