- 您現在的位置：買賣IC網 > PDF目錄383588 > MCP201 (Microchip Technology Inc.) LIN Transceiver with Voltage Regulator(帶有集成Vreg的線收發器) PDF資料下載
參數資料
| 型號： | MCP201 |
| 廠商： | Microchip Technology Inc. |
| 英文描述： | LIN Transceiver with Voltage Regulator(帶有集成Vreg的線收發器) |
| 中文描述： | LIN收發器和穩壓器（帶有集成Vreg的線收發器） |
| 文件頁數： | 4/27頁 |
| 文件大?。?/td> | 417K |
| 代理商： | MCP201 |
第1頁第2頁第3頁當前第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁
DS21730C-page 4
Preliminary
2003 Microchip Technology Inc.
1.3
Modes of Operation
For an overview of all operational modes, please refer
to Table 1-2.
1.3.1
POWER-DOWN MODE
In the Power-Down mode, the transmitter and the volt-
age regulator are both off. Only the receiver section
and the CS/WAKE pin wake-up circuits are in
operation. This is the lowest power mode.
If any bus activity (e.g., a BREAK character) should
occur during Power-Down mode, the device will imme-
diately enable the voltage regulator. Once the output
has stabilized, enter the Ready mode.
The part will enter the operation mode if the CS/WAKE
pin should become active-high (‘1’).
1.3.2
READY MODE AND READY1 MODE
There are two states for the Ready mode.The only dif-
ference between these states is the transition during
start-up of the regulator, depending on the signal CS/
WAKE. The state Ready1 mode ensures that the tran-
sition from the Ready-to-Operation mode (once an
active edge of CS/WAKE) occurs.
Upon entering the Ready mode, the voltage regulator
is powered up. If a microcontroller is being driven by
the voltage regulator output, it will go through a power-
on reset and initialization sequence. All other circuits,
other than the transmitter, are fully operational. The LIN
pin is held in the recessive state.
The device will stay in the Ready mode until the
CS/WAKE pin goes high (‘1’). After CS/WAKE is active,
the transmitter is enabled and the part enters the
Operation mode.
The part may only enter the Power-Down mode after
going through an Operation mode step.
On power-on of the V
BAT
supply pin, the component is
in either in Ready or Ready1 mode, waiting for a
CS/WAKE rising edge.
1.3.3
OPERATION MODE
In this mode, all internal modules are operational.
The MCP201 will go into the Power-down mode on the
falling edge of CS/WAKE.
FIGURE 1-1:
OPERATIONAL MODES
STATE DIAGRAMS
TABLE 1-2:
State
POR
OVERVIEW OF OPERATIONAL MODES
Transmitter
Voltage Regulator
OFF
Note:
While the MCP201 is in shutdown, TXD
should not be activaly driven high.
Operation
Mode
Power-Down
Mode
Ready
Mode
Bus Activity
CS/WAKE = true
CS/WAKE = true
POR
CS/WAKE = false
Ready1
Mode
CS/WAKE = true
CS/WAKE = false
C
Start
FLT
FLT
Operation
Comments
OFF
Read CS/WAKE, if LOW then
READY, if HIGH READY1
mode
If CS/WAKE rising edge, then
Operation mode
If CS/WAKE falling edge,
then READY mode
If CS/WAKE falling edge,
then Power down
On LIN bus falling, go to
READY mode. On CS/WAKE
rising edge, go to Operational
mode
Sample FAULT/SLPS and
select slope
READY
OFF
ON
Bus Off state
READY1
OFF
ON
Bus Off state
OPERATION
ON
ON
Normal Operation mode
POWER-
DOWN
OFF
OFF
Low Power mode
相關PDF資料 |
PDF描述 |
|---|---|
| MCP2120 | low-cost, high-performance, fully-static infrared encoder/decoder.(帶有硬件/軟件波特率選擇的UART到IR編譯碼器) |
| MCP2140 | IrDA Standard Protocol Stack Controller With Fixed 9600 Baud Communication Rate(固定波特率,低成本,IrDA標準協議編譯碼器) |
| MCP2150 | DEVELOPER’S KIT USER’S GUIDE |
| MCP2155 | IrDA Standard Protocol Stack Controller Supporting DCE Applications(提供IrDA協議來處理PLUS位的編碼/譯碼功能,這是為了在一個低引腳的計數設備上實現數據傳輸功能(DCE)而提供的) |
| MCP23016 | 16-Bit I2C I/O Expander(16位I/O口擴展芯片) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MCP201-E | 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:LIN Transceiver with Voltage Regulator |
| MCP201-E/P | 功能描述:LIN 收發器 W/ On Board Vreg RoHS:否 制造商:NXP Semiconductors 工作電源電壓: 電源電流: 最大工作溫度: 封裝 / 箱體:SO-8 |
| MCP201-E/SN | 功能描述:LIN 收發器 W/ On Board Vreg RoHS:否 制造商:NXP Semiconductors 工作電源電壓: 電源電流: 最大工作溫度: 封裝 / 箱體:SO-8 |
| MCP201-EMF | 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:LIN Transceiver with Voltage Regulator |
| MCP201-EP | 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:LIN Transceiver with Voltage Regulator |
發布緊急采購，3分鐘左右您將得到回復。