- 您現在的位置：買賣IC網 > PDF目錄10601 > MCP2004-E/P (Microchip Technology)IC LIN BUS BIDIRECT 8PDIP PDF資料下載
參數資料
| 型號： | MCP2004-E/P |
| 廠商： | Microchip Technology |
| 文件頁數： | 29/34頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC LIN BUS BIDIRECT 8PDIP |
| 產品培訓模塊： | Microchip MCP20xx LIN Transceiver Overview |
| 標準包裝： | 60 |
| 類型： | 收發器 |
| 驅動器/接收器數： | 1/1 |
| 規程： | LIN |
| 電源電壓： | 6 V ~ 27 V |
| 安裝類型： | 通孔 |
| 封裝/外殼： | 8-DIP（0.300"，7.62mm） |
| 供應商設備封裝： | 8-PDIP |
| 包裝： | 管件 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁當前第29頁第30頁第31頁第32頁第33頁第34頁
MCP2003/4/3A/4A
DS22230D-page 4
2010-2011 Microchip Technology Inc.
1.3
Modes of Operation
For an overview of all operational modes, refer to
1.3.1
POWER-DOWN MODE
In Power-Down mode, everything is off except the
wake-up section. This is the lowest power mode. The
receiver is off, thus its output is open-drain.
On CS going to a high level or a falling edge on WAKE
(MCP2003/MCP2003A only), the device will enter
Ready Mode as soon as internal voltage stabilizes.
Refer to the AC Spec table. In addition, LIN bus activity
will change the device from power-down mode to ready
mode; MCP2003/4 wakes up on a falling edge of LIN
bus and MCP2003/4A on a rising edge, following a low
level lasting at least 20 S of time. Refer to Figure 1-2
– Figure 1-5 about remote wake up. If CS is held high
as the device transitions from Power-Down to Ready
mode, the device will transition to either Operation or
Transmitter Off mode, depending on TXD input, as
soon as internal voltages stabilize.
1.3.2
READY MODE
Upon entering the Ready mode, VREN is enabled and
the receiver detect circuit is powered up. The transmit-
ter remains disabled and the device is ready to receive
data but not to transmit.
Upon VBB supply pin power-on, the device will remain
in Ready mode as long as CS is low. When CS transi-
tions high, the device will either enter Operation mode,
if TXD pin is held high, or the device will enter Trans-
mitter Off mode, if TXD pin is held low.
1.3.3
OPERATION MODE
In this mode, all internal modules are operational.
The device will go into the Power-Down mode on the
falling edge of CS. For the MCP2003/4 device, a
specific process should be followed to put all nodes into
Power-down mode. Refer to Section 1.6 “Enter
Power-Down Mode” and Figure 1-6. The device will
enter Transmitter Off mode in the event of a Fault
condition. These include: thermal overload, bus
contention and TXD timer expiration.
The
MCP2004/2004A
device
can
also
enter
Transmitter Off mode if the FAULT/TXE pin is pulled
low. The VBB-LBUS pull-up resistor is connected only
in Operation mode.
1.3.4
TRANSMITTER OFF MODE
Transmitter Off mode is reached whenever the
transmitter is disabled either due to a Fault condition or
pulling the nFAULT/TXE pin low on the MCP2004/
2004A. The fault conditions include: thermal overload,
bus contention or TXD timer expiration.
The device will go into Power-Down mode on the falling
edge of CS, or return to Operation mode if all faults are
resolved and the FAULT/TXE pin on the MCP2004/
2004A is high.
FIGURE 1-2:
OPERATIONAL MODES STATE DIAGRAM – MCP2003
POR
VREN OFF
RX OFF
TX OFF
VBAT>5.5V
Ready
VREN ON
RX ON
TX OFF
TOFF
Mode
VREN ON
RX ON
TX OFF
Operation
Mode
VREN ON
RX ON
TX ON
POWER
DOWN
VREN OFF
RX OFF
TX OFF
CS=1 & TXD=0
CS=1 & TXD=1
CS=1 & TXD=1 & No Fault
Fault (thermal or timer)
CS=0
Falling edge on LIN
or CS=1
or falling edge on WAKE PIN
CS=0
相關PDF資料 |
PDF描述 |
|---|---|
| PX0747/P | CONN JAM NUT 4POS W/PINS |
| HR25-9R-20SA | CONN RECEPT 20POS FEMALE SLD PCB |
| HR25-9R-16PA | CONN RECEPT 16POS MALE SLD PCB |
| VI-220-IW-F4 | CONVERTER MOD DC/DC 5V 100W |
| ADV7523ABCBZ-P-RL | IC TX HDMI/DVI LP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MCP2004T-E/MD | 功能描述:LIN 收發器 Stand Alone LIN Transceiver RoHS:否 制造商:NXP Semiconductors 工作電源電壓: 電源電流: 最大工作溫度: 封裝 / 箱體:SO-8 |
| MCP2004T-E/P | 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:LIN J2602 Transceiver |
| MCP2004T-E/SN | 功能描述:LIN 收發器 Stand Alone LIN Transceiver RoHS:否 制造商:NXP Semiconductors 工作電源電壓: 電源電流: 最大工作溫度: 封裝 / 箱體:SO-8 |
| MCP200JR-100K | 功能描述:RES 100K OHM 2W 5% MELF RoHS:是 類別:電阻器 >> 芯片電阻 - 表面安裝 系列:MCP 產品目錄繪圖:RHM Series Top RHM Series Side 標準包裝:5,000 系列:MCR10 電阻（歐姆）:27 功率（瓦特）:0.125W，1/8W 復合體:厚膜 特點:- 溫度系數:±200ppm/°C 容差:±5% 封裝/外殼:0805（2012 公制） 尺寸/尺寸:0.079" L x 0.049" W（2.00mm x 1.25mm） 高度:0.026"（0.65mm） 端子數:2 包裝:帶卷 (TR) 產品目錄頁面:2225 (CN2011-ZH PDF) 其它名稱:RHM27ATR |
| MCP200JR-100R | 功能描述:RES 100 OHM 2W 5% MELF RoHS:是 類別:電阻器 >> 芯片電阻 - 表面安裝 系列:MCP 標準包裝:4,000 系列:RCL - 汽車 電阻（歐姆）:30.9 功率（瓦特）:1W 復合體:厚膜 特點:- 溫度系數:±100ppm/°C 容差:±1% 封裝/外殼:1812（4632 公制）寬（長端），1218（3246 公制） 尺寸/尺寸:0.126" L x 0.181" W（3.20mm x 4.60mm） 高度:0.024"（0.60mm） 端子數:2 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。
