參數資料
型號: MB96F338USAPMC-GSE2
廠商: FUJITSU LTD
元件分類: 微控制器/微處理器
英文描述: 16-BIT, FLASH, 56 MHz, MICROCONTROLLER, PQFP144
封裝: 20 X 20 MM, 1.70 MM HEIGHT, 0.50 MM PITCH, PLASTIC, LQFP-144
文件頁數: 94/124頁
文件大?。?/td> 2581K
代理商: MB96F338USAPMC-GSE2
MB96330 Series
DS07-13805-1E
71
2. Opposite phase external clock
When using an opposite phase external clock, X1 (X1A) must be supplied with a clock signal which has the
opposite phase to the X0 (X0A) pins.
4.
Unused sub clock signal
If the pins X0A and X1A are not connected to an oscillator, a pull-down resistor must be connected on the X0A
pin and the X1A pin must be left open.
5.
Notes on PLL clock mode operation
If the PLL clock mode is selected and no external oscillator is operating or no external clock is supplied, the
microcontroller attempts to work with the free oscillating PLL. Performance of this operation, however, cannot
be guaranteed.
6.
Power supply pins (VCC/VSS)
It is required that all VCC-level as well as all VSS-level power supply pins are at the same potential. If there is more
than one VCC or VSS level, the device may operate incorrectly or be damaged even within the guaranteed operating
range.
VCC and VSS must be connected to the device from the power supply with lowest possible impedance.
As a measure against power supply noise, it is required to connect a bypass capacitor of about 0.1
μF between
VCC and VSS as close as possible to VCC and VSS pins.
7.
Crystal oscillator and ceramic resonator circuit
Noise at X0, X1 pins or X0A, X1A pins might cause abnormal operation. It is required to provide bypass capacitors
with shortest possible distance to X0, X1 pins and X0A, X1A pins, crystal oscillator (or ceramic resonator) and
ground lines, and, to the utmost effort, that the lines of oscillation circuit do not cross the lines of other circuits.
It is highly recommended to provide a printed circuit board art work surrounding X0, X1 pins and X0A, X1A pins
with a ground area for stabilizing the operation.
It is highly recommended to evaluate the quartz/MCU or resonator/MCU system at the quartz or resonator
manufacturer, especially when using low-Q resonators at higher frequencies.
8.
Turn on sequence of power supply to A/D converter and analog inputs
It is required to turn the A/D converter power supply (AVCC, AVRH, AVRL) and analog inputs (ANn) on after
turning the digital power supply (VCC) on.
It is also required to turn the digital power off after turning the A/D converter supply and analog inputs off. In this
case, the voltage must not exceed AVRH or AVCC (turning the analog and digital power supplies simultaneously
on or off is acceptable).
9.
Pin handling when not using the A/D converter
It is required to connect the unused pins of the A/D converter as AVCC = VCC
, AVSS = AVRH = AVRL = VSS.
10. Notes on Power-on
To prevent malfunction of the internal voltage regulator, supply voltage profile while turning the power supply on
should be slower than 50
μs from 0.2 V to 2.7 V.
X0
X1
相關PDF資料
PDF描述
MB96F348CWBXXXPMC-GSE2 16-BIT, FLASH, 56 MHz, RISC MICROCONTROLLER, PQFP100
MB96F348AWAXXXPQC-GSE2 16-BIT, FLASH, 56 MHz, RISC MICROCONTROLLER, PQFP100
MB96F348CSBXXXPQC-GSE2 16-BIT, FLASH, 56 MHz, RISC MICROCONTROLLER, PQFP100
MB96F347RSAXXXPMC-GSE2 16-BIT, FLASH, 56 MHz, RISC MICROCONTROLLER, PQFP100
MB96F348TSBXXXPMC-GSE2 16-BIT, FLASH, 56 MHz, RISC MICROCONTROLLER, PQFP100
相關代理商/技術參數
參數描述
MB96F338USAPMC-GS-N2K5E2 功能描述:F2MC-16FX F2MC-16FX MB96330 Microcontroller IC 16-Bit 48MHz 544KB (544K x 8) FLASH 144-LQFP (20x20) 制造商:cypress semiconductor corp 系列:F2MC-16FX MB96330 包裝:托盤 零件狀態:在售 核心處理器:F2MC-16FX 核心尺寸:16-位 速度:48MHz 連接性:CAN,EBI/EMI,I2C,LIN,SCI,UART/USART,USB 外設:DMA,LVD,LVR,POR,PWM,WDT I/O 數:120 程序存儲容量:544KB(544K x 8) 程序存儲器類型:閃存 EEPROM 容量:- RAM 容量:32K x 8 電壓 - 電源(Vcc/Vdd):3 V ~ 5.5 V 數據轉換器:A/D 36x10b 振蕩器類型:內部 工作溫度:-40°C ~ 105°C(TA) 封裝/外殼:144-LQFP 供應商器件封裝:144-LQFP(20x20) 標準包裝:60
MB96F338UWAPMC-GSE2 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:16-bit Proprietary Microcontroller
MB96F338YSAPMC-GSE2 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:16-bit Proprietary Microcontroller
MB96F338YWAPMC-GSE2 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:16-bit Proprietary Microcontroller
MB96F345 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:16-bit Proprietary Microcontroller