參數資料
型號: MSP430F1101AIDW
廠商: TEXAS INSTRUMENTS INC
元件分類: 微控制器/微處理器
英文描述: 16-BIT, FLASH, 8 MHz, RISC MICROCONTROLLER, PDSO20
封裝: GREEN, PLASTIC, SOIC-20
文件頁數: 3/43頁
文件大?。?/td> 869K
代理商: MSP430F1101AIDW
MSP430C11x1, MSP430F11x1A
MIXED SIGNAL MICROCONTROLLER
SLAS241I SEPTEMBER 1999 REVISED DECEMBER 2008
11
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
peripherals
Peripherals are connected to the CPU through data, address, and control buses and can be handled using all
instructions. For complete module descriptions, see the MSP430x1xx Family User’s Guide, literature number
SLAU049.
oscillator and system clock
The clock system is supported by the basic clock module that includes support for a 32768-Hz watch crystal
oscillator, an internal digitally-controlled oscillator (DCO), and a high-frequency crystal oscillator. The basic
clock module is designed to meet the requirements of both low system cost and low power consumption. The
internal DCO provides a fast turn-on clock source and stabilizes in less than 6
μs. The basic clock module
provides the following clock signals:
D Auxiliary clock (ACLK), sourced from a 32768-Hz watch crystal or a high-frequency crystal
D Main clock (MCLK), the system clock used by the CPU
D Sub-Main clock (SMCLK), the subsystem clock used by the peripheral modules
digital I/O
There are two 8-bit I/O ports implemented—ports P1 and P2 (only six P2 I/O signals are available on external
pins):
D All individual I/O bits are independently programmable.
D Any combination of input, output, and interrupt conditions is possible.
D Edge-selectable interrupt input capability for all the eight bits of port P1 and six bits of port P2.
D Read/write access to port-control registers is supported by all instructions.
NOTE:
Only six bits of port P2 (P2.0 to P2.5) are available on external pins, but all control and data bits
for port P2 are implemented.
watchdog timer (WDT)
The primary function of the WDT module is to perform a controlled system restart after a software problem
occurs. If the selected time interval expires, a system reset is generated. If the watchdog function is not needed
in an application, the module can be configured as an interval timer and can generate interrupts at selected time
intervals.
Comparator_A
The primary function of the Comparator_A module is to support precision slope analog-to-digital conversions,
battery-voltage supervision, and monitoring of external analog signals.
相關PDF資料
PDF描述
MSP430F1101IDW 16-BIT, FLASH, 8 MHz, RISC MICROCONTROLLER, PDSO20
MSP430F1111AIDW 16-BIT, FLASH, 8 MHz, RISC MICROCONTROLLER, PDSO20
MSP430F1121AIRGER 16-BIT, FLASH, 8 MHz, RISC MICROCONTROLLER, PQCC24
MSP430F1101IPWR 16-BIT, FLASH, 8 MHz, RISC MICROCONTROLLER, PDSO20
MSP430F1121IDWR 16-BIT, FLASH, 8 MHz, RISC MICROCONTROLLER, PDSO20
相關代理商/技術參數
參數描述
MSP430F1101AIDW 制造商:Texas Instruments 功能描述:16-Bit Microcontroller IC 制造商:Texas Instruments 功能描述:IC, 16BIT MCU, MSP430, 8MHz, SOIC-20
MSP430F1101AIDWR 功能描述:16位微控制器 - MCU 1kB Flash 128B RAM Comparator RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT
MSP430F1101AIPW 功能描述:16位微控制器 - MCU 1kB Flash 128B RAM Comparator RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT
MSP430F1101AIPW 制造商:Texas Instruments 功能描述:16-Bit Microcontroller IC
MSP430F1101AIPWR 功能描述:16位微控制器 - MCU 1kB Flash 128B RAM Comparator RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT