- 您現在的位置：買賣IC網 > PDF目錄1953 > MCP2003-E/MD (Microchip Technology)TXRX LIN BUS BIDIRECT 8DFN PDF資料下載
參數資料
| 型號： | MCP2003-E/MD |
| 廠商： | Microchip Technology |
| 文件頁數： | 2/6頁 |
| 文件大小： | 0K |
| 描述： | TXRX LIN BUS BIDIRECT 8DFN |
| 產品培訓模塊： | Microchip MCP20xx LIN Transceiver Overview |
| 標準包裝： | 91 |
| 類型： | 收發器 |
| 驅動器/接收器數： | 1/1 |
| 規程： | LIN |
| 電源電壓： | 6 V ~ 27 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-VDFN 裸露焊盤 |
| 供應商設備封裝： | 8-DFN（4x4） |
| 包裝： | 管件 |
| 產品目錄頁面： | 685 (CN2011-ZH PDF) |
TB3067
DS93067A-page 2
2011 Microchip Technology Inc.
To prevent an undesired wake-up scenario in a LIN bus
loss situation, the Power-Down mode has to be entered
via the Transmitter-Off mode observing specific timings
and the switching sequence outlined below (“Forced
Power-Down mode”).
The following state machine diagram shows the paths
to enter the MCP2003 Power-Down mode from
Operation mode or Transmitter-Off mode.
To enter Power-Down mode from Ready mode, the
MCP2003 has two different paths:
Passing through Transmitter-Off mode (TOFF),
which is shown in red in Figure 2
Passing through Operating mode, which is shown
in blue in Figure 2
FIGURE 2:
Entering MCP2003 Power-Down Mode From Operation Mode or Transmitter-Off Mode.
The Forced Power-Down mode sequence is used to
enter
Power-Down
mode
without
activating
the
transceiver to reduce the current consumption of the
transceiver. After the device is in Ready mode, this path
could be selected by holding TXD and CS in low state
for tTX2CS, and then setting CS to ‘1’ for tCSactive
before resetting CS to ‘0’. This results in all functionality
being disabled in the transceiver until CS goes high or
a falling edge on LIN bus had been detected.
POR
VREN OFF
RX OFF
TX OFF
Ready Mode
VREN ON
RX ON
TX OFF
VBAT > 5.5V
Falling Edge
on LIN or CS = 1
TOFF Mode
VREN ON
RX ON
TX OFF
Power-Down
Mode
VREN OFF
RX OFF
TX OFF
CS = 1 and TXD = 1
and No Fault
Fault
(Thermal or Timer)
CS = 0
Operation
Mode
VREN ON
RX ON
TX ON
CS = 1 and TXD = 0*
Note: * TXD = 0 before raising CS to ‘1’.
相關PDF資料 |
PDF描述 |
|---|---|
| MCP201T-I/SN | IC LIN TXRX ON-BOARD VREG 8SOIC |
| MCP2021A-330E/MD | IC TXRX LIN 3.3V LDO 8-DFN |
| MCP2022PT-500E/ST | IC TXRX LIN ON-BOARD VREG 14TSSO |
| MCP2022T-330E/ST | IC LIN TXRX ON-BD VREG 14TSSOP |
| MCP2036T-I/MG | INTEGRATED CIRCUITS LINEAR - 82 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MCP2003T-E/MD | 功能描述:LIN 收發器 Stand Alone LIN Transceiver RoHS:否 制造商:NXP Semiconductors 工作電源電壓: 電源電流: 最大工作溫度: 封裝 / 箱體:SO-8 |
| MCP2003T-E/P | 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:LIN J2602 Transceiver |
| MCP2003T-E/SN | 功能描述:LIN 收發器 Stand Alone LIN Transceiver RoHS:否 制造商:NXP Semiconductors 工作電源電壓: 電源電流: 最大工作溫度: 封裝 / 箱體:SO-8 |
| MCP2004 | 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:LIN J2602 Transceiver |
| MCP2004A | 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:LIN J2602 Transceiver |
發布緊急采購，3分鐘左右您將得到回復。