- 您現在的位置：買賣IC網 > PDF目錄6027 > OP27GZ (Analog Devices Inc)IC OPAMP GP 8MHZ LN PREC 8DIP PDF資料下載
參數資料
| 型號： | OP27GZ |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 9/20頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC OPAMP GP 8MHZ LN PREC 8DIP |
| 標準包裝： | 48 |
| 放大器類型： | 通用 |
| 電路數： | 1 |
| 轉換速率： | 2.8 V/µs |
| 增益帶寬積： | 8MHz |
| 電流 - 輸入偏壓： | 15nA |
| 電壓 - 輸入偏移： | 30µV |
| 電壓 - 電源，單路/雙路(±)： | ±4 V ~ 18 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 通孔 |
| 封裝/外殼： | 8-DIP（0.300"，7.62mm） |
| 供應商設備封裝： | 8-PDIP |
| 包裝： | 管件 |
| 產品目錄頁面： | 774 (CN2011-ZH PDF) |
OP27
Rev. F | Page 17 of 20
CA
RA
R1
33k
R2
5k
TAPE
HEAD
0.47F
0.01F
10
15k
T1 = 3180s
T2 = 50s
OP27
+
–
00
31
7-
0
42
Figure 42. Tape Head Preamplifier
While the tape equalization requirement has a flat high
frequency gain above 3 kHz (T2 = 50 μs), the amplifier need
not be stabilized for unity gain. The decompensated OP37
provides a greater bandwidth and slew rate. For many applica-
tions, the idealized time constants shown can require trimming
of R1 and R2 to optimize frequency response for nonideal tape
head performance and other factors (see the References
section).
The network values of the configuration yield a 50 dB gain at
1 kHz, and the dc gain is greater than 70 dB. Thus, the worst-
case output offset is just over 500 mV. A single 0.47 μF output
capacitor can block this level without affecting the dynamic
range.
The tape head can be coupled directly to the amplifier input,
because the worst-case bias current of 80 nA with a 400 mH,
100 μ inch head (such as the PRB2H7K) is not troublesome.
Amplifier bias-current transients that can magnetize a head
present one potential tape head problem. The OP27 and OP37
are free of bias current transients upon power-up or power-
down. It is always advantageous to control the speed of power
supply rise and fall to eliminate transients.
In addition, the dc resistance of the head should be carefully
controlled and preferably below 1 kΩ. For this configuration,
the bias current induced offset voltage can be greater than the
100 pV maximum offset if the head resistance is not sufficiently
controlled.
A simple, but effective, fixed gain transformerless microphone
preamp (Figure 43) amplifies differential signals from low
impedance microphones by 50 dB and has an input impedance
of 2 kΩ. Because of the high working gain of the circuit, an
OP37 helps to preserve bandwidth, which is 110 kHz. As the
OP37 is a decompensated device (minimum stable gain of 5), a
dummy resistor, Rp, may be necessary if the microphone is to be
unplugged. Otherwise, the 100% feedback from the open input
can cause the amplifier to oscillate.
Common-mode input noise rejection will depend upon the
match of the bridge-resistor ratios. Either close tolerance (0.1%)
types should be used, or R4 should be trimmed for best CMRR.
All resistors should be metal film types for best stability and low
noise.
Noise performance of this circuit is limited more by the Input
Resistors R1 and R2 than by the op amp, as R1 and R2 each
generate a 4 nV/√Hz noise, while the op amp generates a
3.2 nV/√Hz noise. The rms sum of these predominant noise
sources is about 6 nV/√Hz, equivalent to 0.9 μV in a 20 kHz
noise bandwidth, or nearly 61 dB below a 1 mV input signal.
Measurements confirm this predicted performance.
LOW IMPEDANCE
MICROPHONE INPUT
(Z = 50 TO 200)
C1
5mF
R1
1k
R3
316k
R6
100
R4
316k
R2
1k
RP
30k
OUTPUT
R3
R1
R4
R2
=
OP27/
OP37
+
–
R7
10k
00
31
7-
0
43
Figure 43. Fixed Gain Transformerless Microphone Preamplifier
For applications demanding appreciably lower noise, a high
quality microphone transformer coupled preamplifier (Figure
44) incorporates the internally compensated OP27. T1 is a JE-
115K-E 150 Ω/15 kΩ transformer that provides an optimum
source resistance for the OP27 device. The circuit has an overall
gain of 40 dB, the product of the transformer’s voltage setup and
the op amp’s voltage gain.
JENSEN TRANSFORMERS
A1
OP27
R3
100
R1
121
R2
1100
C2
1800pF
OUTPUT
150
SOURCE
T11
T1 – JENSEN JE – 115K – E
1
3
6
2
00
31
7-
0
44
Figure 44. High Quality Microphone Transformer Coupled Preamplifier
Gain can be trimmed to other levels, if desired, by adjusting R2
or R1. Because of the low offset voltage of the OP27, the output
offset of this circuit is very low, 1.7 mV or less, for a 40 dB gain.
The typical output blocking capacitor can be eliminated in such
cases, but it is desirable for higher gains to eliminate switching
transients.
OP27
–18V
+18V
8
7
6
4
3
2
00317-045
Figure 45. Burn-In Circuit
相關PDF資料 |
PDF描述 |
|---|---|
| RMCF0603JT10K0 | RES 10K OHM 1/10W 5% 0603 SMD |
| AD708AQ | IC OPAMP GP DUAL PREC 8CDIP |
| AD8643ACPZ-R2 | IC OPAMP JFET R-R 3.5MHZ 16LFCSP |
| OP484FPZ | IC OPAMP GP R-R 4.25MHZ LN 14DIP |
| 0791081059 | CONN RCPT 2MM GOLD DL 20CKT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| OP-27GZ | 制造商:AD 制造商全稱:Analog Devices 功能描述:LOW NOISE, PRECISION OPERATIONAL AMPLIFIER |
| OP27NBC | 制造商:Analog Devices 功能描述: |
| OP27SAJ5/38510 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Analog IC |
| OP27SAZ5/38510 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Analog IC |
| OP280 | 功能描述:紅外發射源 SMD RoHS:否 制造商:Fairchild Semiconductor 波長:880 nm 射束角:+/- 25 輻射強度: 最大工作溫度:+ 100 C 最小工作溫度:- 40 C 封裝 / 箱體:Side Looker 封裝:Bulk |
發布緊急采購，3分鐘左右您將得到回復。