- 您現在的位置：買賣IC網 > PDF目錄9443 > MCP40D17T-502E/LT (Microchip Technology)IC DGTL POT 5K 128TAPS SC70-6 PDF資料下載
參數資料
| 型號： | MCP40D17T-502E/LT |
| 廠商： | Microchip Technology |
| 文件頁數： | 27/43頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC DGTL POT 5K 128TAPS SC70-6 |
| 標準包裝： | 1 |
| 接片： | 128 |
| 電阻（歐姆）： | 5k |
| 電路數： | 1 |
| 溫度系數： | 標準值 150 ppm/°C |
| 存儲器類型： | 易失 |
| 接口： | I²C |
| 電源電壓： | 1.8 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 6-TSSOP，SC-88，SOT-363 |
| 供應商設備封裝： | SC-70-6 |
| 包裝： | 標準包裝 |
| 產品目錄頁面： | 674 (CN2011-ZH PDF) |
| 其它名稱： | MCP40D17T-502E/LTDKR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁當前第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁
2009 Microchip Technology Inc.
DS22152B-page 33
MCP40D17/18/19
5.0
SERIAL INTERFACE -
I2C MODULE
A 2-wire I2C serial protocol is used to write or read the
digital potentiometer’s wiper register. The I2C protocol
utilizes the SCL input pin and SDA input/output pin.
The I2C serial interface supports the following features:
Slave mode of operation
7-bit addressing
The following clock rate modes are supported:
- Standard mode, bit rates up to 100 kb/s
- Fast mode, bit rates up to 400 kb/s
Support Multi-Master Applications
The serial clock is generated by the Master.
The I2C Module is compatible with the Phillips I2C
specification. Philips only defines the field types, field
lengths, timings, etc. of a frame. The frame content
defines the behavior of the device. The frame content
for the MCP40D17, MCP40D18, and MCP40D19
devices are defined in this section of the data sheet.
FIGURE 5-1:
Typical Application I2C Bus
Configurations.
Refer to Section 2.0 “Typical Performance Curves”,
AC/DC Electrical Characteristics table for detailed input
threshold and timing specifications.
5.1
I2C I/O Considerations
I2C specifications require active low, passive high
functionality on devices interfacing to the bus. Since
devices may be operating on separate power supply
sources, ESD clamping diodes are not permitted. The
specification recommends using open drain transistors
tied to VSS (common) with a pull-up resistor. The
specification makes some general recommendations
on the size of this pull-up, but does not specify the
exact value since bus speeds and bus capacitance
impacts
the
pull-up
value
for
optimum
system
performance.
Common pull-up values range from 1 k
Ω to a maximum
of ~10 k
Ω. Power sensitive applications tend to choose
higher values to minimize current losses during
communication but these applications also typically
utilize lower VDD.
The SDA and SCL float (are not driving) when the
device is powered down.
A "glitch" filter is on the SCL and SDA pins when the pin
is an input. When these pins are an output, there is a
slew rate control of the pin that is independent of device
frequency.
5.1.1
SLOPE CONTROL
The device implements slope control on the SDA
output. The slope control is defined by the fast mode
specifications.
For Fast (FS) mode, the device has spike suppression
and Schmidt trigger inputs on the SDA and SCL pins.
Single I2C Bus Configuration
Host
Controller
Device 1
Device 3
Device n
Device 2
Device 4
相關PDF資料 |
PDF描述 |
|---|---|
| MS27656E23A35PA | CONN RCPT 100POS WALL MNT W/PINS |
| MS27474T16B42PC | CONN RCPT 42POS JAM NUT W/PINS |
| MCP40D18T-502E/LT | IC DGTL POT 5K 128TAPS SC70-6 |
| MS27656E13F4S | CONN RCPT 4POS WALL MNT W/SCKT |
| MS27499E20F35S | CONN RCPT 79POS BOX MNT W/SCKT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MCP40D17T-503AE/LT | 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:7-Bit Single I2C? (with Command Code) Digital POT with Volatile Memory in SC70 |
| MCP40D17T-503E/LT | 功能描述:數字電位計 IC 50k I2C sngl 7-bit volatile memory RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
| MCP40D18 | 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:7-Bit Single I2C? (with Command Code) Digital POT with Volatile Memory in SC70 |
| MCP40D18-103AE/LT | 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:7-Bit Single I2C? (with Command Code) Digital POT with Volatile Memory in SC70 |
| MCP40D18-103E/LT | 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:7-Bit Single I2C? (with Command Code) Digital POT with Volatile Memory in SC70 |
發布緊急采購，3分鐘左右您將得到回復。