- 您現在的位置：買賣IC網 > PDF目錄369923 > MPC5200ID (Motorola, Inc.) MPC5200 Hardware Specifications PDF資料下載
參數資料
| 型號： | MPC5200ID |
| 廠商： | Motorola, Inc. |
| 英文描述： | MPC5200 Hardware Specifications |
| 中文描述： | MPC5200的硬件規格 |
| 文件頁數： | 71/76頁 |
| 文件大小： | 1404K |
| 代理商： | MPC5200ID |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁當前第71頁第72頁第73頁第74頁第75頁第76頁
MOTOROLA
MPC5200 Hardware Specifications
71
System Design Information
6.3.3 Pull-up/Pull-down Requirements for MEM_MDQS pins (SDRAM)
The MEM_MDQS[3:0] signals are not used with SDR memories and require pull-up or pull-down resistors
in SDRAM mode.
6.4
Boundary scan testing is enabled through the JTAG interface signals. The JTAG_TRST signal is optional
in the IEEE 1149.1 specification but is provided on all processors that implement the PowerPC
architecture. To obtain a reliable power-on reset performance, the JTAG_TRST signal must be asserted
during power-on reset.
Information about JTAG_TRST
6.4.1 JTAG_TRST and PORRESET
The JTAG interface can control the direction of the MPC5200 I/O pads via the boundary scan chain. The
JTAG module must be reset before the MPC5200 comes out of power-on reset; do this by asserting
JTAG_TRST before PORRESET is released.
For more details refer to the Reset and JTAG Timing Specification.
Figure 52 PORRESET vs. JTAG_TRST
6.5
The wiring of the JTAG_TRST is dependent of the existence of a board-related debug interface.
Connecting JTAG_TRST
Normally this interface is implemented, using a COP (common on-chip processor) connector. The COP
allows a remote computer system (typically, a PC with dedicated hardware and debugging software) to
access and control the internal operations of the MPC5200. The COP port requires the ability to
independently assert HRESET and JTAG_TRST in order to fully control the processor.
There are two possibilities to connect the JTAG interface: using it with a COP connector and without a
COP connector.
6.5.1 Boards interfacing the JTAG port via a COP connector
For a board with a COP (common on-chip processor) connector, which accesses the JTAG interface and
which needs to reset the JTAG module, simply wiring TRST and PORRESET is not recommended.
To reset the MPC5200 via the COP connector, the HRESET pin of the COP should be connected to the
HRESET pin of the MPC5200.
The circuitry shown in Figure 53 allows the COP to assert HRESET or JTAG_TRST separately, while any
other board sources can drive PORRESET.
JTAG_TRST
PORRESET
required assertion of JTAG_TRST
optional assertion of JTAG_TRST
F
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
n
.
相關PDF資料 |
PDF描述 |
|---|---|
| MPC555 | Highly Integrated, Low-Power, 32-Bit Microcontroller |
| MPC561 | RISC MCU Including Peripheral Pin Multiplexing with Flash and Code Compression Options |
| MPC561MZP56 | RISC MCU Including Peripheral Pin Multiplexing with Flash and Code Compression Options |
| MPC562 | RISC MCU Including Peripheral Pin Multiplexing with Flash and Code Compression Options |
| MPC562MZP56 | RISC MCU Including Peripheral Pin Multiplexing with Flash and Code Compression Options |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MPC5200VR400 | 功能描述:微處理器 - MPU NO-PB COMM 5200 400MHZ RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324 |
| MPC5200VR400B | 功能描述:微處理器 - MPU HABANERO COMM PBFREE RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324 |
| MPC5200VR400BR2 | 功能描述:IC MPU 32BIT 400MHZ 272-PBGA RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:MPC52xx 標準包裝:1 系列:AVR® ATmega 核心處理器:AVR 芯體尺寸:8-位 速度:16MHz 連通性:I²C，SPI，UART/USART 外圍設備:欠壓檢測/復位，POR，PWM，WDT 輸入/輸出數:32 程序存儲器容量:32KB（16K x 16） 程序存儲器類型:閃存 EEPROM 大小:1K x 8 RAM 容量:2K x 8 電壓 - 電源 (Vcc/Vdd):2.7 V ~ 5.5 V 數據轉換器:A/D 8x10b 振蕩器型:內部 工作溫度:-40°C ~ 125°C 封裝/外殼:44-TQFP 包裝:剪切帶 (CT) 其它名稱:ATMEGA324P-B15AZCT |
| MPC52100J | 功能描述:厚膜電阻器 - 透孔 RoHS:否 制造商:Caddock 電阻:27 kOhms 容差:1 % 功率額定值:8 W 溫度系數:50 PPM / C 系列:MS 端接類型:Axial 電壓額定值:2 kV 工作溫度范圍:- 15 C to + 275 C 尺寸:8.89 mm Dia. x 23.11 mm L 封裝:Bulk |
| MPC52100J | 制造商:TE Connectivity 功能描述:RESISTOR 5W 10R |
發布緊急采購，3分鐘左右您將得到回復。