- 您現在的位置：買賣IC網 > PDF目錄377913 > MB89997PF (FUJITSU LTD) CONV DC-DC 24V IN 5/3.3V OUT 40W PDF資料下載
參數資料
| 型號： | MB89997PF |
| 廠商： | FUJITSU LTD |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | CONV DC-DC 24V IN 5/3.3V OUT 40W |
| 中文描述： | 8-BIT, MROM, 4.2 MHz, MICROCONTROLLER, PDSO28 |
| 封裝： | PLASTIC, SOP-28 |
| 文件頁數： | 12/42頁 |
| 文件大?。?/td> | 551K |
| 代理商： | MB89997PF |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁當前第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁
12
MB89990 Series
I
HANDLING DEVICES
1. Preventing Latch
-
up
Latchup may occur on CMOS ICs if voltage higher than V
CC
or lower than V
SS
is applied to input or output pins
other than medium-to high-voltage pins or if higher than the voltage which shows on “ 1. Absolute Maximum
Ratings” in “
I
Electrical Characteristics” is applied between V
CC
to V
SS
.
When latchup occurs, power supply current increases rapidly and might thermally damage elements. When
using, take great care not to exceed the absolute maximum ratings.
2. Treatment of Unused Input Pins
Leaving unused input pins open could cause malfunctions. They should be connected to pull-up or pull-down
resistor.
3. Treatment of N.C. Pins
Be sure to leave (internally connected) N.C. pins open.
4. Power Supply Voltage Fluctuations
Although V
CC
power supply voltage is assured to operate within the rated range, a rapid fluctuation of the voltage
could cause malfunctions, even if it occurs within the rated range. Stabilizing voltage supplied to the IC is
therefore important. As stabilization guidelines, it is recommended to control power so that V
CC
ripple fluctuations
(P-P value) will be less than 10% of the standard V
CC
value at the commercial frequency (50 to 60 Hz) and the
transient fluctuation rate will be less than 0.1 V/ms at the time of a momentary fluctuation such as when power
is switched.
5. Precautions when Using an External Clock
When an external clock is used, oscillation stabilization time is required even for power-on reset (option selection)
and release from stop mode.
相關PDF資料 |
PDF描述 |
|---|---|
| MB89P135A | 8-Bit Proprietary Microcontroller(8位專用微控制器) |
| MB89P133A | 8-Bit Proprietary Microcontroller(8位專用微控制器) |
| MB89P601 | 8-Bit Proprietary Microcontroller(8位專用微控制器) |
| MB89601R | 8-Bit Proprietary Microcontroller(8位專用微控制器) |
| MB89603R | 8-Bit Proprietary Microcontroller(8位專用微控制器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MB89997P-SH | 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:8-bit Proprietary Microcontroller |
| MB8999X | 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:8-bit Proprietary Microcontroller |
| MB899E | 制造商:IBase Technology (USA) Inc. 功能描述:ITX, SOCKET 478 FOR YONAH (DUAL CORE), 945GME, VGA, ICH LANX - Bulk |
| MB899FE | 制造商:IBase Technology (USA) Inc. 功能描述:ITX, SOCKET 478 FOR YONAH (DUAL CORE), 945GME, VGA, ICH LAN - Bulk |
| MB899F-MV-R | 制造商:IBase Technology (USA) Inc. 功能描述:ITX, SOCKET 478 FOR YONAH (DUAL CORE), 945GM, VGA, MARVELL 8 - Bulk |
發布緊急采購，3分鐘左右您將得到回復。