參數資料
型號： MT9079
廠商： Mitel Networks Corporation
英文描述： Advanced Controller for E1(先進的E1幀調節器和控制器)
中文描述： 高級控制器素E1（先進的素E1幀調節器和控制器）
文件頁數： 17/60頁
文件大?。?/td> 347K
代理商： MT9079
MT9079
4-223
CRC Error and E-bit Counters
CRC-4 errors and E-bit errors are counted by the
MT9079 in order to support compliance with CCITT
requirements. These eight bit counters are located
on page 4, addresses 1FH and 1EH respectively.
They are incremented by single error events, which
is a maximum rate of twice per CRC-4 multiframe.
There are two maskable interrupts associated with
the CRC error and E-bit error measurement. CRCI
and EBI are initiated when the least significant bit of
the appropriate counter toggles, and CRCO and
EBO are initiated when the appropriate counter
changes from FFH to 00H.
G.821 Bit Error Rate Estimation
A G.821 BERT estimation for an E1 link can be done
with either the BERT counter, when it is associated
with the FAS, or the Errored Frame Alignment Signal
counter. It should be noted that the BERT counter
will be incremented once for every bit error found in
the FAS, and not just once for every FAS in error.
The formula for the link BERT estimation is as
follows:
BERT estimation = BERT counter value/(N
*
F
*
T)
where:
N is the number of bits verified (i.e., when the FAS
is used N = 7; when a channel is selected N = 8).
F is the number of FAS or channels in one second
(i.e., when the FAS is used F= 4000, when a
channel is selected F = 8000).
T is the elapsed time in seconds.
A similar formula can be used with the FAS error
counter.
BERT estimation = FAS Error counter value/(7
*
4000
*
T).
The CRC-4 error counter can also be used for BERT
estimation. The formula for BERT estimation using
the CRC-4 error count is as follows:
BERT estimation = CEt counter value/(2048000
*
T)
where:
2048000 is the number of bits that are
received in one second.
T is the elapsed time in seconds.
A similar formula can be used to provide a BERT
estimation of the transmit direction by using the E-bit
error counter, EBt.
A more accurate BERT estimation can be done using
the Bipolar Violation Error counter. The BPV error
counter will count violations that are not due to HDB3
encoding. The formula for this is as follows:
BERT estimation = BPV Error counter value/(256
*
8000
*
T)
where:
256 is the number of bits per basic frame.
8000 is the number of basic frames in one second.
T is the elapsed time in seconds.
This assumes that one BPV error will be the result of
one bit error.
RAI and Continuous CRC-4 Error Counter
When the receive Remote Alarm Indication is active
(RAI = 1 - bit 3 of the NFAS) and a receive E-bit
indicates a remote error (En = 0), the RCRC counter
will be incremented. This counter will count the
number of submultiframes that were received in error
at the remote end of a link during a time when layer
one capabilities were lost at that end. This eight bit
RCRC counter is located on page 4, addresses 19H.
There are two maskable interrupts associated with
the RCRC counter. RCRI is initiated when the least
significant bit of the RCRC counter toggles, and
RCRO and EBO are initiated when the counter
changes from FFH to 00H.
Maintenance and Alarms
Error Insertion
Five types of error conditions can be inserted into
the transmit PCM 30 data stream through control
bits, which are located on page 2, address 10H.
These error events include the bipolar violation
errors (BPVE), CRC-4 errors (CRCE), FAS errors
(FASE), NFAS errors (NFSE), and a loss of signal
condition (LOSE). The LOSE function overrides the
HDB3 encoding function.
相關PDF資料
PDF描述
MT9080B SMX - Switch Matrix Module(用于消費類轉換應用的開關矩陣模塊)
MT90810 Flexible MVIP(Multi-Vendor Integration Protocol) Interface Circuit(彈性MVIP接口電路)
MT90812 Integrated Digital Switch (IDX)(集成數字開關)
MT90840AK Distributed Hyperchannel Switch
MT90840AP Distributed Hyperchannel Switch
相關代理商/技術參數
參數描述
MT9079AC 制造商:MITEL 制造商全稱:Mitel Networks Corporation 功能描述:CMOS ST-BUS? FAMILY Advanced Controller for E1
MT9079AE 制造商:MITEL 制造商全稱:Mitel Networks Corporation 功能描述:CMOS ST-BUS? FAMILY Advanced Controller for E1
MT9079AL 制造商:MITEL 制造商全稱:Mitel Networks Corporation 功能描述:CMOS ST-BUS⑩ FAMILY Advanced Controller for E1
MT9079AP 制造商:MITEL 制造商全稱:Mitel Networks Corporation 功能描述:CMOS ST-BUS⑩ FAMILY Advanced Controller for E1
MT9079APR 制造商:Microsemi Corporation 功能描述:FRAMER E1 5V 44PLCC - Tape and Reel
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*