參數資料
型號: MC68HC705T16B
廠商: MOTOROLA INC
元件分類: 微控制器/微處理器
英文描述: 8-BIT, OTPROM, 2.1 MHz, MICROCONTROLLER, PDIP56
封裝: PLASTIC, SDIP-56
文件頁數: 70/128頁
文件大小: 734K
代理商: MC68HC705T16B
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁當前第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁
MOTOROLA
5-4
MC68HC05T16
TIMERS
5
bits are readable and writable and are not affected by the timer hardware or reset. If the compare
function is not needed, the Output Compare registers can be used as storage locations.
The contents of the Output Compare registers are continually compared with the contents of the
free-running counter and, if a match is found, the corresponding output compare ag (OC0F or
OC1F) in the Timer Status register is set. The Output Compare registers’ value should be changed
after each successful comparison to establish a new elapsed time-out. An interrupt can also
accompany a successful output compare provided the corresponding interrupt enable bit (OC0IE
or OC1IE) is set. (The free-running counter is updated every four internal bus clock cycles.)
After a processor write cycle to the Output Compare registers containing the MSB ($14 or $16),
the output compare function is inhibited until the LSB ($15 or $17) is also written. The user must
write both bytes (locations) if the MSB is written rst. A write made only to the LSB ($15 or $17)
will not inhibit the compare function. The processor can write to either byte of an Output Compare
register without affecting the other byte. The minimum time required to update the Output
Compare registers is a function of the program rather than the internal hardware. Because the
output compare ags and Output Compare registers are not dened at power on, and not affected
by reset, care must be taken when initializing output compare functions with software. The
following procedure is recommended:
1) write to Output Compare register 0 and/or 1 High-byte to inhibit further
compares;
2) read the Timer Status register to initialize clearing of OC0F or/and OC1F;
3) write to Output Compare register 0 or/and 1 Low-byte to enable the output
compare function.
5.1.3
Input Capture Registers
Input Capture Register
High byte - $12, Low byte - $13
‘Input Capture’ is a technique whereby an external signal (connected to TCAP pin) is used to
trigger a read of the free-running counter. In this way it is possible to relate the timing of an external
signal to the internal counter value, and hence to elapsed time.
The two 8-bit registers that make up the 16-bit input capture register, are read-only, and are used
to latch the value of the free-running counter after the corresponding input capture edge detector
senses a valid transition. The level transition that triggers the counter transfer is dened by the
corresponding input edge bit (IEDG). Reset does not affect the contents of the input capture
register.
The result obtained from an input capture will be one greater than the value of the free-running
counter on the rising edge of the internal bus clock preceding the external transition. This delay is
required for internal synchronization. Resolution is one count of the free-running counter, which is
four internal bus clock cycles.
The free-running counter contents are transferred to the input capture register on each valid signal
transition whether the input capture ag (ICF) is set or clear. The input capture register always
TPG
44
相關PDF資料
PDF描述
MC68HC05T16B 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PDIP56
MC68HC705V8CFU 8-BIT, OTPROM, 2.1 MHz, MICROCONTROLLER, PQFP64
MC68HC705V8B 8-BIT, OTPROM, 2.1 MHz, MICROCONTROLLER, PDIP56
MC68HC705V8FN 8-BIT, OTPROM, 2.1 MHz, MICROCONTROLLER, PQCC68
MC68HC705V8CFN 8-BIT, OTPROM, 2.1 MHz, MICROCONTROLLER, PQCC68
相關代理商/技術參數
參數描述
MC68HC706P6ACDW 制造商:Motorola Inc 功能描述:
MC68HC708MP16CFU 制造商:MAJOR 功能描述:
MC68HC711D3CFBE2 制造商:Freescale Semiconductor 功能描述:
MC68HC711D3CFN2 功能描述:IC MCU 2MHZ 4K OTP 44-PLCC RoHS:否 類別:集成電路 (IC) >> 嵌入式 - 微控制器, 系列:HC11 其它有關文件:STM32F101T8 View All Specifications 特色產品:STM32 32-bit Cortex MCUs 標準包裝:490 系列:STM32 F1 核心處理器:ARM? Cortex?-M3 芯體尺寸:32-位 速度:36MHz 連通性:I²C,IrDA,LIN,SPI,UART/USART 外圍設備:DMA,PDR,POR,PVD,PWM,溫度傳感器,WDT 輸入/輸出數:26 程序存儲器容量:64KB(64K x 8) 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:10K x 8 電壓 - 電源 (Vcc/Vdd):2 V ~ 3.6 V 數據轉換器:A/D 10x12b 振蕩器型:內部 工作溫度:-40°C ~ 85°C 封裝/外殼:36-VFQFN,36-VFQFPN 包裝:托盤 配用:497-10030-ND - STARTER KIT FOR STM32497-8853-ND - BOARD DEMO STM32 UNIV USB-UUSCIKSDKSTM32-PL-ND - KIT IAR KICKSTART STM32 CORTEXM3497-8512-ND - KIT STARTER FOR STM32F10XE MCU497-8505-ND - KIT STARTER FOR STM32F10XE MCU497-8304-ND - KIT STM32 MOTOR DRIVER BLDC497-6438-ND - BOARD EVALUTION FOR STM32 512K497-6289-ND - KIT PERFORMANCE STICK FOR STM32MCBSTM32UME-ND - BOARD EVAL MCBSTM32 + ULINK-MEMCBSTM32U-ND - BOARD EVAL MCBSTM32 + ULINK2更多... 其它名稱:497-9032STM32F101T8U6-ND
MC68HC711D3CFNE2 功能描述:8位微控制器 -MCU 8B OTP 192RAM 2 MHZ RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT