參數資料
型號: MC145483DWR2
廠商: Freescale Semiconductor
文件頁數: 18/24頁
文件大小: 0K
描述: IC CODEC-FILTER PCM 3V 20-SOIC
標準包裝: 1
類型: PCM 編解碼器/濾波器
數據接口: PCM 音頻接口
分辨率(位): 13 b
ADC / DAC 數量: 1 / 1
三角積分調變:
電壓 - 電源,數字: 2.7 V ~ 5.25 V
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 20-SOIC(0.295",7.50mm 寬)
供應商設備封裝: 20-SOIC W
包裝: 剪切帶 (CT)
其它名稱: MC145483DWR2CT
MC145483
FREQ
RO –
PI
PO –
PO +
VDD
VSS
VAG
TG
TI –
TI +
+
– 1
1
+
SHARED
DAC
0.886 V
REF
ADC
TRANSMIT
SHIFT
REGISTER
SEQUENCE
AND
CONTROL
DR
FSR
BCLKR
PDI
MCLK
BCLKT
FST
DT
RECEIVE
SHIFT
REGISTER
HB
VAG Ref
VDD
VSS
R*
Figure 1. MC145483 13–Bit Linear PCM Codec–Filter Block Diagram
DEVICE DESCRIPTION
A PCM Codec–Filter is used for digitizing and reconstruct-
ing the human voice. These devices are used primarily for
the telephone network to facilitate voice switching and trans-
mission. Once the voice is digitized, it may be switched by
digital switching methods or transmitted long distance (T1,
microwave, satellites, etc.) without degradation. The name
codec is an acronym from ‘‘COder’’ for the analog–to–digital
converter (ADC) used to digitize voice, and ‘‘DECoder’’ for
the digital–to–analog converter (DAC) used for reconstruct-
ing voice. A codec is a single device that does both the ADC
and DAC conversions.
To digitize intelligible voice requires a signal–to–distortion
ratio of about 30 dB over a dynamic range of about 40 dB.
This may be accomplished with a linear 13–bit ADC and
DAC. The MC145483 satisfies these requirements and may
be used as the analog front–end for voice coders using DSP
technology to further compress the digital data stream.
In a sampling environment, Nyquist theory says that to
properly sample a continuous signal, it must be sampled at a
frequency higher than twice the signal’s highest frequency
component. Voice contains spectral energy above 3 kHz, but
its absence is not detrimental to intelligibility. To reduce the
digital data rate, which is proportional to the sampling rate, a
sample rate of 8 kHz was adopted, consistent with a band-
width of 3 kHz. This sampling requires a low–pass filter to
limit the high frequency energy above 3 kHz from distorting
the in–band signal. The telephone line is also subject to
50/60 Hz power line coupling, which must be attenuated
from the signal by a high–pass filter before the analog–to–
digital converter. The MC145483 includes a high–pass filter
for compatibility with existing telephone applications, but it
may be removed from the analog input signal path by the
high–pass bypass pin.
The digital–to–analog conversion process reconstructs a
staircase version of the desired in–band signal, which has
spectral images of the in–band signal modulated about the
sample frequency and its harmonics. These spectral images
are called aliasing components, which need to be attenuated
to obtain the desired signal. The low–pass filter used to at-
tenuate these aliasing components is typically called a re-
construction or smoothing filter.
The MC145483 PCM Codec–Filter has the codec, both
presampling and reconstruction filters, and a precision volt-
age reference on–chip.
F
re
e
sc
a
le
S
e
m
ic
o
n
d
u
c
to
r,
I
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
n
c
..
.
相關PDF資料
PDF描述
MC145481SDR2 IC CODEC-FILTER PCM 3V 20-SSOP
MC145483DW IC CODEC-FILTER PCM 3V 20-SOIC
VI-24F-CV-S CONVERTER MOD DC/DC 72V 150W
VE-22V-IX-F3 CONVERTER MOD DC/DC 5.8V 75W
VE-22V-IX-F1 CONVERTER MOD DC/DC 5.8V 75W
相關代理商/技術參數
參數描述
MC145483EG 功能描述:IC CODEC-FILTER PCM 3V 20-SOIC RoHS:是 類別:集成電路 (IC) >> 接口 - 編解碼器 系列:- 標準包裝:2,500 系列:- 類型:立體聲音頻 數據接口:串行 分辨率(位):18 b ADC / DAC 數量:2 / 2 三角積分調變:是 S/N 比,標準 ADC / DAC (db):81.5 / 88 動態范圍,標準 ADC / DAC (db):82 / 87.5 電壓 - 電源,模擬:2.6 V ~ 3.3 V 電壓 - 電源,數字:1.7 V ~ 3.3 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-WFQFN 裸露焊盤 供應商設備封裝:48-TQFN-EP(7x7) 包裝:帶卷 (TR)
MC145483EGR2 功能描述:IC CODEC-FILTER PCM 3V 20-SOIC RoHS:是 類別:集成電路 (IC) >> 接口 - 編解碼器 系列:- 標準包裝:2,500 系列:- 類型:立體聲音頻 數據接口:串行 分辨率(位):18 b ADC / DAC 數量:2 / 2 三角積分調變:是 S/N 比,標準 ADC / DAC (db):81.5 / 88 動態范圍,標準 ADC / DAC (db):82 / 87.5 電壓 - 電源,模擬:2.6 V ~ 3.3 V 電壓 - 電源,數字:1.7 V ~ 3.3 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-WFQFN 裸露焊盤 供應商設備封裝:48-TQFN-EP(7x7) 包裝:帶卷 (TR)
MC145483EJ 功能描述:IC CODEC-FI 13BIT 3V 20-TSSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 編解碼器 系列:- 標準包裝:2,500 系列:- 類型:立體聲音頻 數據接口:串行 分辨率(位):18 b ADC / DAC 數量:2 / 2 三角積分調變:是 S/N 比,標準 ADC / DAC (db):81.5 / 88 動態范圍,標準 ADC / DAC (db):82 / 87.5 電壓 - 電源,模擬:2.6 V ~ 3.3 V 電壓 - 電源,數字:1.7 V ~ 3.3 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-WFQFN 裸露焊盤 供應商設備封裝:48-TQFN-EP(7x7) 包裝:帶卷 (TR)
MC145483EJR2 功能描述:IC CODEC-FI 13BIT 3V 20-TSSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 編解碼器 系列:- 標準包裝:2,500 系列:- 類型:立體聲音頻 數據接口:串行 分辨率(位):18 b ADC / DAC 數量:2 / 2 三角積分調變:是 S/N 比,標準 ADC / DAC (db):81.5 / 88 動態范圍,標準 ADC / DAC (db):82 / 87.5 電壓 - 電源,模擬:2.6 V ~ 3.3 V 電壓 - 電源,數字:1.7 V ~ 3.3 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-WFQFN 裸露焊盤 供應商設備封裝:48-TQFN-EP(7x7) 包裝:帶卷 (TR)
MC145483EN 功能描述:IC CODEC-FI 13BIT 3V 20-SSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 編解碼器 系列:- 標準包裝:2,500 系列:- 類型:立體聲音頻 數據接口:串行 分辨率(位):18 b ADC / DAC 數量:2 / 2 三角積分調變:是 S/N 比,標準 ADC / DAC (db):81.5 / 88 動態范圍,標準 ADC / DAC (db):82 / 87.5 電壓 - 電源,模擬:2.6 V ~ 3.3 V 電壓 - 電源,數字:1.7 V ~ 3.3 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-WFQFN 裸露焊盤 供應商設備封裝:48-TQFN-EP(7x7) 包裝:帶卷 (TR)