參數資料
型號: MIC5204BS
廠商: MICREL INC
元件分類: 通用總線功能
英文描述: SCSI-II Active Terminator Preliminary Information
中文描述: 27-LINE 110 ohm SCSI BUS TERMINATOR, DSO4
封裝: SOT-223, 4 PIN
文件頁數: 4/4頁
文件大小: 28K
代理商: MIC5204BS
MIC5204
Applications Information
Micrel
February 1999
62
MIC5204
Thermal Considerations
Part I. Layout
External Capacitors
A 2.2
μ
F capacitor is recommended between the MIC5204
output and ground to prevent oscillations due to instability.
Larger values serve to improve the regulator's transient re-
sponse. Most types of tantalum or aluminum electrolytics will
be adequate; film types will work. Many aluminum electrolytics
have electrolytes that freeze at about –30
°
C, so solid tantalums
are recommended for operation below –25
°
C. The important
parameters of the capacitor are an effective series resistance
of about 5
or less and a resonant frequency above 500kHz.
The value of this capacitor may be increased without limit.
A 1
μ
F capacitor should be placed from the MIC5204 input to
ground if there is more than 10 inches of wire between the
input and the AC filter capacitor or if a battery is used as the
input.
The MIC5204 will remain stable and in regulation with no load
in addition to the internal voltage divider.
PC Board
Dielectric
FR4
Ceramic
θ
JA
160
°
C/W
120
°
C/W
Multi-layer boards having a ground plane, wide traces near
the pads, and large supply bus lines provide better thermal
conductivity. The "worst case" value of 160
°
C/W assumes no
ground plane, minimum trace widths, and a FR4 material
board.
Part II. Nominal Power Dissipation and Die Temperature
The MIC5204BM at a 25
°
C ambient temperature will operate
reliably at up to 625mW power dissipation when mounted in
the "worst case" manner described above. At an ambient
temperature of 55
°
C, the device may safely dissipate 440mW.
These power levels are equivalent to a die temperature of
125
°
C, the recommended maximum temperature for non-
military grade silicon integrated circuits. In normal SCSI
terminator applications, the average power dissipation is very
small and this minimum geometry heat sink is suitable. The
total dissipation does not approact the 400mW to 625mW
range described above.
For MIC5204BS (SOT-223 package) heat sink characteris-
tics, please refer to Micrel Application Hint 17, “P.C. Board
Heat Sinking”. As with the SO-8, average power dissipation
in SCSI terminator applications is low and a minimum pad size
is generally adequate.
The MIC5204BM (8-pin surface mount package) has the
following thermal characteristics when mounted on a single
layer copper-clad printed circuit board.
245 mil
30 mil
50 mil
50 mil
150 mil
Minimum recommended board pad size, SO-8.
相關PDF資料
PDF描述
MIC5204 SCSI-II Active Terminator Preliminary Information
mic5208 Dual 50mA LDO Voltage Regulator(輸出電流50mA低壓差雙電壓穩壓器)
MIC5208-4.0BMM Dual 50mA LDO Voltage Regulator Preliminary Information
MIC5208-5.0BMM Dual 50mA LDO Voltage Regulator Preliminary Information
MIC5208 Dual 50mA LDO Voltage Regulator Preliminary Information
相關代理商/技術參數
參數描述
MIC5205 制造商:MICREL 制造商全稱:Micrel Semiconductor 功能描述:150mA Low-Noise LDO Regulator
MIC5205_06 制造商:MICREL 制造商全稱:Micrel Semiconductor 功能描述:150mA Low-Noise LDO Regulator
MIC5205-1.5BM5 制造商:Exar Corporation 功能描述:VOLTAGE REGULATOR
MIC5205-1.88BM5TR 制造商:Rochester Electronics LLC 功能描述:- Tape and Reel 制造商:RF Micro Devices Inc 功能描述: 制造商:Micrel Inc 功能描述:
MIC5205-1.8BM5 制造商:Rochester Electronics LLC 功能描述:- Bulk