- 您現在的位置：買賣IC網 > Datasheet目錄45 > NCP1606BDR2G (ON Semiconductor)IC POWER FACTOR CONTROLLER 8SOIC Datasheet資料下載
參數資料
| 型號： | NCP1606BDR2G |
| 廠商： | ON Semiconductor |
| 文件頁數： | 12/22頁 |
| 文件大?。?/td> | 245K |
| 描述： | IC POWER FACTOR CONTROLLER 8SOIC |
| 標準包裝： | 1 |
| 模式： | 臨界傳導（CRM） |
| 電流 - 啟動： | 20µA |
| 電源電壓： | 10.3 V ~ 20 V |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-SOIC（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 8-SOICN |
| 包裝： | 標準包裝 |
| 其它名稱： | NCP1606BDR2GOSDKR |
NCP1606
http://onsemi.com
12
the average demand only. Therefore, the output capacitor
must absorb the difference between the delivered power
and the power consumed by the load. This means that when
the power fed to the load is lower than the demand, the
output capacitor discharges to compensate for the lack of
power. Alternatively, when the supplied power is higher
than that absorbed by the load, the output capacitor charges
to store the excess energy. The situation is depicted in
Figure 26.
Figure 26. Output Voltage Ripple for a Constant Output Power
V
OUT
P
OUT
P
IN
Iac
Vac
As a consequence, the output voltage exhibits a ripple at
a frequency of either 100 Hz (for 50 Hz mains such as in
Europe) or 120 Hz (for 60 Hz mains in the USA). This
ripple must not be taken into account by the regulation loop
because the error amplifiers output voltage must be kept
constant over a given ac line cycle for a proper shaping of
the line current. Due to this constraint, the regulation
bandwidth is typically set below 20 Hz. For a simple type 1
compensation network, only a capacitor is placed between
FB and Control (see Figure 1). In this configuration, the
capacitor necessary to attenuate the bulk voltage ripple is
given by:
C
COMP
+
10
G
20
4 @ p f
line
@ R
OUT1
(eq. 3)
where G is the attenuation level in dB (commonly 60 dB)
ON TIME SEQUENCE
Since the NCP1606 is designed to control a CRM boost
converter, its switching pattern must accommodate
constant on times and variable off times. The Controller
generates the on time via an external capacitor connected
to pin 3 (Ct). A current source charges this capacitor to a
level determined by the Control pin voltage. Specifically,
Ct is charged to V
CONTROL
minus the V
EAL
offset
(typically 2.1 V). Once this level is exceeded, the drive is
turned off (Figure 27).
Figure 27. On Time Generation
Control
Ct
+
PWM
+
DRV
I
CHARGE
t
ON
V
EAL
V
CONTROL
V
EAL
t
ON
V
Ct
V
Ct(off)
V
DD
DRV
V
CONTROL
Since V
CONTROL
varies with the RMS line level and
output load, this naturally satisfies equation 1. And if the
values of compensation components are sufficient to filter
相關PDF資料 |
PDF描述 |
|---|---|
| NCP1607BDR2G | IC PFC CONTROLLER CRM 8SOIC |
| NCP1611BDR2G | IC PFC CTLR HE ENHANCED 8-SOIC |
| NCP1651DR2G | IC PFC CONTROLLER CCM/DCM 16SOIC |
| NCP1654BD133R2G | IC PFC CCM 133KHZ 8-SOIC |
| NCP1927DR2G | IC CTLR PFC/FLYBACK 16-SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| NCP1606BOOSTGEVB | 功能描述:電源管理IC開發工具 OSPI NCP1606 100 W BOOST RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V |
| NCP1606BPG | 功能描述:功率因數校正 IC LO CST PWR FCTR CONT RoHS:否 制造商:Fairchild Semiconductor 開關頻率:300 KHz 最大功率耗散: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Reel |
| NCP1607BDR2G | 功能描述:功率因數校正 IC CST EFCT PW FCTR CTR RoHS:否 制造商:Fairchild Semiconductor 開關頻率:300 KHz 最大功率耗散: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Reel |
| NCP1607BOOSTGEVB | 功能描述:BOARD EVAL NCP1607 100W BOOST RoHS:是 類別:編程器，開發系統 >> 評估演示板和套件 系列:* 標準包裝:1 系列:PCI Express® (PCIe) 主要目的:接口，收發器，PCI Express 嵌入式:- 已用 IC / 零件:DS80PCI800 主要屬性:- 次要屬性:- 已供物品:板 |
| NCP1608BDR2G | 功能描述:功率因數校正 IC COST EFFECT PWR FACT CONT RoHS:否 制造商:Fairchild Semiconductor 開關頻率:300 KHz 最大功率耗散: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。