- 您現在的位置：買賣IC網 > PDF目錄377880 > MB3836 (Fujitsu Limited) Li-Ion Battery Protection IC PDF資料下載
參數資料
| 型號： | MB3836 |
| 廠商： | Fujitsu Limited |
| 英文描述： | Li-Ion Battery Protection IC |
| 中文描述： | 鋰離子電池保護IC |
| 文件頁數： | 18/28頁 |
| 文件大小： | 256K |
| 代理商： | MB3836 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁當前第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
MB3836
18
3.
When no “H” level signal is input to the PDWN terminal after over-discharge detection
If any cell voltage becomes the over-discharge detection voltage (2.75 V Typ), the PF terminal (pin 19) outputs
a “L” level PF signal to the notebook PC after a PF output delay time (2 s Typ) managed by the capacitor (C
UVT
)
connected between the CUVT terminal (pin 12) and GND. At the same time, after a power-down delay time
(20 s Typ) managed by the capacitor (C
PDT
) connected between the CPDT terminal (pin 11) and GND, the DOUT
terminal (pin 3) goes “H” level to turn off the Pch MOS FET for external discharge control, thereby stopping
discharging the battery. The VS terminal (pin 5) goes “L” level at this time. As discharging is stopped, the OCV
terminal (pin 1) goes “L” level to completely turn off the bias source in the IC.
Over-discharge Detection/Power Fail Circuit
That is, an over-discharge state is detected when a cell voltage does not return to the over-discharge detection
voltage (2.75 V Typ) or more within the power-down delay time (20 s Typ), an over-discharge state is detected.
When the OCV terminal (pin 1) goes “H” level, the DOUT terminal (pin 3) goes “L” level to turn on the Pch MOS
FET for external discharge control and the VS terminal (pin 5) goes “H” level. If the cell voltage remains not
exceeding the over-discharge detection voltage (2.75 V Typ) at this time, the PF terminal (pin 19) outputs a “L”
level PF signal to the notebook PC again after a PF output delay time (2 s Typ) managed by the capacitor (C
UVT
)
connected between the CUVT terminal (pin 12) and GND. If the cell voltage reaches or exceeds the over-
discharge detection voltage (2.75 V Typ) within the power-down delay time (20 s Typ), however, the PF terminal
goes “H” level and an over-discharge state is not detected.
相關PDF資料 |
PDF描述 |
|---|---|
| MB3836PFV | Li-Ion Battery Protection IC |
| MB3841 | Power Management Switch IC |
| MB3841PF-G-BND | PERMASLEEVE WIRE MARKING SLEEVES |
| MB3842 | Power Management 2-ch Switch IC |
| MB3842PFV | Power Management 2-ch Switch IC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MB3836PFV | 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:Li-Ion Battery Protection IC |
| MB3841 | 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:Power Management Switch IC |
| MB3841PF-G-BND | 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:Power Management Switch IC |
| MB3841PF-G-BND-JNE1 | 制造商:Fujitsu 功能描述:8SOP p[}lWgXCb` Tube |
| MB3842 | 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:Power Management 2-ch Switch IC |
發布緊急采購，3分鐘左右您將得到回復。