- 您現在的位置：買賣IC網 > PDF目錄69033 > MK1493-02AG 200 MHz, PROC SPECIFIC CLOCK GENERATOR, PDSO56 PDF資料下載
參數資料
| 型號： | MK1493-02AG |
| 元件分類： | 時鐘產生/分配 |
| 英文描述： | 200 MHz, PROC SPECIFIC CLOCK GENERATOR, PDSO56 |
| 封裝： | 6.10 MM, 0.50 MM PITCH, TSSOP-56 |
| 文件頁數： | 7/24頁 |
| 文件大?。?/td> | 444K |
| 代理商： | MK1493-02AG |
Networking/PCI Clock Generator
MDS 1493-02A C
15
Revision 020204
Integrated Circuit Systems, Inc.
● 525 Race Street, San Jose, CA 95126 ● tel (408) 297-1201 ● www.icst.com
MK1493-02A
External Components
The MK1493-02A requires a minimum number of
external components for proper operation.
Decoupling Capacitor
Decoupling Capacitors of 0.1
F and 0.001F must be
connected between each VDD and GND as close to
the device as possible. For optimum device
performance, the decoupling capacitor should be
mounted on the component side of the PCB. Avoid the
use of vias in the decoupling circuit.
Series Termination Resistor
When the PCB trace between the clock outputs and the
loads are over one inch, series termination should be
used. To series terminate a 50
trace (a commonly
used trace impedance), place a 33
resistor in series
with the clock line as close to the clock output pin as
possible. The nominal impedance of the clock output is
20 Ohms.
Crystal Information
The crystal used should be a fundamental mode,
parallel resonant crystal. Do not use third overtone.
Crystal capacitors should be connected from pins X1 to
ground and from X2 to ground to optimize the initial
accuracy. The value of these capacitors is given by the
following equation:
Crystal caps (pF) = (CL - 6) x 2
In the equation, CL is the crystal load capacitance. So
for a crystal with 16 pF load capacitance, two 20 pF
[(1606) x 2] capacitors should be used.
Absolute Maximum Ratings
Stresses above the ratings listed below can cause permanent damage to the MK1493-02A. These ratings
are stress ratings only. Functional operation of the device at these or any other conditions above those
indicated in the operational sections of the specifications is not implied. Exposure to absolute maximum
rating conditions for extended periods can affect product reliability. Electrical parameters are guaranteed
only over the recommended operating temperature range.
Item
Rating
Supply Voltage, VDD
5.5 V
All Inputs and Outputs
-0.5 V to VDD+0.5 V
Ambient Operating Temperature
0 to +70
°C
Storage Temperature
-65 to +150
°C
Junction Temperature
125
°C
Soldering Temperature
260
°C
相關PDF資料 |
PDF描述 |
|---|---|
| MK2049-10SITRLF | 44.736 MHz, OTHER CLOCK GENERATOR, PDSO20 |
| MK2049-10SI | 44.736 MHz, OTHER CLOCK GENERATOR, PDSO20 |
| MK2049-10SI | 44.736 MHz, OTHER CLOCK GENERATOR, PDSO20 |
| MK2049-10SILF | 44.736 MHz, OTHER CLOCK GENERATOR, PDSO20 |
| MK2049-10SITR | 44.736 MHz, OTHER CLOCK GENERATOR, PDSO20 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MK1493-03B | 制造商:IDT 制造商全稱:Integrated Device Technology 功能描述:PCI CLOCK GENERATOR |
| MK1493-03BGILF | 制造商:Integrated Device Technology Inc 功能描述:DIFFERENTIAL SPREAD SPECTRUM CLOCK DRIVER, TSSOP16 - Rail/Tube |
| MK1493-03BGILFTR | 制造商:Integrated Device Technology Inc 功能描述:IDT MK1493-03BGILFTR PHASED LOCKED LOOP (PLL) - Tape and Reel 制造商:Integrated Device Technology Inc 功能描述:IDT MK1493-03BGILFTR Phased Locked Loop (PLL) |
| MK1493-03BGLF | 制造商:Integrated Device Technology Inc 功能描述:DIFFERENTIAL SPREAD SPECTRUM CLOCK DRIVER, - Rail/Tube |
| MK1493-03BGLFTR | 制造商:IDT 制造商全稱:Integrated Device Technology 功能描述:PCI CLOCK GENERATOR |
發(fā)布緊急采購，3分鐘左右您將得到回復。