- 您現在的位置：買賣IC網 > PDF目錄11599 > MCP2140-I/SO (Microchip Technology)IC IRDA CONTROLLR DTE/DCE 18SOIC PDF資料下載
參數資料
| 型號： | MCP2140-I/SO |
| 廠商： | Microchip Technology |
| 文件頁數： | 4/58頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC IRDA CONTROLLR DTE/DCE 18SOIC |
| 產品培訓模塊： | IrDA® Standard Protocol |
| 標準包裝： | 42 |
| 控制器類型： | IRDA 標準協議棧控制器 |
| 接口： | UART |
| 電源電壓： | 3 V ~ 5.5 V |
| 電流 - 電源： | 2.2mA |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 18-SOIC（0.295"，7.50mm 寬） |
| 供應商設備封裝： | 18-SOIC |
| 包裝： | 管件 |
| 產品目錄頁面： | 685 (CN2011-ZH PDF) |
| 配用： | MCP2140DM-TMPSNS-ND - BOARD DEMO FOR MCP2140 |
第1頁第2頁第3頁當前第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁
MCP2140
DS21790A-page 12
Preliminary
2003 Microchip Technology Inc.
2.5.2
DECODER (DEMODULATION)
The modulated signal (data) from the IR transceiver
module (on RXIR pin) needs to be demodulated to
form the received data (on RX pin). Once demodula-
tion of the data byte occurs, the data that is received is
transmitted by the MCP2140 UART (on the RX pin).
Figure 2-6 shows the decoding of the modulated
signal.
Each bit time is comprised of 16-bit clocks. If the value
to be received is a logic-low, the RXIR pin will be a low
level for the first 3-bit clock cycles, or a minimum of
1.6 s. The remaining 13-bit clock cycles (or difference
up to the 16-bit clock time) will be high. If the value to
be received is a logic-high, the RXIR pin will be a high
level for the entire 16-bit clock cycles. The level on the
RX pin will be in the appropriate state for the entire 16
clock cycles.
2.6
IR Port Baud Rate
The baud rate for the MCP2140 IR port (the TXIR and
RXIR pins) is fixed at the default rate of 9600 baud. The
Primary device will be informed of this parameter dur-
ing NDM. The Host UART baud rate and the IR port
baud rate are the same.
FIGURE 2-6:
DECODING
Note:
The signal on the RX pin does not actually
line up in time with the bit value that was
received on the RXIR pin, as shown in
Figure 2-6. The RXIR bit value is shown to
represent the value to be transmitted on
the RX pin.
BITCLK
RX
RXIR Bit Value
01
0
1
≥ 1.6 s (up to 3 CLK)
≥ 13 CLK
16 CLK
Start Bit
Data bit 0
Data bit 1
Data bit 2
Data bit ...
(CLK)
RXPD
RXPDREF
相關PDF資料 |
PDF描述 |
|---|---|
| ENC28J60T-I/SO | IC ETHERNET CTRLR W/SPI 28-SOIC |
| ENC28J60T-I/SS | IC ETHERNET CTLR SPI 28SSOP |
| GRM21BF51C225ZA01K | CAP CER 2.2UF 16V Y5V 0805 |
| GRM21BF51A225ZA01K | CAP CER 2.2UF 10V Y5V 0805 |
| MCP2140A-I/SS | IC IRDA CONTROLLR DTE/DCE 20SSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MCP2140-ISS | 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:IrDA㈢ Standard Protocol Stack Controller With Fixed 9600 Baud Communication Rate |
| MCP2140T-I/SO | 功能描述:網絡控制器與處理器 IC 9600bd fixd spd IrDA RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
| MCP2140T-I/SS | 功能描述:網絡控制器與處理器 IC 9600bd fixd spd IrDA RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
| MCP2140T-IP | 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:IrDA㈢ Standard Protocol Stack Controller With Fixed 9600 Baud Communication Rate |
| MCP2140T-ISO | 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:IrDA㈢ Standard Protocol Stack Controller With Fixed 9600 Baud Communication Rate |
發布緊急采購，3分鐘左右您將得到回復。