- 您現在的位置：買賣IC網 > PDF目錄383612 > MIC5156BN (MICREL INC) Replaced by PTN78060W : PDF資料下載
參數資料
| 型號： | MIC5156BN |
| 廠商： | MICREL INC |
| 元件分類： | 模擬信號調理 |
| 英文描述： | Replaced by PTN78060W : |
| 中文描述： | SPECIALTY ANALOG CIRCUIT, PDIP8 |
| 封裝： | DIP-8 |
| 文件頁數： | 8/11頁 |
| 文件大?。?/td> | 94K |
| 代理商： | MIC5156BN |
March 1999
3-119
MIC5156/5157/5158
Micrel
3
Charge Pump (MIC5157/5158 only)
The charge pump tripler creates a dc voltage across reservoir
capacitor C3. External capacitors C1 and C2 provide the
necessary storage for the stages of the charge pump tripler.
The tripler’s approximate dc output voltage is:
V
CP
≈
3 (V
DD
– 1)
where:
V
CP
= charge pump output voltage
V
DD
= supply voltage
The V
CP
clamp circuit limits the charge pump voltage to 16V
above V
DD
by gating the charge pump oscillator ON or OFF
as required. The charge pump oscillator operates at 160kHz.
The error amplifier uses the charge pump voltage to drive the
gate of the external MOSFET. It provides a constant load of
about 1mA to the charge pump. The error amplifier output can
swing to within 1V of V
CP
.
Although the MIC5157/8 is designed to provide gate drive
using its internal charge pump, an external gate drive supply
voltage can be applied to V
CP
. When using an external gate
drive supply, V
CP
must not be forced more than 14V higher
than V
DD
.
When constant loads are driven, the ON/OFF switching of the
charge pump may be evident on the output waveform. This is
caused by the charge pump switching ON and rapidly in-
creasing the supply voltage to the error amplifier. The period
of this small charge pump excitation is determined by a
number of factors: the input voltage, the 1mA op-amp load,
any dc leakage associated with the MOSFET gate circuit, the
size of the charge pump capacitors, the size of the charge
pump reservoir capacitor, and the characteristics of the input
voltage and load. The period is lengthened by increasing the
charge pump reservoir capacitor (C3). The amplitude is
reduced by weakening the charge pump—this is accom-
plished by reducing the size of the pump capacitors (C1 and
C2). If this small burst is a problem in the application, use a
10
μ
F reservoir capacitor at C3 and 0.01
μ
F pump capacitors
at C1 and C2. Note that the recovery time to repetitive load
transients may be affected with small pump capacitors.
Gate-to-Source Clamp
A gate-to-source protective voltage clamp of 16.6V protects
the MOSFET in the event that the output voltage is suddenly
forced to zero volts. This prevents damage to the external
MOSFET during shorted load conditions. Refer to “Charge
Pump” for normal clamp circuit operation.
The source connection required by the gate-to-source clamp
is not available on the adjustable version of the MIC5156.
Output Regulation
At start-up, the error amplifier feedback voltage (EA), or
internal feedback on fixed versions, is below nominal when
compared to the internal 1.235V bandgap reference. This
forces the error amplifier output high which turns on external
MOSFET Q1. Once the output reaches regulation, the con-
troller maintains constant output voltage under changing
input and load conditions by adjusting the error amplifier
output voltage (gate enhancement voltage) according to the
feedback voltage.
Out-of-Regulation Detection
When the output voltage is 8% or more below nominal, the
open-collector FLAG output (normally high) is forced low to
signal a fault condition. The FLAG output can be used to
signal or control external circuitry. The FLAG output can also
be used to shut down the regulator using the EN control.
Current Limiting
Super LDO Regulators perform constant-current limiting (not
foldback). To implement current limiting, a sense resistor
(R
S
) must be placed in the “power” path between V
DD
and D
(drain).
If the voltage drop across the sense resistor reaches 35mV,
the current limit comparator reduces the error amplifier out-
put. The error amplifier output is decreased only enough to
reduce the output current, keeping the voltage across the
sense resistor from exceeding 35mV.
Application Information
MOSFET Selection
Standard N-channel enhancement-mode MOSFETs are ac-
ceptable for most Super LDO regulator applications.
Logic-level N-channel enhancement-mode MOSFETs may
be necessary if the external gate drive voltage is too low
(MIC5156), or the input voltage is too low, to provide ad-
equate charge pump voltage (MIC5157/8) to enhance a
standard MOSFET.
Circuit Layout
For the best voltage regulation, place the source, ground, and
error amplifier connections as close as possible to the load.
See figures (1a) and (1b).
GND
S
L
G
MIC515x
V
IN
Figure 1a. Connections for Fixed Output
相關PDF資料 |
PDF描述 |
|---|---|
| MIC5158BM | Replaced by PTN78060W : |
| MIC5158BN | Replaced by PTN78060W : |
| MIC5157 | Super LDO Regulator Controller(超低壓差穩壓器控制器) |
| MIC5159 | PROGRAMMABLE CURRENT LIMIT UCAP LDO REGULATOR CONTROLLER |
| MIC5159-1.8BM6 | PROGRAMMABLE CURRENT LIMIT UCAP LDO REGULATOR CONTROLLER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MIC5156-MIC5157-MIC5158穩壓控制器 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述: |
| MIC5156YM | 功能描述:低壓差控制器 - LDO Super LDO Regulator-Adjustable(Lead Free) RoHS:否 制造商:Micrel 最大輸入電壓:5.5 V 輸出電壓:Adjustable 輸出電流:10 mA 負載調節: 輸出類型:Adjustable, Fixed 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-23-6 |
| MIC5156YM TR | 功能描述:低壓差控制器 - LDO Super LDO Regulator-Adjustable(Lead Free) RoHS:否 制造商:Micrel 最大輸入電壓:5.5 V 輸出電壓:Adjustable 輸出電流:10 mA 負載調節: 輸出類型:Adjustable, Fixed 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-23-6 |
| MIC5156YN | 功能描述:低壓差控制器 - LDO Super LDO Regulator-Adjustable(Lead Free) RoHS:否 制造商:Micrel 最大輸入電壓:5.5 V 輸出電壓:Adjustable 輸出電流:10 mA 負載調節: 輸出類型:Adjustable, Fixed 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-23-6 |
| MIC5157BM | 功能描述:IC REG CTRLR SGL OUT 14SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性晶體管驅動器 系列:- 產品培訓模塊:More Information on LDOs 標準包裝:2,500 系列:- 類型:正，固定式 輸出數:2 輸出電壓:2.8V，3.3V 電流 - 電源:12mA 輸入電壓:5 V ~ 22 V 工作溫度:0°C ~ 70°C 封裝/外殼:16-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:16-SOIC 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。