- 您現在的位置：買賣IC網 > PDF目錄359132 > MC33689 (飛思卡爾半導體(中國)有限公司) System Basis Chip with LIN transceiver(帶LIN收發器的系統基片) PDF資料下載
參數資料
| 型號： | MC33689 |
| 廠商： | 飛思卡爾半導體(中國)有限公司 |
| 英文描述： | System Basis Chip with LIN transceiver(帶LIN收發器的系統基片) |
| 中文描述： | 系統基礎芯片（帶林收發器的系統基片的LIN收發器） |
| 文件頁數： | 14/18頁 |
| 文件大小： | 389K |
| 代理商： | MC33689 |
MC33689
14
MC33689
Sleep and stop mode enter:
To safely enter sleep or stop mode and to ensure that these modes are not entered by noise issue during SPI transmission, a
dedicated sequence combining bit controlling the LIN bus and the device mode must be send twice.
Enter sleep mode: first and second SPI commands (with bit D6=1, D7=1, D5 =0 or 1, D1=0 and D0=0) 11x0_0000 must be
sent.
Enter stop mode: first and second SPI commands (with bit D6=1, D7=1, D5 =0 or 1, D1=0 and D0=1) 11x0_0001 must be
sent.
Sleep or stop mode is entered after the second SPI command. D5 bit must be set accordingly.
5.9
Window watchdog.
The window watchdog is configurable using external resistor at Wdc pin. The W/D is cleared through mode1 and mode 2 bit is
SPI register. If Wdc pin is left open a fixed watchdog period is selected (typ 150ms). If no watchdog function is required or to
disable the watchdog, the Wdc pin must be connected to gnd. The watchdog period is calculated by the following formula:
Twd = 0.991 * R +0.648
(with R in kohms and Twd in ms).
Watchdog clear:
The watchdog is cleared by SPI write command with following mode1 and mode2 bits.
Normal
Vdd: ON
N/A
- High.
- Active low if Vdd
under voltage occurs
or if W/D fail (if W/D
enable)
Window WD if
enabled.
ON or
OFF
Transmit
and
Receive
Active
Stop
Vdd ON,
limited current
capability
LIN and
state
change on
Lx inputs
- Normally high.
- Active low if Vdd
under voltage occurs
Disable
OFF
Recessive
state with
Wake
capability
Not
active
Sleep
Vdd OFF, (Set
to 5V after
wake up to
enter Normal
request)
LIN and
state
change on
Lx inputs
- Low
- Go to high after wake
up and Vdd within
spec
Disable
OFF
Recessive
state with
Wake
capability
Not
active
Mode 2
Mode 1
Mode
0
0
Sleep mode (note 1)
0
1
Stop mode
1
0
Normal mode + W/D clear (note 2)
1
1
Normal mode
Device
Mode
Voltage
Regulator
Wake up
capabilities
Reset output
Watchdog
function
HS1
HS2
HS3
LIN
interface
Opera-
tional
amplifier
Table 5-1.
window closed
no watchdog clear allowed
window open
for watchdog clear
Twd * 50%
Twd * 50%
Watchdog period
Twd
Window watchdog operation
F
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
n
.
相關PDF資料 |
PDF描述 |
|---|---|
| MC33701 | 1.5 A Switch-Mode Power Supply with Linear Regulator(1.5 A開關方式電源，帶線性穩壓器) |
| MC33702 | 3.0 A Switch-Mode Power Supply with Linear Regulator(3.0 A開關方式電源，帶線性穩壓器) |
| MC33742 | System Basis Chip (SBC) with Enhanced High-Speed CAN Transceiver(帶增強型高速CAN收發器的系統基片) |
| MC33790 | Two-Channel Distributed System Interface (DSI) Physical Interface Device(2通道分布式系統接口（DSI）物理接口) |
| MC33793 | Distributed System Interface (DSI) Sensor Interface(分布式系統接口（DSI）傳感器接口) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC33689DDWB | 功能描述:CAN 接口集成電路 SBCLIN RoHS:否 制造商:Texas Instruments 類型:Transceivers 工作電源電壓:5 V 電源電流: 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:SOIC-8 封裝:Tube |
| MC33689DDWBR2 | 功能描述:CAN 接口集成電路 SBCLIN RoHS:否 制造商:Texas Instruments 類型:Transceivers 工作電源電壓:5 V 電源電流: 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:SOIC-8 封裝:Tube |
| MC33689DPEW | 制造商:Freescale Semiconductor 功能描述:SYSTEM BASIS CHIP W/LIN 制造商:Freescale Semiconductor 功能描述:SYSTEM BASIS CHIP W/LIN - Bulk 制造商:Freescale Semiconductor 功能描述:IC SYSTEM BASIS W/LIN 32SOIC |
| MC33689DPEWR2 | 制造商:Freescale Semiconductor 功能描述:SYSTEM BASIS CHIP W/LIN 制造商:Freescale Semiconductor 功能描述:SYSTEM BASIS CHIP W/LIN - Tape and Reel 制造商:Freescale Semiconductor 功能描述:IC SYSTEM BASIS W/LIN 32SOIC |
| MC33689DWB | 功能描述:CAN 接口集成電路 SBCLIN RoHS:否 制造商:Texas Instruments 類型:Transceivers 工作電源電壓:5 V 電源電流: 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:SOIC-8 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。