參數資料
型號: MC68HC05C9AMB
廠商: FREESCALE SEMICONDUCTOR INC
元件分類: 微控制器/微處理器
英文描述: 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PDIP42
封裝: SHRINK, PLASTIC, DIP-42
文件頁數: 79/124頁
文件大小: 774K
代理商: MC68HC05C9AMB
Serial Communications Interface (SCI)
MC68HC05C9A Advance Information Data Sheet, Rev. 5.1
58
Freescale Semiconductor
9.9 Start Bit Detection
When the input (idle) line is detected low, it is tested for three more sample times (referred to as the start
edge verification samples in Figure 9-4). If at least two of these three verification samples detect a logic
0, a valid start bit has been detected; otherwise, the line is assumed to be idle. A noise flag is set if all
three verification samples do not detect a logic 0. Thus, a valid start bit could be assumed with a set noise
flag present.
If a framing error has occurred without detection of a break (10 0s for 8-bit format or 11 0s for 9-bit format),
the circuit continues to operate as if there actually was a stop bit, and the start edge will be placed
artificially. The last bit received in the data shift register is inverted to a logic 1, and the three logic 1 start
qualifiers (shown in Figure 9-4) are forced into the sample shift register during the interval when detection
of a start bit is anticipated (see Figure 9-6); therefore, the start bit will be accepted no sooner than it is
anticipated.
Figure 9-6. SCI Artificial Start Following a Frame Error
If the receiver detects that a break (RDRF = 1, FE = 1, receiver data register = $003B) produced the
framing error, the start bit will not be artificially induced and the receiver must actually detect a logic 1
before the start bit can be recognized (see Figure 9-7).
Figure 9-7. SCI Start Bit Following a Break
DATA
EXPECTED STOP
DATA SAMPLES
ARTIFICIAL EDGE
START BIT
DATA
RDI
DATA
EXPECTED STOP
DATA SAMPLES
START EDGE
START BIT
DATA
RDI
a) Case 1: Receive Line Low During Artificial Edge
b) Case 2: Receive Line High During Expected Start Edge
EXPECTED STOP
DATA SAMPLES
DETECTED AS VALID START EDGE
START BIT
RDI
BREAK
START
QUALIFIERS
START EDGE
VERIFICATION
SAMPLES
相關PDF資料
PDF描述
MC68HC05C9AMFN 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PQCC44
MC68HC05C9AMP 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PDIP40
MC68HC05C9ECP 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PDIP40
MC68HC05CC2B 8-BIT, MROM, 4.2 MHz, MICROCONTROLLER, PDIP42
MC68HC05CJ4FB 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PQFP44
相關代理商/技術參數
參數描述
MC68HC05C9AMFB 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Microcontrollers
MC68HC05C9AMFN 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Microcontrollers
MC68HC05C9AMP 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Microcontrollers
MC68HC05C9AP 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Microcontrollers
MC68HC05C9CP 制造商:Motorola Inc 功能描述:IC UP HCMOS 68HC05C9CP DIP40 0