- 您現在的位置：買賣IC網 > PDF目錄377971 > ML50000 (OKI SEMICONDUCTOR CO., LTD.) Echo Canceler(回聲消除器) PDF資料下載
參數資料
| 型號： | ML50000 |
| 廠商： | OKI SEMICONDUCTOR CO., LTD. |
| 英文描述： | Echo Canceler(回聲消除器) |
| 中文描述： | 回聲消除器（回聲消除器） |
| 文件頁數： | 24/26頁 |
| 文件大?。?/td> | 287K |
| 代理商： | ML50000 |
Semiconductor
ML50000
24/26
NOTES ON USE
1. Set echo return loss (ERL) to be attenuated. The echo can be eliminated even if the
echo return loss is set to be amplified. This may cause an excessive input.
Refer to the characteristics diagram for ERL vs. echo attenuation quantity.
2. Set the level of the analog input so that the PCM CODEC does not overflow.
3. The recommended input level is –10 to –20 dBm0. Refer to the characteristics
diagram for the RIN input level vs. echo attenuation quantity.
4. Applying the tone signal to this echo canceler for long duration may decrease echo
attenuation.
When used with the HD pin "L" (howling detector ON), this echo canceler may
operate faultily if, while a signal is input to the RIN pin, a tone signal with a higher
level than the signal being input to RIN is input to the SIN pin.
A signal should therefore be input either to the RIN pin or to the SIN pin. If,
however, the tone signal is input to the SIN pin while a signal is input to the RIN pin,
the ADP, HD, or HCL pin must be set to "H".
5. When turning the power ON, set the
PWDWN
pin to "1" and input the basic clock
simultaneously with power ON.
If powering down immediately after power ON, be sure fast input 10 or more clocks
of the basic clock.
6. After powering ON, be sure to reset.
7. After the power down mode is released (when the
PWDWN
pin is changed to "H"
from "L"), be sure to reset the device.
8. If this canceler is used to cancel acoustic echoes, an echo attenuation may be less
than 30 dB.
相關PDF資料 |
PDF描述 |
|---|---|
| ML53612 | 64-Channel Full Duplex H.100/H.110 CT Bus System Interface and Time-Slot Interchange |
| ML60851D | USB Device Controller |
| ML60852 | USB Device Controller |
| ML6190A | Longwave Time Code RF Receiver LSI |
| ML63187 | 4-Bit Microcontroller with Built-in 1024-Dot Matrix LCD Drivers and Melody Circuit, Operating at 0.9 V (Min). |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ML-5000-C1-2P | 制造商:Sato Parts USA 功能描述:General MC reference article |
| ML-5000-C1-3P | 制造商:Sato Parts USA 功能描述:General MC reference article |
| ML-5000-C1-4P | 制造商:Sato Parts USA 功能描述:General MC reference article |
| ML-5000-C2-2P | 制造商:Sato Parts 功能描述:General MC reference article |
| ML-5000-C2-3P | 制造商:Sato Parts USA 功能描述:General MC reference article |
發布緊急采購，3分鐘左右您將得到回復。