參數資料
型號： MC68HC705J1ACP
廠商： MOTOROLA INC
元件分類： 微控制器/微處理器
英文描述： Microcontrollers
中文描述： 8-BIT, OTPROM, 2.1 MHz, MICROCONTROLLER, PDIP20
封裝： PLASTIC, DIP-20
文件頁數： 16/108頁
文件大?。?/td> 718K
代理商： MC68HC705J1ACP
Introduction
MC68HC705KJ1 MC68HRC705KJ1 MC68HLC705KJ1 Data Sheet, Rev. 4.1
16
Freescale Semiconductor
1.4.1 V
DD
and V
SS
V
DD
and V
SS
are the power supply and ground pins. The MCU operates from a single power supply.
Very fast signal transitions occur on the MCU pins, placing high, short-duration current demands on the
power supply. To prevent noise problems, take special care, as
Figure 1-3
shows, by placing the bypass
capacitors as close as possible to the MCU. C2 is an optional bulk current bypass capacitor for use in
applications that require the port pins to source high current levels.
Figure 1-3. Bypassing Layout Recommendation
1.4.2 OSC1 and OSC2
The OSC1 and OSC2 pins are the connections for the on-chip oscillator. The oscillator can be driven by
any of the following:
1.
Standard crystal (See
Figure 1-4
and
Figure 1-5
.)
2.
Ceramic resonator (See
Figure 1-6
and
Figure 1-7
.)
3.
Resistor/capacitor (RC) oscillator (Refer to
Appendix A MC68HRC705KJ1
.)
4.
External clock signal as shown in (See
Figure 1-8
.)
5.
Low speed (32 kHz) crystal connections (Refer to
Appendix B MC68HLC705KJ1
.)
The frequency, f
OSC
, of the oscillator or external clock source is divided by two to produce the internal
operating frequency, f
OP
.
1.4.2.1 Crystal Oscillator
Figure 1-4
and
Figure 1-5
show a typical crystal oscillator circuit for an AT-cut, parallel resonant crystal.
Follow the crystal supplier’s recommendations, as the crystal parameters determine the external
component values required to provide reliable startup and maximum stability. The load capacitance
values used in the oscillator circuit design should include all stray layout capacitances.
To minimize output distortion, mount the crystal and capacitors as close as possible to the pins. An
internal startup resistor of approximately 2 M
is provided between OSC1 and OSC2 for the crystal
oscillator as a programmable mask option.
NOTE
Use an AT-cut crystal and not an AT-strip crystal because the MCU can
overdrive an AT-strip crystal.
C1
C2
MCU
C1
0.1
μ
F
C2
V+
+
V
DD
V
SS
V
DD
V
SS
相關PDF資料
PDF描述
MC68HC705J1ACDW Microcontrollers
MC68HC705V12CFN The Motorola microcontroller
MC68HC705V12 The Motorola microcontroller
MC68HC705JJ7 HCMOS Microcontroller Unit
MC68HC705SP7 HCMOS Microcontroller Unit
相關代理商/技術參數
參數描述
MC68HC705J1ACPE 功能描述:8位微控制器 -MCU HCO5 CORE+1.2K RAM + EPR RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
MC68HC705J2CDW 制造商:Motorola Inc 功能描述: 制造商:Motorola Inc 功能描述:MicroController, 8-Bit, 20 Pin, Plastic, SOP
MC68HC705J2DW 制造商:Motorola Inc 功能描述:
MC68HC705J5ACP 制造商:Motorola Inc 功能描述: 制造商:MOTOROLA 功能描述:
MC68HC705JB4DW 制造商:Motorola Inc 功能描述: 制造商:MOTOROLA 功能描述:
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*