- 您現在的位置：買賣IC網 > PDF目錄201871 > MC68HC912BL16VFU8 (FREESCALE SEMICONDUCTOR INC) 16-BIT, FLASH, 8 MHz, MICROCONTROLLER, PQFP64 PDF資料下載
參數資料
| 型號： | MC68HC912BL16VFU8 |
| 廠商： | FREESCALE SEMICONDUCTOR INC |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 16-BIT, FLASH, 8 MHz, MICROCONTROLLER, PQFP64 |
| 封裝： | QFP-64 |
| 文件頁數： | 20/128頁 |
| 文件大?。?/td> | 3326K |
| 代理商： | MC68HC912BL16VFU8 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁當前第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁
MC68HC912BL16
116
MC68HC912BL16TS/D
on BKGD to the start of the bit time as perceived by the target MCU. The host initiates the bit time but
the target MC68HC912BL16 finishes it. Since the target wants the host to receive a logic zero, it drives
the BKGD pin low for 13 E-clock cycles, then briefly drives it high to speed up the rising edge. The host
samples the bit level about ten cycles after starting the bit time.
15.2.2 Enabling BDM Firmware Commands
BDM is available in all operating modes, but must be made active before firmware commands can be
executed. BDM is enabled by setting the ENBDM bit in the BDM STATUS register via the single wire
interface (using a hardware command; WRITE_BD_BYTE at $FF01). BDM must then be activated to
map BDM registers and ROM to addresses $FF00 to $FFFF and to put the MCU in active background
mode.
After the firmware is enabled, BDM can be activated by the hardware BACKGROUND command, by
the BDM tagging mechanism, or by the CPU BGND instruction. An attempt to activate BDM before firm-
ware has been enabled causes the MCU to resume normal instruction execution after a brief delay.
BDM becomes active at the next instruction boundary following execution of the BDM BACKGROUND
command, but tags activate BDM before a tagged instruction is executed.
In special single-chip mode, background operation is enabled and active immediately out of reset. This
active case replaces the M68HC11 boot function, and allows programming a system with blank mem-
ory.
While BDM is active, a set of BDM control registers are mapped to addresses $FF00 to $FF06. The
BDM control logic uses these registers which can be read anytime by BDM logic, not user programs.
Refer to 15.2.4 BDM Registers for detailed descriptions.
Some on-chip peripherals have a BDM control bit which allows suspending the peripheral function dur-
ing BDM. For example, if the timer control is enabled, the timer counter is stopped while in BDM. Once
normal program flow is continued, the timer counter is re-enabled to simulate real-time operations.
15.2.3 BDM Commands
All BDM command opcodes are eight bits long, and can be followed by an address and/or data, as in-
dicated by the instruction. These commands do not require the CPU to be in active BDM mode for ex-
ecution.
The host controller must wait 150 cycles for a non-intrusive BDM command to execute before another
command can be sent. This delay includes 128 cycles for the maximum delay for a dead cycle. For data
read commands, the host must insert this delay between sending the address and attempting to read
the data.
BDM logic retains control of the internal buses until a read or write is completed. If an operation can be
completed in a single cycle, it does not intrude on normal CPU operation. However, if an operation re-
quires multiple cycles, CPU clocks are frozen until the operation is complete.
There are two types of BDM commands: hardware and firmware. Hardware commands allow target
system memory to be read or written. Target system memory includes all memory that is accessible by
the CPU12 including on-chip RAM, EEPROM, on-chip I/O and control registers, and external memory
connected to the target HC12 MCU. Hardware commands are implemented in hardware logic and do
not require the HC12 MCU to be in BDM mode for execution. The control logic watches the CPU12 bus-
es to find a free bus cycle to execute the command so that the background access does not disturb the
running application programs. If a free cycle is not found within 128 E-clock cycles, the CPU12 is mo-
mentarily frozen so the control logic can steal a cycle. Refer to Table 38 for commands implemented in
BDM control logic.
F
re
e
sc
a
le
S
e
m
ic
o
n
d
u
c
to
r,
I
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
n
c
..
.
相關PDF資料 |
PDF描述 |
|---|---|
| MK74CG117AFT | 90 MHz, OTHER CLOCK GENERATOR, PDSO48 |
| MC68HC08AS32ACFU | 8-BIT, MROM, 8.4 MHz, MICROCONTROLLER, PQFP64 |
| MC68HRC98JL3ECFA | 8-BIT, FLASH, 4 MHz, MICROCONTROLLER, PQFP48 |
| MC68HRC98JL3EMDW | 8-BIT, FLASH, 8 MHz, MICROCONTROLLER, PDSO28 |
| MC68HC05C9AFN | 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PQCC44 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC68HC916P1CAA16 | 功能描述:16位微控制器 - MCU 16B MCU 32K FLASH RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT |
| MC68HC916P1CFU16 | 制造商:Rochester Electronics LLC 功能描述:16BIT W/32KB FLASH EEPRO - Bulk |
| MC68HC916P1VAA16 | 功能描述:IC MCU 32K FLASH 16MHZ 80-QFP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:HC16 標準包裝:1 系列:AVR® ATmega 核心處理器:AVR 芯體尺寸:8-位 速度:16MHz 連通性:I²C，SPI，UART/USART 外圍設備:欠壓檢測/復位，POR，PWM，WDT 輸入/輸出數:32 程序存儲器容量:32KB（16K x 16） 程序存儲器類型:閃存 EEPROM 大小:1K x 8 RAM 容量:2K x 8 電壓 - 電源 (Vcc/Vdd):2.7 V ~ 5.5 V 數據轉換器:A/D 8x10b 振蕩器型:內部 工作溫度:-40°C ~ 125°C 封裝/外殼:44-TQFP 包裝:剪切帶 (CT) 其它名稱:ATMEGA324P-B15AZCT |
| MC68HC916P3CFU16 | 制造商:Rochester Electronics LLC 功能描述:16BIT MCU FOR GENERAL - Bulk |
| MC68HC98LJ12CFU | 制造商:Rochester Electronics LLC 功能描述: 制造商:Freescale Semiconductor 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。