參數資料
型號: OP-37CJG
廠商: TEXAS INSTRUMENTS INC
元件分類: 運算放大器
英文描述: OP-AMP, 300 uV OFFSET-MAX, 63 MHz BAND WIDTH, CDIP8
封裝: CERAMIC, DIP-8
文件頁數: 8/24頁
文件大?。?/td> 391K
代理商: OP-37CJG
OP27A, OP27C, OP27E, OP27G
OP37A, OP37C, OP37E, OP37G
LOW-NOISE HIGH-SPEED PRECISION OPERATIONAL-AMPLIFIER
SLOS100C – FEBRUARY 1989 – REVISED SEPTEMBER 2000
16
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
TYPICAL CHARACTERISTICS
V
OP37
VOLTAGE-FOLLOWER
SMALL-SIGNAL PULSE RESPONSE
80
60
40
20
0
– 20
– 40
– 60
– 80
O
Output
V
oltage
mV
t – Time –
s
0
0.2
0.4
0.6
0.8
1
1.2
VCC
± = ±15 V
AV = 5
CL = 15 pF
TA = 25°C
V
O
Output
V
oltage
V
OP37
VOLTAGE-FOLLOWER
LARGE-SIGNAL PULSE RESPONSE
8
6
4
0
– 2
– 4
– 6
– 8
2
t – Time –
s
012
345
6
VCC
± = ±15 V
AV = 5
TA = 25°C
Figure 32
Figure 33
APPLICATION INFORMATION
general
The OP27 and OP37 series devices can be inserted directly onto OP07, OP05,
A725, and SE5534 sockets
with or without removing external compensation or nulling components. In addition, the OP27 and OP37 can
be fitted to
A741 sockets by removing or modifying external nulling components.
noise testing
Figure 34 shows a test circuit for 0.1-Hz to 10-Hz peak-to-peak noise measurement of the OP27 and OP37.
The frequency response of this noise tester indicates that the 0.1-Hz corner is defined by only one zero.
Because the time limit acts as an additional zero to eliminate noise contributions from the frequency band below
0.1 Hz, the test time to measure 0.1-Hz to 10-Hz noise should not exceed 10 seconds.
Measuring the typical 80-nV peak-to-peak noise performance of the OP27 and OP37 requires the following
special test precautions:
1.
The device should be warmed up for at least five minutes. As the operational amplifier warms up, the
offset voltage typically changes 4
V due to the chip temperature increasing from 10°C to 20°C starting
from the moment the power supplies are turned on. In the 10-s measurement interval, these
temperature-induced effects can easily exceed tens of nanovolts.
2.
For similar reasons, the device should be well shielded from air currents to eliminate the possibility of
thermoelectric effects in excess of a few nanovolts, which would invalidate the measurements.
3.
Sudden motion in the vicinity of the device should be avoided, as it produces a feedthrough effect that
increases observed noise.
相關PDF資料
PDF描述
OP-37GP OP-AMP, 220 uV OFFSET-MAX, 63 MHz BAND WIDTH, PDIP8
OP-47GT OP-AMP, 220 uV OFFSET-MAX, 70 MHz BAND WIDTH, MBCY8
OP-47CD/883B OP-AMP, 300 uV OFFSET-MAX, 70 MHz BAND WIDTH, CDIP8
OP-47CT/883B OP-AMP, 300 uV OFFSET-MAX, 70 MHz BAND WIDTH, MBCY8
OP-47CD OP-AMP, 300 uV OFFSET-MAX, 70 MHz BAND WIDTH, CDIP8
相關代理商/技術參數
參數描述
OP37CJGB 制造商:Rochester Electronics LLC 功能描述:- Bulk
OP-37CL 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Voltage-Feedback Operational Amplifier
OP37CP 制造商:TI 制造商全稱:Texas Instruments 功能描述:LOW-NOISE HIGH-SPEED PRECISION OPERATIONAL AMPLIFIERS
OP-37CP 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Voltage-Feedback Operational Amplifier
OP37CZ 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:Low-Noise Precision Operaional Amplifiers