- 您現在的位置：買賣IC網 > PDF目錄5860 > MC33077DG (ON Semiconductor)IC OPAMP DUAL LOW NOISE 8-SOIC PDF資料下載
參數資料
| 型號： | MC33077DG |
| 廠商： | ON Semiconductor |
| 文件頁數： | 4/14頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC OPAMP DUAL LOW NOISE 8-SOIC |
| 標準包裝： | 98 |
| 放大器類型： | 通用 |
| 電路數： | 2 |
| 轉換速率： | 11 V/µs |
| 增益帶寬積： | 37MHz |
| 電流 - 輸入偏壓： | 280nA |
| 電壓 - 輸入偏移： | 130µV |
| 電流 - 電源： | 3.5mA |
| 電流 - 輸出 / 通道： | 33mA |
| 電壓 - 電源，單路/雙路(±)： | 5 V ~ 36 V，±2.5 V ~ 18 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-SOIC（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 8-SOICN |
| 包裝： | 管件 |
| 其它名稱： | MC33077DGOS |
MC33077
http://onsemi.com
12
amplifier’s input capacitance, creating a pole near the closed
loop
corner
frequency,
lead
capacitor
compensation
techniques (lead capacitor in parallel with the feedback
resistor) can be employed to improve stability. The feedback
resistor and lead capacitor RC time constant should be larger
than that of the uncompensated input pole frequency. Having
a high resistance connected to the noninverting input of the
amplifier can create a like instability problem. Compensation
for this condition can be accomplished by adding a lead
capacitor in parallel with the noninverting input resistor of
such a value as to make the RC time constant larger than the
RC time constant of the uncompensated input resistor acting
in conjunction with the amplifiers input capacitance.
For optimum frequency performance and stability, careful
component placement and printed circuit board layout
should be exercised. For example, long unshielded input or
output leads may result in unwanted input output coupling.
In order to reduce the input capacitance, the body of resistors
connected to the input pins should be physically close to the
input pins. This not only minimizes the input pole creation
for optimum frequency response, but also minimizes
extraneous signal “pickup” at this node. Power supplies
should be decoupled with adequate capacitance as close as
possible to the device supply pin.
In addition to amplifier stability considerations, input
source resistance values should be low to take full advantage
of the low noise characteristics of the amplifier. Thermal
noise (Johnson Noise) of a resistor is generated by
thermallycharged carriers randomly moving within the
resistor creating a voltage. The RMS thermal noise voltage
in a resistor can be calculated from:
Enr =
4k TR
× BW
/
where:
k = Boltzmann’s Constant (1.38
× 1023 joules/k)
T = Kelvin temperature
R = Resistance in ohms
BW = Upper and lower frequency limit in Hertz.
By way of reference, a 1.0 k
W resistor at 25°C will
produce a 4.0 nV/ Hz
√
of RMS noise voltage. If this resistor
is connected to the input of the amplifier, the noise voltage
will be gainedup in accordance to the amplifier’s gain
configuration. For this reason, the selection of input source
resistance for low noise circuit applications warrants serious
consideration. The total noise of the amplifier, as referred to
its inputs, is typically only 4.4 nV/ Hz
√
at 1.0 kHz.
The output of any one amplifier is current limited and thus
protected from a direct short to ground, However, under such
conditions, it is important not to allow the amplifier to exceed
the maximum junction temperature rating. Typically for
±15 V supplies, any one output can be shorted continuously
to ground without exceeding the temperature rating.
Figure 37. Voltage Noise Test Circuit
(0.1 Hz to 10 Hzpp)
Note: All capacitors are nonpolarized.
+
0.1
mF
10
W
100 k
W
2.0 k
W
4.7
mF
Voltage Gain = 50,000
Scope
× 1
Rin = 1.0 MW
1/2
MC33077
+
D.U.T.
100 k
W
0.1
mF
2.2
mF
22
mF
24.3 k
W
4.3 k
W
110 k
W
相關PDF資料 |
PDF描述 |
|---|---|
| 951112-7722-AR | CONN HEADER 12POS 2MM R/A T/H |
| TPL-CN | FUSE TELPOWER 300A 170VDC |
| 77313-801-22LF | CONN HEADER .100 DUAL STR 22POS |
| NE5534DG | IC OPAMP SGL LOW NOISE 8-SOIC |
| 25CJ | FUSE 25A 600V CERAM BODY CSA |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC33077DR2 | 功能描述:運算放大器 - 運放 Dual 11V/us Low RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
| MC33077DR2G | 功能描述:運算放大器 - 運放 Dual 11V/us Low Noise Ind. Temp RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
| MC33077DR2G-CUT TAPE | 制造商:ON 功能描述:MC Series 11 V/us 36 V SMT Low Noise Dual Operational Amplifier - SOIC-8 |
| MC33077P | 功能描述:運算放大器 - 運放 Dual 11V/us Low RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
| MC33077PG | 功能描述:運算放大器 - 運放 Dual 11V/us Low Noise Ind. Temp RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。