參數資料
型號: NCV8881PWR2G
廠商: ON Semiconductor
文件頁數: 29/33頁
文件大?。?/td> 321K
描述: IC REG TRPL BUCK/LINEAR 16SOIC
標準包裝: 1
拓?fù)洌?/td> 降壓(降壓)(1),線性(LDO)(2)
功能: 車載
輸出數: 3
頻率 - 開關: 170kHz
電壓/電流 - 輸出 1: 3.3 V ~ 8 V,1.5A
電壓/電流 - 輸出 2: 5V,100mA
電壓/電流 - 輸出 3: 8.5V,40mA
帶 LED 驅動器:
帶監控器:
帶序列發生器:
電源電壓: 5 V ~ 19 V
工作溫度: -40°C ~ 150°C
安裝類型: 表面貼裝
封裝/外殼: 16-SOIC(0.295",7.50mm 寬)裸露焊盤
供應商設備封裝: 16-SOIC W
包裝: 標準包裝
其它名稱: NCV8881PWR2GOSDKR
NCV8881
http://onsemi.com
29
WATCHDOG STUCK HIGH; ENABLE = LOW, THEN EN = HIGH RESTARTS
3.3V
WDI STUCK HIGH
NORMAL RESPONSE
5V
0
WDI
1
2
3
4
5
6
7
9
10    11    12
RESB
ENABLE
VIN
8
13    14    15    16
WATCHDOG
DELAY
DELAY
POR
BOOT DELAY
DELAY
POR
BOOT DELAY
NORMAL RESPONSE
Figure 56. Watchdog Stuck HIGH, EN Input LOW; then EN Goes HIGH to Restart the Regulators
0
SMPS OUTPUT OUT OF REGULATION TO RESB LOW DELAY
VFBMONL
1
2
3
4
5
6
7
9
10
11
12
RESB
3.3V
THRESHOLD
8
tFBLDLY
13
14
Figure 57. RESB Pulled Low as the SMPS Output Voltage (pullup source for RESB) Drops Out of Regulation
APPLICATION INFORMATION
Input Capacitors
The primary input capacitor should be a ceramic of at least
4.7 mF placed between the VIN pin and the ground terminal
of the SMPS freewheeling diode in order to reduce input
voltage perturbations present when the NCV8881 SMPS is
heavily loaded. A secondary 0.1 mF ceramic capacitor
positioned as closely as possible between the VIN and GND
pins of the NCV8881 provides greater reduction of input
perturbations than further increasing the value of the
primary ceramic capacitor, and can be more effectively
positioned than the larger 4.7 mF capacitor without
compromising PCB thermal conductivity.
LDO Output Capacitor Selection
The LDOs have been compensated to work with output
capacitors above 3.3 mF having an ESR from 200 mW up to
5 W over the full range of output current and temperature.
Lower capacitance and ESR can be used for lighter load
requirements. Tantalum, Aluminum or Polymer
Electrolytic, capacitors can be used. Ceramic capacitors
should have series resistance added to be within the
recommended ESR range. There are many capacitor
vendors which supply automotive rated parts that fall within
these ranges. For example, the SUNCON EPseries
Aluminum Electrolytic capacitors are well suited well for
automotive radio applications.
Setting the SMPS Output Voltage
To set the output voltage of the switching regulator, use
the following equation:
V
SWOUT
+V
REF
 
1)
R1
R2
(eq. 1)
where V
REF
 is the Reference voltage, R1 is the resistor
connected from V
SWOUT
 to the FB pin and R2 is the resistor
connected from the FB pin to ground. To reduce the effect
相關PDF資料
PDF描述
NE1617ADS,112 IC TEMP MONITOR 16SSOP
NE1619DS,118 IC TEMP MONITOR 16SSOP
NIS5112D1R2G IC ELECTRONIC FUSE HOTSWAP 8SOIC
NIS5132MN2TXG IC ELECTRONIC FUSE 12V 10DFN
NIS5132MN3TXG IC ELECTRONIC FUSE 12V 10-DFN
相關代理商/技術參數
參數描述
NCV890100 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:1.2A, 2MHz Automotive Buck Switching Regulator
NCV890100MWTXG 功能描述:IC REG BUCK ADJ 1.2A 8-DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:50 系列:- 類型:升壓(升壓) 輸出類型:可調式 輸出數:1 輸出電壓:5 V ~ 25 V 輸入電壓:2.3 V ~ 5.5 V PWM 型:電流模式 頻率 - 開關:600kHz,1.2MHz 電流 - 輸出:1A 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP,8-MSOP(0.118",3.00mm 寬) 包裝:管件 供應商設備封裝:8-MSOP
NCV890100PDR2G 功能描述:直流/直流開關調節器 Auto Buck Switching Regulator 1.2A 2 MHz RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5
NCV890101 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:1.2A, 2MHz Automotive Buck Switching Regulator
NCV890101MWTXG 功能描述:IC REG BUCK ADJ 1.2A 10DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 類型:降壓(降壓) 輸出類型:兩者兼有 輸出數:1 輸出電壓:5V,1 V ~ 10 V 輸入電壓:3.5 V ~ 28 V PWM 型:電流模式 頻率 - 開關:220kHz ~ 1MHz 電流 - 輸出:600mA 同步整流器:無 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:16-SSOP(0.154",3.90mm 寬) 包裝:帶卷 (TR) 供應商設備封裝:16-QSOP