參數資料
型號： MD80C52CXXX-16SCD
廠商： ATMEL CORP
元件分類： 微控制器/微處理器
英文描述： 8-BIT, MROM, 16 MHz, MICROCONTROLLER, CDIP40
封裝： 0.600 INCH, CERAMIC, DIP-40
文件頁數： 47/80頁
文件大?。?/td> 5152K
代理商： MD80C52CXXX-16SCD
247
XMEGA A [MANUAL]
8077I–AVR–11/2012
Bit 1:0 – DREINTLVL[1:0]: Data Register Empty Interrupt Level
These bits enable the data register empty interrupt and select the interrupt level, as described in “Interrupts and
Programmable Multilevel Interrupt Controller” on page 125. The enabled interrupt will be triggered when the DREIF flag
in the STATUS register is set.
21.15.4 CTRLB – Control register B
Bit 7:5 – Reserved
These bits are unused and reserved for future use. For compatibility with future devices, always write these bits to zero
when this register is written.
Bit 4 – RXEN: Receiver Enable
Setting this bit enables the USART receiver. The receiver will override normal port operation for the RxD pin, when
enabled. Disabling the receiver will flush the receive buffer, invalidating the FERR, BUFOVF, and PERR flags.
Bit 3 – TXEN: Transmitter Enable
Setting this bit enables the USART transmitter. The transmitter will override normal port operation for the TxD pin, when
enabled. Disabling the transmitter (writing TXEN to zero) will not become effective until ongoing and pending
transmissions are completed; i.e., when the transmit shift register and transmit buffer register do not contain data to be
transmitted. When disabled, the transmitter will no longer override the TxD port.
Bit 2 – CLK2X: Double Transmission Speed
Setting this bit will reduce the divisor of the baud rate divider from16 to 8, effectively doubling the transfer rate for
asynchronous communication modes. For synchronous operation, this bit has no effect and should always be written to
zero. This bit must be zero when the USART communication mode is configured to IRCOM.
This bit is unused in master SPI mode operation.
Bit 1 – MPCM: Multiprocessor Communication Mode
This bit enables the multiprocessor communication mode. When the MPCM bit is written to one, the USART receiver
ignores all the incoming frames that do not contain address information. The transmitter is unaffected by the MPCM
setting. For more detailed information, see “Multiprocessor Communication Mode” on page 244.
This bit is unused in master SPI mode operation.
Bit 0 – TXB8: Transmit Bit 8
TXB8 is the ninth data bit in the character to be transmitted when operating with serial frames with nine data bits. When
used, this bit must be written before writing the low bits to DATA.
This bit is unused in master SPI mode operation.
Bit
765
43210
+0x04
–
RXEN
TXEN
CLK2X
MPCM
TXB8
Read/Write
R
R/W
Initial Value
0
相關PDF資料
PDF描述
MQ80C52TXXX-25SCR 8-BIT, MROM, 25 MHz, MICROCONTROLLER, CQFP44
MQ80C52CXXX-30/883D 8-BIT, MROM, 30 MHz, MICROCONTROLLER, CQFP44
MR83C154XXX-25P883 8-BIT, MROM, 25 MHz, MICROCONTROLLER, CQCC44
MS80C51-12D 8-BIT, MROM, 12 MHz, MICROCONTROLLER, PQCC44
MT80C51T-16R 8-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP44
相關代理商/技術參數
參數描述
MD80C86 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:CMOS 16-Bit Microprocessor
MD80C862 制造商:Intel 功能描述:PROCESSOR:MICRO-PROCESSOR
MD80C86-2 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:CMOS 16-Bit Microprocessor
MD80C86-2/883 制造商:Intersil Corporation 功能描述:MPU 16BIT CMOS 8MHZ 40CDIP - Rail/Tube 制造商:Rochester Electronics LLC 功能描述:CPU 16BILT 5V CMOS 8MHZ 40CDIP - Bulk
MD80C86-2/B 制造商:Intersil Corporation 功能描述:MPU 16BIT CMOS 8MHZ 40CDIP - Rail/Tube
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*