參數資料
型號: MSM6665-xx
廠商: OKI SEMICONDUCTOR CO., LTD.
英文描述: DOT MATRIX LCD CONTROLLER WITH 17-DOT COMMON DRIVER AND 80-DOT SEGMENT DRIVER
中文描述: 點陣LCD控制器,17點通用驅動程序和80點段驅動
文件頁數: 13/30頁
文件大小: 261K
代理商: MSM6665-XX
13/30
Semiconductor
MSM6665-xx
DISP (Display on/off)
[1,0,0,X,1,0,0,1/0]
Command used to control lighing-on and lighting-off for the LCD panel.
When D0 is "1", the display of the LCD panel goes on, and When D0 is "0", it goes off.
When the display is off, the V
DD
level voltage is output on all of pins of both the segment
driver and the common driver.
D0 is set to "0" after inputting Reset.
ABBC 1/5 (Arbitrator Blink Control 1/5 dot)
[1,0,0,1,1,1,0,1/0]
Command used to do switching between arbitrator’s blinking in a 1-dot unit and or in
a 5-dot unit.
When D0 is "1", arbitrator’s blinking comes in the 1-dot unit mode.
When D0 is "0", it comes in the 5-dot unit mode.
D0="0" is set after inputting Reset.
Note)
1-dot unit blink setting
See ABB.
5-dot unit blink setting
See CHB.
ABB (Arbitrator Blink)
[1,0,0,0,1,1,0,1/0]
Command used to control on/off of blinking, which is valid only when arbitrator’s
blinking is set in the 1-dot unit mode.
Data , which are entered via SI pin after setting D0="1", are taken as arbitrator blink data
(1-dot unit).
Input blink data correspond to each of arbitrator’s dots. When "1", blinking is on, and
when "0", blinking is off.
Note that the arbitrator, which arbitrator-on is not specified, is not able to blink, though
blink-setting is available. Dummy data must be entered into the arbitrator blink data D5
thru D7.
It is impossible to write data in addressed 00H through 31H.
D0="0" is set after inputting Reset.
Note)
If blink is set in the 5-dot unit mode, ABB command setting (D0="1" or "0") is
available, but blink-on/off setting via input of display data is impossible.
AINC (Address Increment)
[1,0,0,X,1,X,1,X]
Command used to increment the value of the address pointer by 1.
The pointer is increment by 1 each time this command is executed. The operation set by
LOT command is given to the address before being increased by 1 each time this
command is execution.
相關PDF資料
PDF描述
MSM6679A-110 Voice Synthesiser(SI/SD話音識別,記錄/播放,語音合成器)
MSM7524 DTMF Transceiver(雙音多頻收發器)
MSM7547 Voice Signal Level Control LSI(音頻信號電平控制LSI)
MSM80C86A-10 16-Bit CMOS Microprocessor(全靜態設計,最高工作頻率10MHz,數據、地址復用,16位微處理器)
MSM80C88A-10 8-Bit CMOS Microprocessor(內部結構為16位,外圍接口8位,8位微處理器)
相關代理商/技術參數
參數描述
MSM6669 制造商:OKI 制造商全稱:OKI electronic componets 功能描述:80-DOT LCD SEGMENT DRIVER
MSM6679A-110 制造商:OKI 制造商全稱:OKI electronic componets 功能描述:SI/SD Voice Recognizer, Recorder/Player, and Speech Synthesizer
MSM6679AL-110 制造商:OKI 制造商全稱:OKI electronic componets 功能描述:SI/SD Voice Recognizer, Recorder/Player, and Speech Synthesizer
MSM6684B 制造商:OKI 制造商全稱:OKI electronic componets 功能描述:4,194,304-word x 1-bit Serial Register
MSM6685 制造商:OKI 制造商全稱:OKI electronic componets 功能描述:8,388,608-Word x 1-Bit Serial Register