- 您現在的位置：買賣IC網 > PDF目錄10481 > MCP3008T-I/SL (Microchip Technology)IC ADC 10BIT 2.7V 8CH SPI 16SOIC PDF資料下載
參數資料
| 型號： | MCP3008T-I/SL |
| 廠商： | Microchip Technology |
| 文件頁數： | 15/40頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ADC 10BIT 2.7V 8CH SPI 16SOIC |
| 標準包裝： | 2,600 |
| 位數： | 10 |
| 采樣率（每秒）： | 200k |
| 數據接口： | 串行，SPI? |
| 轉換器數目： | 1 |
| 電壓電源： | 單電源 |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-SOIC（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 16-SOIC |
| 包裝： | 帶卷 (TR) |
| 輸入數目和類型： | 8 個單端，單極；4 個偽差分，單極 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁當前第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁
MCP3004/3008
DS21295D-page 22
2008 Microchip Technology Inc.
FIGURE 6-2:
SPI Communication with the MCP3004/3008 using 8-bit segments (Mode 1,1: SCLK idles high).
6.2
Maintaining Minimum Clock Speed
When the MCP3004/3008 initiates the sample period,
charge is stored on the sample capacitor. When the
sample period is complete, the device converts one bit
for each clock that is received. It is important for the
user to note that a slow clock rate will allow charge to
bleed off the sample capacitor while the conversion is
taking place. At 85°C (worst case condition), the part
will maintain proper charge on the sample capacitor for
at least 1.2 ms after the sample period has ended. This
means that the time between the end of the sample
period and the time that all 10 data bits have been
clocked out must not exceed 1.2 ms (effective clock
frequency of 10 kHz). Failure to meet this criterion may
introduce linearity errors into the conversion outside
the rated specifications. It should be noted that during
the entire conversion cycle, the A/D converter does not
require a constant clock speed or duty cycle, as long as
all timing specifications are met.
6.3
Buffering/Filtering the Analog
Inputs
If the signal source for the A/D converter is not a low-
impedance source, it will have to be buffered or
inaccurate conversion results may occur (see Figure 4-
2). It is also recommended that a filter be used to
eliminate any signals that may be aliased back in to the
conversion results, as is illustrated in Figure 6-3, where
an op amp is used to drive, filter and gain the analog
input of the MCP3004/3008. This amplifier provides a
low-impedance source for the converter input, plus a
low-pass filter, which eliminates unwanted high-
frequency noise.
Low-pass (anti-aliasing) filters can be designed using
Microchip’s free interactive FilterLab software.
FilterLab will calculate capacitor and resistors values,
as well as determine the number of poles that are
required for the application. For more information on fil-
tering signals, see AN699, “Anti-Aliasing Analog Filters
for Data Acquisition Systems”
.
FIGURE 6-3:
The MCP601 Operational
Amplifier is used to implement a second order
anti-aliasing filter for the signal being converted
by the MCP3004.
12
3
4
5
6
7
8
9
10 11 12 13 14 15
16
CS
SCLK
DIN
X = “Don’t Care” Bits
17 18 19 20 21 22 23
24
DOUT
DO
Don’t Care
NULL
BIT B9
B8
B6 B5 B4 B3 B2 B1 B0
HI-Z
00
0
1
XX
X
DO
SGL/
DIFF
XX
X
XX
X
B7 B6 B5 B4 B3 B2 B1 B0
B9 B8
0
??
?????
?
???
MCU latches data from A/D converter
on rising edges of SCLK
Data is clocked out of A/D
converter on falling edges
D1
D2
SGL
/
DIFF
Start
Bit
(Null)
D1
D2
Start
MCU Transmitted Data
(Aligned with falling
edge of clock)
MCU Received Data
(Aligned with rising
edge of clock)
B7
Data stored into MCU receive
register after transmission of first
8 bits
Data stored into MCU receive
register after transmission of
second 8 bits
Data stored into MCU receive
register after transmission of last
8 bits
?
00
MCP3004
VDD
10 F
IN-
IN+
-
+
VIN
C1
C2
VREF
4.096V
Reference
1F
0.1 F
MCP601
R1
R2
R3
R4
MCP1541
相關PDF資料 |
PDF描述 |
|---|---|
| MS3106E18-5S | CONN PLUG 3POS STRAIGHT W/SCKT |
| V110A3V3M150B | CONVERTER MOD DC/DC 3.3V 150W |
| V48B3V3M150BG3 | CONVERTER MOD DC/DC 3.3V 150W |
| MS3106F16-12P | CONN PLUG 1POS STRAIGHT W/PINS |
| VE-BTR-MX-F2 | CONVERTER MOD DC/DC 7.5V 75W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MCP3009 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:NON-ZERO-CROSSING TRIACS |
| MCP300X | 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:MCP300X 10-Bit Analog-to-Digital Converters |
| MCP3010 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:NON-ZERO-CROSSING TRIACS |
| MCP3011 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:NON-ZERO-CROSSING TRIACS |
| MCP3012 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:NON-ZERO-CROSSING TRIACS |
發布緊急采購，3分鐘左右您將得到回復。