- 您現在的位置：買賣IC網 > PDF目錄383595 > MCR100 (Rohm CO.,LTD.) Thick Film Rectangular(厚膜矩形電阻) PDF資料下載
參數資料
| 型號： | MCR100 |
| 廠商： | Rohm CO.,LTD. |
| 英文描述： | Thick Film Rectangular(厚膜矩形電阻) |
| 中文描述： | 厚膜矩形（厚膜矩形電阻） |
| 文件頁數： | 2/6頁 |
| 文件大?。?/td> | 106K |
| 代理商： | MCR100 |
MCR100
Resistors
!
Characteristics
Characteristics
Test method
Chip resistance
F: ± 1%
J: ± 5%
Specifications
Jumper type
DC resistance
Resistance temperature
characteristics
Insulation resistance
Withstand voltage
Intermittent overload
Terminal strength
(against bending of circuit board)
Solderability
Resistance to dry heat
Endurance
(rated load)
Endurance
(under load in damp environment)
Resistance to humidity
(steady state)
Temperature cycling
Resistance to solvents
Resistance to soldering heat
Short time overload
± (2.5% + 0.1
)
Max. 50m
± (5.0% + 0.1
)
Max. 50m
± (1.0% + 0.05
)
There must be no mechanical damage.
Max. 50m
± (1.0% + 0.05
)
Outside must not be noticeably damaged.
± (3.0% + 0.1
)
Max. 50m
Max. 100m
See Table 1.
Min. 1,000M
between terminal and board
Do not damage insulation or cause a short circuit.
95% of terminal surface must be covered by
new solder, and there must be
no soldering corrosion.
Markings must not be dissolved away.
Max. 50m
JIS C 5202 5.1
Applied voltage: A
JIS C 5202 5.2
Test conditions: + 25 / - 55 / + 25 / + 125
C
JIS C 5202 5.7
Test voltage: 500V
JIS C 5202 5.8
Rated voltage (current):
×
2.5
(1s: ON
25s: OFF)
×
10,000cyc.
JIS C 5202 6.1
JIS C 5202 6.4
Soldering conditions: 260 ± 5
C
Soldering time: 10 ± 1s.
JIS C 5202 7.2
125
C
Test time: 1,000 to 1,048 hrs.
± (3.0% + 0.1
)
± (5.0% + 0.1
)
± (3.0% + 0.1
)
± (1.0% + 0.05
)
± (0.5% + 0.05
)
Max. 100m
Max. 100m
Max. 100m
Max. 50m
Max. 100m
JIS C 5202 7.10
Rated voltage (current), 70
C
1.5h: ON - 0.5h: OFF
Test time: 1,000 to 1,048 hrs.
JIS C 5202 7.9
Rated voltage (current), 60
C
, 95%RH
1.5h: ON - 0.5h: OFF
Test time: 1,000 to 1,048 hrs.
JIS C 5202 7.5
85
C
, 85%RH
Test time: 1,000 to 1,048 hrs.
JIS C 5202 7.4
Test temperature: - 55
C
to + 125
C
100cyc.
JIS C 5202 6.9
Room temperature, static immersion, 1 min.
Solvent: Isopropyl alcohol
JIS C 5202 6.5
Rosin methanol: (25%WT)
Soldering conditions: 235 ± 5
C
Soldering time: 2.0 ± 0.5s.
JIS C 5202 5.5
Rated voltage (current):
×
2.5, 5s.
Maximum overload voltage: 400V
JIS C 5202 5.6
Test voltage: 100V, 1min.
Assembled state
Test resistor
Insulation
sheath
Insulation plate
Metal plate
Spring-loaded
pressure
R 0.5
Observation
point B
Metal block
observation
point A
相關PDF資料 |
PDF描述 |
|---|---|
| MCR101 | CHOPPER STABILIZED SWITCH W/TIN PLATING |
| MCR101-4 | CHOPPER STABILIZED SWITCH W/TIN PLATE |
| MCR101-6 | SEE A3242ELHLT-T |
| MCR101-8 | CHOPPER STABILIZED SWITCH W/TIN PLATING |
| MCR10EZHFL | Thick film rectangular Low resistance series |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MCR100_07 | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:Sensitive Gate Silicon Controlled Rectifiers Reverse Blocking Thyristors |
| MCR100_1 | 制造商:ROHM 制造商全稱:Rohm 功能描述:Thick film rectangular Low resistance series |
| MCR100_11 | 制造商:ROHM 制造商全稱:Rohm 功能描述:Low Ohmic Thick Film Chip Resistors |
| MCR100_2 | 制造商:ROHM 制造商全稱:Rohm 功能描述:Low Ohmic Thick Film Chip Resistors |
| MCR100-003 | 功能描述:SCR 100V 800mA RoHS:否 制造商:STMicroelectronics 最大轉折電流 IBO:480 A 額定重復關閉狀態電壓 VDRM:600 V 關閉狀態漏泄電流（在 VDRM IDRM 下）:5 uA 開啟狀態 RMS 電流 (It RMS): 正向電壓下降:1.6 V 柵觸發電壓 (Vgt):1.3 V 最大柵極峰值反向電壓:5 V 柵觸發電流 (Igt):35 mA 保持電流（Ih 最大值）:75 mA 安裝風格:Through Hole 封裝 / 箱體:TO-220 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。