- 您現在的位置：買賣IC網 > PDF目錄45354 > MPC8245TVV300D (MOTOROLA INC) 32-BIT, 300 MHz, RISC PROCESSOR, PBGA352 PDF資料下載
參數資料
| 型號： | MPC8245TVV300D |
| 廠商： | MOTOROLA INC |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 32-BIT, 300 MHz, RISC PROCESSOR, PBGA352 |
| 封裝： | 35 X 35 MM, 1.70 MM HEIGHT, 1.27 MM PITCH, CAVITY-UP, TBGA-352 |
| 文件頁數： | 32/60頁 |
| 文件大?。?/td> | 674K |
| 代理商： | MPC8245TVV300D |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁當前第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁
38
MPC8245 Integrated Processor Hardware Specications
MOTOROLA
PLL Configuration
1.6
PLL Conguration
The internal PLLs of the MPC8245 are congured by the PLL_CFG[0:4] signals. For a given
PCI_SYNC_IN (PCI bus) frequency, the PLL conguration signals set both the peripheral logic/memory
bus PLL (VCO) frequency of operation for the PCI-to-memory frequency multiplying and the MPC603e
CPU PLL (VCO) frequency of operation for memory-to-CPU frequency multiplying. The PLL
DA[14:15]
F1 J2
Output
GVDD
DRV_MEM_CTRL
2, 6
Notes:
1.
Place a pull-up resistor of 120
or less on the TEST0 pin.
2.
Treat these pins as no connects (NC) unless using debug address functionality.
3.
This pin has an internal pull-up resistor which is enabled only when the MPC8245 is in the reset state. The value
of the internal pull-up resistor is not guaranteed, but is sufcient to ensure that a logic 1 is read into conguration
bits during reset.
4.
This pin is a reset conguration pin.
5.
DL[0] is a reset conguration pin and has an internal pull-up resistor which is enabled only when the MPC8245 is
in the reset state. The value of the internal pull-up resistor is not guaranteed, but is sufcient to ensure that a logic 1
is read into conguration bits during reset.
6.
Multi-pin signals such as AD[31:0] or MDL[0:31] have their physical package pin numbers listed in order,
corresponding to the signal names. Example: AD0 is on pin C22, AD1 is on pin D22, ..., AD31 is on pin V25.
7.
GNT4 is a reset conguration pin and has an internal pull-up resistor which is enabled only when the MPC8245 is
in the reset state.
8.
Recommend a weak pull-up resistor (2–10 k
) be placed on this PCI control pin to LVDD.
9.
10. Recommend a weak pull-up resistor (2–10 k
) be placed on this pin to OVDD.
11. Recommend a weak pull-up resistor (2–10 k
) be placed on this pin to GVDD.
12. This pin has an internal pull-up resistor which is enabled at all times. The value of the internal pull-up resistor is
not guaranteed, but is sufcient to prevent unused inputs from oating.
13. External PCI clocking source or fan-out buffer may be required for system if using the MPC8245 DUART
functionality since PCI_CLK[0:3] are not available in DUART mode. Only PCI_CLK4 is available in DUART mode.
14. This pin is a multiplexed signal and appears more than once in this table.
15. This pin is affected by programmable PCI_HOLD_DEL parameter.
16. This pin is an open drain signal.
17. This pin can be programmed to be driven (default) or can be programmed (in PMCR2) to be open drain.
18. This pin is a sustained three-state pin as dened by the PCI Local Bus Specication.
19. OSC_IN utilizes the 3.3-V PCI interface driver which is 5-V tolerant, see Table 2 for details.
20. PLL_CFG[0:4] signals are sampled a few clocks after the negation of HRST_CPU and HRST_CTRL.
21. SDRAM_CLK[0:3] and SDRAM_SYNC_OUT signals use DRV_MEM_CTRL for chip Rev 1.1 (A). These signals
use DRV_MEM_CLK for chip Rev 1.2 (B).
22. The 266- and 300-MHz part offerings can be run at a source voltage of 1.8 ± 100 mV or 2.0 ± 100 mV. Note that
source voltage should be 2.0 ± 100 mV for 333- and 350-MHz parts.
23. This pin was formally LAVDD on the MPC8240. It is a no connect on the MPC8245. This should not pose a problem
when replacing an MPC8240 with an MPC8245.
24. The driver capability of this pin is hardwired to 40
and cannot be changed.
Table 17. MPC8245 Pinout Listing (continued)
Name
Pin Number
Type
Power
Supply
Output
Driver Type
Notes
相關PDF資料 |
PDF描述 |
|---|---|
| MPC8250ACZQIHBX | 32-BIT, 200 MHz, RISC PROCESSOR, PBGA516 |
| MPC8250AVVLHDX | 32-BIT, 250 MHz, RISC PROCESSOR, PBGA480 |
| MPC8250AVRIHBX | 32-BIT, 200 MHz, RISC PROCESSOR, PBGA516 |
| MPC8250ACZUIHBX | 32-BIT, 200 MHz, RISC PROCESSOR, PBGA480 |
| MPC8250AZQIFBX | 32-BIT, 200 MHz, RISC PROCESSOR, PBGA516 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MPC8245TVV333D | 功能描述:微處理器 - MPU INTEGRATED HOST PROC RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324 |
| MPC8245TVV350D | 功能描述:微處理器 - MPU INTEGRATED HOST PROC RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324 |
| MPC8245TZU266D | 功能描述:微處理器 - MPU 266MHz 505.4MIPS RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324 |
| MPC8245TZU300D | 功能描述:微處理器 - MPU 300MHz 570MIPS RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324 |
| MPC8245TZU333D | 功能描述:微處理器 - MPU 333MHz 632.7MIPS RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324 |
發布緊急采購，3分鐘左右您將得到回復。