參數資料
型號: MSP430G2202IRSA16
廠商: TEXAS INSTRUMENTS INC
元件分類: 微控制器/微處理器
英文描述: RISC MICROCONTROLLER, PQCC16
封裝: GREEN, PLASTIC, VQFN-16
文件頁數: 5/54頁
文件大?。?/td> 871K
代理商: MSP430G2202IRSA16
DCO(RSEL,DCO+1)
DCO(RSEL,DCO)
average
DCO(RSEL,DCO)
DCO(RSEL,DCO+1)
32 × f
× f
f
=
MOD × f
+ (32 – MOD) × f
MSP430G2x32
MSP430G2x02
SLAS723B
– DECEMBER 2010 – REVISED MARCH 2011
Main DCO Characteristics
All ranges selected by RSELx overlap with RSELx + 1: RSELx = 0 overlaps RSELx = 1, ... RSELx = 14
overlaps RSELx = 15.
DCO control bits DCOx have a step size as defined by parameter SDCO.
Modulation control bits MODx select how often fDCO(RSEL,DCO+1) is used within the period of 32 DCOCLK
cycles. The frequency fDCO(RSEL,DCO) is used for the remaining cycles. The frequency is an average equal to:
Brownout
The brownout circuit is implemented to provide the proper internal reset signal to the device during power on and
power off.
Digital I/O
There are two 8-bit I/O ports implemented:
All individual I/O bits are independently programmable.
Any combination of input, output, and interrupt condition(port P1 and port P2 only) is possible.
Edge-selectable interrupt input capability for all the eight bits of port P1 and port P2, if available.
Read/write access to port-control registers is supported by all instructions.
Each I/O has an individually programmable pullup/pulldown resistor.
Each I/O has an individually programmable pin-oscillator enable bit to enable low-cost touch sensing.
WDT+ Watchdog Timer
The primary function of the watchdog timer (WDT+) module is to perform a controlled system restart after a
software problem occurs. If the selected time interval expires, a system reset is generated. If the watchdog
function is not needed in an application, the module can be disabled or configured as an interval timer and can
generate interrupts at selected time intervals.
Copyright
2010–2011, Texas Instruments Incorporated
13
相關PDF資料
PDF描述
MSP430G2112IRSA16 16-BIT, FLASH, 16 MHz, RISC MICROCONTROLLER, PQCC16
MSP430G2212IRSA16 16-BIT, FLASH, 16 MHz, RISC MICROCONTROLLER, PQCC16
MSP430G2153IPW28R 16-BIT, FLASH, 16 MHz, RISC MICROCONTROLLER, PDSO28
MSP430G2113IRHB32 16-BIT, FLASH, 16 MHz, RISC MICROCONTROLLER, PQCC32
MSP430G2313IPW28R 16-BIT, FLASH, 16 MHz, RISC MICROCONTROLLER, PDSO28
相關代理商/技術參數
參數描述
MSP430G2202IRSA16R 功能描述:16位微控制器 - MCU Mixed Signal Micro controller RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT
MSP430G2202IRSA16T 功能描述:16位微控制器 - MCU Mixed Signal Micro controller RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT
MSP430G2203IN20 功能描述:16位微控制器 - MCU Mixed Signal MCU RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT
MSP430G2203IPW20 功能描述:16位微控制器 - MCU Mixed Signal MCU RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT
MSP430G2203IPW20R 功能描述:16位微控制器 - MCU Mixed Signal MCU RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT