參數資料
型號: MP2482DN
廠商: MONOLITHIC POWER SYSTEMS INC
元件分類: 穩壓器
英文描述: 9 A SWITCHING REGULATOR, 600 kHz SWITCHING FREQ-MAX, PDSO8
封裝: MS-012BA, SOIC-8
文件頁數: 8/11頁
文件大?。?/td> 350K
代理商: MP2482DN
MP2482 – 5A, 30V, 420KHZ STEP-DOWN CONVERTER
MP2482 Rev.1.2
www.MonolithicPower.com
6
10/22/2009
MPS Proprietary Information. Unauthorized Photocopy and Duplication Prohibited.
2009 MPS. All Rights Reserved.
OPERATION
IN
EN/SYNC
FB
GND
SW
BST
REGULATOR
OSCILLATOR
420KHz
DRIVER
CURRENT SENSE
AMPLIFIER
x40
ERROR
AMPLIFIER
CURRENT
LIMIT
COMPARATOR
PWM
COMPARATOR
D2
REGULATOR
REFERENCE
Σ
--
+
--
+
--
+
S
R
Q
--
+
VCC
54pF
1pF
PG
POWER
GOOD
0.74V
0.81 VREF
Figure 1—Functional Block Diagram
The MP2482 is a fixed frequency, non-
synchronous, step-down switching regulator
with an integrated high-side power MOSFET. It
achieves 5A continuous output current over a
wide input supply range with excellent load and
line regulation. It provides a single highly
efficient solution with current mode control for
fast loop response and easy compensation.
The MP2482 operates in a fixed frequency,
peak current control mode to regulate the
output voltage. A PWM cycle is initiated by the
internal clock. The integrated high-side power
MOSFET is turned on and remains on until its
current reaches the value set by the COMP
voltage. When the power switch is off, it
remains off until the next clock cycle starts. If, in
90% of one PWM period, the current in the
power MOSFET does not reach the COMP set
current value, the power MOSFET will be
forced to turn off.
Power Good Indicator
When the FB is below 0.74V, the PG pin will be
internally pulled low. When the FB is above
0.74V, the PG becomes an open-drain output.
Error Amplifier
The error amplifier compares the FB pin voltage
with the internal 0.81V reference (REF) and
outputs a current proportional to the difference
between the two. This output current is then
used to charge or discharge the internal
compensation network to form the COMP
voltage, which is used to control the power
MOSFET current. The optimized internal
compensation network minimizes the external
component counts and simplifies the control
loop design.
Internal Regulator
Most of the internal circuitries are powered from
the 5V internal regulator. This regulator takes
the VIN input and operates in the full VIN range.
When VIN is greater than 5.0V, the output of
the regulator is in full regulation. When VIN is
lower than 5.0V, the output decreases. Since
this internal regulator provides the bias current
for the bottom gate driver that requires
significant amount of current depending upon
the external MOSFET selection, a 1uF ceramic
capacitor for decoupling purpose is required.
相關PDF資料
PDF描述
MP5010GN 1-OUTPUT TWO TERM VOLTAGE REFERENCE, 1.22 V, PBCY2
MP6-6131022R 10 CONTACT(S), FEMALE, STRAIGHT TWO PART BOARD CONNECTOR, SURFACE MOUNT
MP6-6131522R 15 CONTACT(S), FEMALE, STRAIGHT TWO PART BOARD CONNECTOR, SURFACE MOUNT
MP6-6132022R 20 CONTACT(S), FEMALE, STRAIGHT TWO PART BOARD CONNECTOR, SURFACE MOUNT
MP6-6132522R 25 CONTACT(S), FEMALE, STRAIGHT TWO PART BOARD CONNECTOR, SURFACE MOUNT
相關代理商/技術參數
參數描述
MP2482DN-LF 功能描述:開關變換器、穩壓器與控制器 6A 30V 420kHz Nonsync Step-Down RoHS:否 制造商:Texas Instruments 輸出電壓:1.2 V to 10 V 輸出電流:300 mA 輸出功率: 輸入電壓:3 V to 17 V 開關頻率:1 MHz 工作溫度范圍: 安裝風格:SMD/SMT 封裝 / 箱體:WSON-8 封裝:Reel
MP2482DN-LF-Z 功能描述:開關變換器、穩壓器與控制器 6A 30V 420kHz Nonsync Step-Down RoHS:否 制造商:Texas Instruments 輸出電壓:1.2 V to 10 V 輸出電流:300 mA 輸出功率: 輸入電壓:3 V to 17 V 開關頻率:1 MHz 工作溫度范圍: 安裝風格:SMD/SMT 封裝 / 箱體:WSON-8 封裝:Reel
MP24830HS-LF 功能描述:LED照明驅動器 LED driver for TV LED backlight RoHS:否 制造商:STMicroelectronics 輸入電壓:11.5 V to 23 V 工作頻率: 最大電源電流:1.7 mA 輸出電流: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:SO-16N
MP24830HS-LF-Z 制造商:Monolithic Power Systems 功能描述:BUCK BOOST POWER LEVERAGE LED DRIVER FOR TV LED BACKLIGHT - Tape and Reel 制造商:Monolithic Power Systems 功能描述:LED driver for TV LED backlight
MP24833GN 制造商:Monolithic Power Systems 功能描述:3A, 55V LED DRIVER WITH INTEGRATED FET - Rail/Tube 制造商:Monolithic Power Systems 功能描述:2.5A, 55V, Prgrmbl Freq White LED Drvr