- 您現在的位置：買賣IC網 > PDF目錄359164 > MGCT04 (Zarlink Semiconductor Inc.) Transmit Circuit for TDMA/AMPS and CDMA/AMPS PDF資料下載
參數資料
| 型號： | MGCT04 |
| 廠商： | Zarlink Semiconductor Inc. |
| 英文描述： | Transmit Circuit for TDMA/AMPS and CDMA/AMPS |
| 中文描述： | 發送電路的TDMA / AMPS二元和CDMA / AMPS二元 |
| 文件頁數： | 6/12頁 |
| 文件大?。?/td> | 343K |
| 代理商： | MGCT04 |
Preliminary Information
MGCT04
5
1900MHz RF output stage (PCS)
Speci
fi
cations assume 50 ohm
load driven via a matching network
(Fig. 5)
RF ampli
fi
er operating frequency
range
1850
1910
MHz
Output power
+8
+18
dBm
Note 1
ACPR (CDMA)
-66
-52
dBc
Pout = +3dBm Vcc = 3V
ACPR (TDMA)
-45
-30
dBc
Pout = +8dBm, Offset = 30kHz
Vcc = 3V
-90
-60
dBc
Pout = +8dBm, Offset = 60kHz
Vcc = 3V
Receive band noise
-128
dBm/
Hz
At duplex frequency, offset 80MHz
Pout = +3dBm
Receive band noise
(1930 - 1990 MHz)
-123
-121
dBm/
Hz
ftx = 1910MHz, Pout = +8dBm
Spurious Outputs
LO Leakage
-30
-20
dBc
Pout = +8dBm
Image Rejection
-30
-20
dBc
Pout = +8dBm
Other Spurii
-20
dBm
Note 3
Characteristics
Value
Units
Conditions
Min.
Typ.
Max.
Table 3 - AC Characteristics (continued)
Notes:
1. V (I/Q) = 1.4V differential, VHF LO = 22mV rms, UHF LO = -15dBm, VGA = 2.6volts
2. V (I/Q) = 1.4 V dc differential, VHF LO = 22mV rms, UHF LO = -15dBm, VGA = 2.6 volts
3. Frequency range 10MHz to 10*ftx except Rx and Tx bands
Circuit Description
General
The MGCT04 circuit is designed to provide the
transmit function in dual band dual mode CDMA/
AMPS IS136/AMPS mobile phones. The circuit
contains the following blocks:
1. Quadrature modulator
2. VHF voltage controlled oscillator buffer and
divide by 8 prescaler
3. Active IF low pass
fi
lter
4. IF variable gain ampli
fi
er
5. Single sideband mixer with external UHF
oscillator inputs
6. RF variable gain ampli
fi
er
7. 900MHz and 1900MHz high power output driver
stages
8. Power and mode control logic
Quadrature Modulator
I and Q data from a baseband circuit such as the
Zarlink Semiconductor MGCM02 or MGCM03 circuit
is applied to the I and Q inputs of the quadrature
modulator to produce the intermediate frequency by
mixing with the local oscillator frequency from the
VHF VCO. The control inputs can select either a
divide by two or divide by four function between the
VHF VCO and the quadrature modulator giving a
choice of possible intermediate frequencies.
VHF Oscillator Input Oscillator Bias and
Divider
An external VHF oscillator circuit is AC coupled to
the VHF oscillator input. The oscillator drives the
quadrature modulator and an internal divide by eight
circuit to reduce the frequency of the output signal to
be sent off chip to the frequency synthesiser. This
reduces the power required in the output buffer
circuit and also allows a low frequency low power
CMOS synthesiser to be used. The divider can be
disabled if not required by connecting the output pin
(DIV OUT - pin 7) to the positive power supply. This
reduces the total supply current by typically 4mA. An
oscillator bias circuit is included on the chip so that
the external VHF oscillator transistor can be switched
off using the control inputs. The bias voltage is
相關PDF資料 |
PDF描述 |
|---|---|
| MGCT04KG | Transmit Circuit for TDMA/AMPS and CDMA/AMPS |
| MGD2388 | Optoelectronic |
| MSD2388 | Optoelectronic |
| MUD2388 | Optoelectronic |
| MH1A | High Dynamic Range PCS-Band MMIC Mixer |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MGCT04KG | 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:Transmit Circuit for TDMA/AMPS and CDMA/AMPS |
| MGCT04LH1S | 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:Transmit Circuit for TDMA/AMPS and CDMA/AMPS |
| MGCT04LH1T | 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:Transmit Circuit for TDMA/AMPS and CDMA/AMPS |
| MGD623N | 制造商:Sanken Electric Co Ltd 功能描述:Tube |
| MGD623S | 制造商:Sanken Electric Co Ltd 功能描述:IGBT 600V 50A 150W TO3P |
發布緊急采購，3分鐘左右您將得到回復。