- 您現在的位置：買賣IC網 > PDF目錄45223 > MC68HC05V7CB (MOTOROLA INC) 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PDIP56 PDF資料下載
參數資料
| 型號： | MC68HC05V7CB |
| 廠商： | MOTOROLA INC |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PDIP56 |
| 封裝： | SDIP-56 |
| 文件頁數： | 123/170頁 |
| 文件大小： | 589K |
| 代理商： | MC68HC05V7CB |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁當前第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁
MOTOROLA
SECTION 6: RESETS
Page 42
MC68HC05V7 Specification Rev. 1.0
6.2.3
COMPUTER OPERATING PROPERLY RESET (COPR)
The MCU contains a watchdog timer that automatically times out if not reset (cleared) within
a specific time by a program reset sequence. If the COP watchdog timer is allowed to time-
out, an internal reset is generated to reset the MCU. Regardless of an internal or external
RESET, the MCU comes out of a COP reset according to the standard rules of mode
selection.
The COP reset function is enabled or disabled by a mask option and is verified during
production testing.
The COP Watchdog reset will activate the internal pulldown device connected to the
RESET pin.
6.2.3.1
RESETTING THE COP
Preventing a COP reset is done by writing a “0” to the COPF bit. This action will reset the
counter and begin the time-out period again. The COPF bit is bit 0 of address $3FF0. A
read of address $3FF0 will return user data programmed at that location.
6.2.3.2
COP DURING WAIT MODE
The COP will continue to operate normally during WAIT mode. The software should pull the
device out of WAIT mode periodically and reset the COP by writing to the COPF bit to
prevent a COP reset.
6.2.3.3
COP DURING STOP MODE
When the STOP enable mask option is selected, STOP mode disables the oscillator circuit
and thereby turns the clock off for the entire device. The COP counter will be reset when
STOP mode is entered. If a reset is used to exit STOP mode, the COP counter will be held
in reset during the 4064 cycles of start up delay. If any operable interrupt is used to exit
STOP mode, the COP counter will not be reset during the 4064 cycle start up delay and
will have that many cycles already counted when control is returned to the program.
6.2.3.4
COP WATCHDOG TIMER CONSIDERATIONS
The COP Watchdog Timer is active in all modes of operation if enabled by a mask option.
If the COP Watchdog Timer is selected by a mask option, any execution of the STOP
instruction (either intentional or inadvertent due to the CPU being disturbed) will cause the
oscillator to halt and prevent the COP Watchdog Timer from timing out. Therefore, it is
recommended that the STOP instruction should be disabled if the COP Watchdog Timer
is enabled.
If the COP Watchdog Timer is selected by a mask option, the COP will reset the MCU when
it times out. Therefore, it is recommended that the COP Watchdog should be disabled for
a system that must have intentional uses of the WAIT Mode for periods longer than the
COP time-out period.
The recommended interactions and considerations for the COP Watchdog Timer, STOP
instruction, and WAIT instruction are summarized in Table 6-1.
相關PDF資料 |
PDF描述 |
|---|---|
| MC68HC05V7CFU | 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PQFP64 |
| MC68HC05X16FU | 8-BIT, MROM, MICROCONTROLLER, PQFP64 |
| MC68HC705X32FU | 8-BIT, OTPROM, MICROCONTROLLER, PQFP64 |
| MC68HC05X16MFU | 8-BIT, MROM, MICROCONTROLLER, PQFP64 |
| MC68HC05X32FU | 8-BIT, MROM, MICROCONTROLLER, PQFP64 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC68HC05X16 | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:High-density complementary metal oxide semiconductor HCMOS) microcontroller unit |
| MC68HC05X32 | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:High-density complementary metal oxide semiconductor HCMOS) microcontroller unit |
| MC68HC05X4 | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:HCMOS Microcontroller Unit |
| MC68HC05X4CDW | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:HCMOS Microcontroller Unit |
| MC68HC05X4DW | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:HCMOS Microcontroller Unit |
發布緊急采購，3分鐘左右您將得到回復。