參數資料
型號: MSM5117800D
廠商: OKI SEMICONDUCTOR CO., LTD.
英文描述: 2,097,152-Word x 8-Bit DYNAMIC RAM : FAST PAGE MODE TYPE
中文描述: 2097152字× 8位動態隨機存儲器:快速頁面模式型
文件頁數: 8/14頁
文件大小: 163K
代理商: MSM5117800D
MSM5117800D
8/14
Notes:
1.
A start-up delay of 200
m
s is required after power-up, followed by a minimum of eight initialization
cycles (RAS-only refresh or CAS before RAS refresh) before proper device operation is achieved.
2.
The AC characteristics assume t
T
= 5ns.
3.
V
IH
(Min.) and V
IL
(Max.) are reference levels for measuring input timing signals. Transition times
(t
T
) are measured between V
IH
and V
IL
.
4.
This parameter is measured with a load circuit equivalent to 2 TTL load and 100pF.
5.
Operation within the t
RCD
(Max.) limit ensures that t
RAC
(Max.) can be met.
t
RCD
(Max.) is specified as a reference point only. If t
RCD
is greater than the specified t
RCD
(Max.)
limit, then the access time is controlled by t
CAC
.
6.
Operation within the t
RAD
(Max.) limit ensures that t
RAC
(Max.) can be met.
t
RAD
(Max.) is specified as a reference point only. If t
RAD
is greater than the specified t
RAD
(Max.)
limit, then the access time is controlled by t
AA
.
7.
t
OFF
(Max.) and t
OEZ
(Max.) define the time at which the output achieved the open circuit
condition and are not referenced to output voltage levels.
8.
t
RCH
or t
RRH
must be satisfied for a read cycle.
9.
t
WCS
, t
CWD
, t
RWD
, t
AWD
and t
CPWD
are not restrictive operating parameters. They are included in
the data sheet as electrical characteristics only. If t
WCS
3
t
WCS
(Min.), then the cycle is an early
write cycle and the data out will remain open circuit (high impedance) throughout the entire cycle.
If t
CWD
3
t
CWD
(Min.), t
RWD
3
t
RWD
(Min.), t
AWD
3
t
AWD
(Min.) and t
CPWD
3
t
CPWD
(Min.), then
the cycle is a read modify write cycle and data out will contain data read from the selected cell; if
neither of the above sets of conditions is satisfied, then the condition of the data out (at access time)
is indeterminate.
10. These parameters are referenced to the CAS leading edge in an early write cycle, and to the WE
leading edge in an OE control write cycle, or a read modify write cycle.
11. The test mode is initiated by performing a WE and CAS before RAS refresh cycle. This mode is
latched and remains in effect until the exit cycle is generated. The test mode specified in this data
sheets is a 2-bit parallel test function, CA0 and CA1 are not used. In a read cycle, if all internal bits
are equal, the DQ pin will indicate a high level. If any internal bits are not equal, the DQ pin will
indicate a low level. The test mode is cleared and the memory device returned to its normal
operating state by performing a RAS-only refresh cycle or a CAS before RAS refresh cycle.
12. In a test mode read cycle, the value of access time parameters is delayed for 5ns for the specified
value. These parameters should be specified in test mode cycle by adding the above value to the
specified value in this data sheet.
相關PDF資料
PDF描述
MSM5117805A 2,097,152-Word x 8-Bit DYNAMIC RAM : FAST PAGE MODE TYPE WITH EDO
MSM5117805B 2097152-word*8-bit dynamic ram:FAST PAGE MODE TYPE WITH EDO
MSM5117805C 2097152-word*8-bit dynamic ram:FAST PAGE MODE TYPE WITH EDO
MSM5117805D 2,097,152-Word x 8-Bit DYNAMIC RAM : FAST PAGE MODE TYPE WITH EDO
MSM5117805F 2,097,152-Word 】 8-Bit DYNAMIC RAM : FAST PAGE MODE TYPE WITH EDO
相關代理商/技術參數
參數描述
MSM5117800D-60JS 制造商:OKI 制造商全稱:OKI electronic componets 功能描述:2,097,152-Word x 8-Bit DYNAMIC RAM : FAST PAGE MODE TYPE
MSM5117800F 制造商:OKI 制造商全稱:OKI electronic componets 功能描述:2,097,152-Word x 8-Bit DYNAMIC RAM : FAST PAGE MODE TYPE
MSM5117800F-50 制造商:OKI 制造商全稱:OKI electronic componets 功能描述:2,097,152-Word x 8-Bit DYNAMIC RAM : FAST PAGE MODE TYPE
MSM5117800F-60 制造商:OKI 制造商全稱:OKI electronic componets 功能描述:2,097,152-Word x 8-Bit DYNAMIC RAM : FAST PAGE MODE TYPE
MSM5117800F-70 制造商:OKI 制造商全稱:OKI electronic componets 功能描述:2,097,152-Word x 8-Bit DYNAMIC RAM : FAST PAGE MODE TYPE