Interrupts
MC68HC908GP32 MC68HC08GP32 Data Sheet, Rev. 7
Freescale Semiconductor
51
4.3.2.2 Break Interrupt
The break module causes the CPU to execute an SWI instruction at a software-programmable break
point.
4.3.2.3 IRQ Pin
A logic 0 on the IRQ pin latches an external interrupt request.
4.3.2.4 CGM
The CGM can generate a CPU interrupt request every time the phase-locked loop circuit (PLL) enters or
leaves the locked state. When the LOCK bit changes state, the PLL flag (PLLF) is set. The PLL interrupt
enable bit (PLLIE) enables PLLF CPU interrupt requests. LOCK is in the PLL bandwidth control register.
PLLF is in the PLL control register.
4.3.2.5 TIM1
TIM1 CPU interrupt sources:
TIM1 overflow flag (TOF) — The TOF bit is set when the TIM1 counter reaches the modulo value
programmed in the TIM1 counter modulo registers. The TIM1 overflow interrupt enable bit, TOIE,
enables TIM1 overflow CPU interrupt requests. TOF and TOIE are in the TIM1 status and control
register.
TIM1 channel flags (CH1F–CH0F) — The CHxF bit is set when an input capture or output compare
occurs on channel x. The channel x interrupt enable bit, CHxIE, enables channel x TIM1 CPU
interrupt requests. CHxF and CHxIE are in the TIM1 channel x status and control register.
4.3.2.6 TIM2
TIM2 CPU interrupt sources:
TIM2 overflow flag (TOF) — The TOF bit is set when the TIM2 counter reaches the modulo value
programmed in the TIM2 counter modulo registers. The TIM2 overflow interrupt enable bit, TOIE,
enables TIM2 overflow CPU interrupt requests. TOF and TOIE are in the TIM2 status and control
register.
TIM2 channel flags (CH1F–CH0F) — The CHxF bit is set when an input capture or output compare
occurs on channel x. The channel x interrupt enable bit, CHxIE, enables channel x TIM2 CPU
interrupt requests. CHxF and CHxIE are in the TIM2 channel x status and control register.
4.3.2.7 SPI
SPI CPU interrupt sources:
SPI receiver full bit (SPRF) — The SPRF bit is set every time a byte transfers from the shift register
to the receive data register. The SPI receiver interrupt enable bit, SPRIE, enables SPRF CPU
interrupt requests. SPRF is in the SPI status and control register and SPRIE is in the SPI control
register.
SPI transmitter empty (SPTE) — The SPTE bit is set every time a byte transfers from the transmit
data register to the shift register. The SPI transmit interrupt enable bit, SPTIE, enables SPTE CPU
interrupt requests. SPTE is in the SPI status and control register and SPTIE is in the SPI control
register.