- 您現在的位置：買賣IC網 > PDF目錄377880 > MB3793-45PNF (FUJITSU LTD) Power Voltage Monitoring IC with Watchdog Timer PDF資料下載
參數資料
| 型號： | MB3793-45PNF |
| 廠商： | FUJITSU LTD |
| 元件分類： | 電源管理 |
| 英文描述： | Power Voltage Monitoring IC with Watchdog Timer |
| 中文描述： | 1-CHANNEL POWER SUPPLY MANAGEMENT CKT, PDSO8 |
| 封裝： | 3.90 X 5.50 MM, 1.75 MM HEIGHT, 1.27 MM PITCH, PLASTIC, SOP-8 |
| 文件頁數： | 10/20頁 |
| 文件大?。?/td> | 192K |
| 代理商： | MB3793-45PNF |
10
MB3793
-42/30
5. Clock pulse input (Positive clock pulse)
I
OPERATION SEQUENCE
The operation sequence is explained by using Timing Chart 1.
The following item numbers correspond to the numbers in Timing Chart 1.
(1) When the power voltage (V
CC
) reaches about 0.8 V (V
CCL
), a reset signal is output.
(2) When V
CC
exceeds the rising-edge detection voltage (V
SH
), charging of power-on reset hold time setting capacitance (C
TP
) is started.
V
SH
is about 4.3 V in the MB3793-42 and 3. 07 V in the MB3793-30.
(3) When the voltage at the CTP pin setting the power-on reset hold time exceeds the threshold voltage (V
th
), resetting is canceled and
the voltage at the RESET pin changes to High level to start charging of the watchdog-timer monitoring time setting capacitance (C
TW
).
Vth is about 3.6 V in the MB3793-42 and 2.4 V in the MB3793-30.
The power-on reset hold time (t
PR
) can be calculated by the following equation.
t
PR
(ms)
≈
A x C
TP
(
μ
F)
Where, A is about 1300 in the MB3793-42 and 750 in the MB3793-30.
(4) When the voltage at the CTW pin setting the monitoring time reaches High level (V
H
), C
TW
switches to discharging from charging. V
H
is about 1.24 V (reference value) in both the MB3793-42 and MB3793-30.
(5) When clock pulses are input to the CK2 pin during C
TW
discharging after clock pulses are input to the CK1 pin—positive-edge trigger,
C
TW
switches to charging.
(6) If clock pulse input does not occur at either the CK1 or CK2 clock pins during the watchdog-timer monitoring time (t
WD
), the CTW voltage
falls below Low level (V
L
), a reset signal is output, and the voltage at the RESET pin changes to Low level. V
L
is about 0.24 V in both
the MB3793-42 and MB3793-30.
t
WD
can be calculated from the following equation.
t
WD
(ms)
≈
B x C
TW
(
μ
F) + C x C
TP
(
μ
F)
Where, B is about 1500 in the MB3793-42 and 1600 in the MB3793-30. C is about 3 in the MB3793-42 and 4 in the MB3793-30; it is
much smaller than B.
Hence, whenC
≤
10, the calculation can be simplified as follows:
t
WD
(ms)
≈
B x C
TW
(
μ
F)
CTW
V
L
V
H
CK1
CK2
b
The MB3793 watchdog timer monitors Clock 1 (CK1) and Clock 2 (CK2) pulses alternately. When a CK2 pulse
is detected after detecting a CK1 pulse, the monitoring time setting capacity (C
TW
) switches to charging from
discharging.
When two consecutive pulses occur on one side of this alternation before switching, the second pulse is ignored.
In the above figure, pulses aand bare ignored.
a
TP
C
相關PDF資料 |
PDF描述 |
|---|---|
| MB3793-45 | Power Voltage Monitoring IC with Watchdog Timer |
| MB3793-45PF | Power Voltage Monitoring IC with Watchdog Timer |
| MB3800 | Switching Regulator Controller(脈寬調制系統開關穩壓器控制器) |
| MB3802 | Power Management Switch(電源管理開關) |
| MB3807 | Power Management Switching IC (with flash memory power switching function) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MB3793-45PNF-G-JN-6(E1) | 制造商:Fujitsu 功能描述: |
| MB3793-45PNF-G-JN-6E1 | 功能描述:IC PWR VOLT MON WD TIMER 8SOL RoHS:是 類別:集成電路 (IC) >> PMIC - 監控器 系列:- 其它有關文件:STM6717 View All Specifications 標準包裝:1 系列:- 類型:多壓監控器 監視電壓數目:2 輸出:開路漏極或開路集電極 復位:低有效 復位超時:最小為 600 ms 電壓 - 閥值:1.11V，3.075V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SC-74A，SOT-753 供應商設備封裝:SOT-23-5 包裝:Digi-Reel® 產品目錄頁面:1194 (CN2011-ZH PDF) 其它名稱:497-7019-6 |
| MB3793-45PNF-G-JN-ER-6E1 | 功能描述:Supervisor CMOS Inverted 1 Channel 8-SOP 制造商:cypress semiconductor corp 系列:- 包裝:剪切帶（CT） 零件狀態:在售 類型:簡單復位/加電復位 受監控電壓數:1 輸出:CMOS 反轉式 復位:低有效 復位超時:最小為 80 ms 電壓 - 閾值:4.5V 工作溫度:-40°C ~ 85°C（TA） 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商器件封裝:8-SOP 標準包裝:1 |
| MB37-T | 制造商:DANAHER - TEKTRONIX 功能描述:T-TYPE THERMOCOUPLE MODULE |
| MB38 | 制造商:PANJIT 制造商全稱:Pan Jit International Inc. 功能描述:SURFACE MOUNT SCHOTTKY BARRIER RECTIFIER |
發布緊急采購，3分鐘左右您將得到回復。