- 您現在的位置：買賣IC網 > PDF目錄359155 > MCZ14467EGR2 (飛思卡爾半導體(中國)有限公司) Low-Power CMOS Ionization Smoke Detector IC PDF資料下載
參數資料
| 型號： | MCZ14467EGR2 |
| 廠商： | 飛思卡爾半導體(中國)有限公司 |
| 英文描述： | Low-Power CMOS Ionization Smoke Detector IC |
| 中文描述： | 低功耗CMOS集成電路電離煙霧探測器 |
| 文件頁數： | 5/9頁 |
| 文件大?。?/td> | 179K |
| 代理商： | MCZ14467EGR2 |
Sensors
Freescale Semiconductor
5
MC14467-1
DEVICE OPERATION
Timing
The internal oscillator of the MC14467-1 operates with a
period of 1.67 seconds during no-smoke conditions. Each
1.67 seconds, internal power is applied to the entire IC and a
check is made for smoke, except during LED pulse, Low
Battery Alarm Chirp, or Horn Modulation (in smoke). Every 24
clock cycles a check is made for low battery by comparing
V
DD
to an internal zener voltage. Since very small currents
are used in the oscillator, the oscillator capacitor should be of
a low leakage type.
Detect Circuitry
If smoke is detected, the oscillator period becomes 40 ms
and the piezoelectric horn oscillator circuit is enabled. The
horn output is modulated 160 ms on, 80 ms off. During the off
time, smoke is again checked and will inhibit further horn
output if no smoke is sensed. During smoke conditions the
low battery alarm is inhibited, but the LED pulses at a 1.0 Hz
rate.
An active guard is provided on both pins adjacent to the
detect input. The voltage at these pins will be within 100 mV
of the input signal. This will keep surface leakage currents to
a minimum and provide a method of measuring the input
voltage without loading the ionization chamber. The active
guard op amp is not power strobed and thus gives constant
protection from surface leakage currents. Pin 15 (the Detect
input) has internal diode protection against static damage.
Sensitivity/Low Battery Thresholds
Both the sensitivity threshold and the low battery voltage
levels are set internally by a common voltage divider (please
see
Figure 2
) connected between VDD and VSS. These
voltages can be altered by external resistors connected from
pins 3 or 13 to either VDD or VSS. There will be a slight
interaction here due to the common voltage divider network.
The sensitivity threshold can also be set by adjusting the
smoke chamber ionization source.
Test Mode
Since the internal op amps and comparators are power
strobed, adjustments for sensitivity or low battery level could
be difficult and/or time-consuming. By forcing Pin 12 to VSS,
the power strobing is bypassed and the outputs, Pins 1 and
4, constantly show smoke/no smoke and good battery/low
battery, respectively. Pin 1 = VDD for smoke and
Pin 4 = VDD for low battery. In this mode and during the
10 ms power strobe, chip current rises to approximately
50
μ
A.
LED Pulse
The 9-volt battery level is checked every 40 seconds
during the LED pulse. The battery is loaded via a 10 mA
pulse for 10 ms. If the LED is not used, it should be replaced
with an equivalent resistor such that the battery loading
remains at 10 mA.
Hysteresis
When smoke is detected, the resistor/divider network that
sets sensitivity is altered to increase sensitivity. This yields
approximately 100 mV of hysteresis and reduces false
triggering.
Figure 6. Typical Application as Ionization Smoke Detector
MC14467-1
1
16
2
3
4
5
6
7
8
15
14
13
12
11
10
9
Test
+
9.0 V
8.2 M
330
1.5 M
*
220 k
*
0.1 μF
1M
1M
0.1 μF
0.001*μF
*NOTE: Component values may change depending on type of piezoelectric horn used.
相關PDF資料 |
PDF描述 |
|---|---|
| MCZ145010EG | Photoelectric Smoke Detector IC with I/O |
| MCZ145011DW | Photoelectric Smoke Detector IC with I/O For Line-Powered Applications |
| MCZ145017EG | Low-Power CMOS Ionization Smoke Detector IC with Temporal Pattern Horn Driver |
| MCZ146010EG | Low Power CMOS Photoelectric Smoke Detector IC |
| MCZ146012EG | Low Power CMOS Photoelectric Smoke Detector IC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MCZ145010EG | 功能描述:煙霧報警器 PHOTO SMKE DET/NFPA TONE RoHS:否 制造商:ELMOS Semiconductor 描述/功能:Smoke detector controller 感應方式:Photoelectric 工作電源電壓:24 V 輸出信號類型: |
| MCZ145010EGR2 | 功能描述:煙霧報警器 SMOKE DET.PHOTO RoHS:否 制造商:ELMOS Semiconductor 描述/功能:Smoke detector controller 感應方式:Photoelectric 工作電源電壓:24 V 輸出信號類型: |
| MCZ145011DW | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Photoelectric Smoke Detector IC with I/O For Line-Powered Applications |
| MCZ145012EG | 功能描述:煙霧報警器 PHOTO SMKE DET/NFPA TONE RoHS:否 制造商:ELMOS Semiconductor 描述/功能:Smoke detector controller 感應方式:Photoelectric 工作電源電壓:24 V 輸出信號類型: |
| MCZ145012EG/R2 | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Photoelectric Smoke Detector IC with I/O and Temporal Pattern Horn Driver |
發布緊急采購，3分鐘左右您將得到回復。