參數資料
型號： P0300EBRP2
英文描述： MCU CMOS 44 LD 10MHZ 8K OTP, 0C to +70C, 44-PLCC, TUBE
中文描述： SIDAC的| 40V的五（公報）最大| 800mA的我（縣）|對92VAR
文件頁數： 60/161頁
文件大?。?/td> 986K
代理商： P0300EBRP2
Analog Line Cards
SIDACtor
Data Book
3 - 20
Teccor Electronics
(972)580-7777
Reference Diagrams
Figure 3-19
uses Teccor
’
s
“
C
”
rated SIDACtors and the F1250T TeleLink fuse to meet
the surge immunity requirements of Bellcore 1089. On-hook protection is
accomplished using Teccor
’
s P1200SC and P200SC which were specifically designed
to protect Lucent Microelectronics Line Card Access Switch (LCAS). Off-hook
protection is accomplished using two P0641SC
’
s. Note the absence of any additional
series resistance. This is because the
“
C
”
series SIDACtor and F1250T TeleLink were
designed to withstand GR 1089 without the aid of additional components such as line
feed resistors and PTC
’
s.
Figure 3-20
uses the P2600SA and P0721SA for over voltage protection and the
F0500T for over current protection in addition to 20
of series resistance on both TIP
and RING. The series resistance is required to limit the transient surge currents to
within the surge current rating of the
“
A
”
series SIDACtors and the F0500T TeleLink
fuse.
Figure 3-21
uses Teccor
’
s Battrax to protect AMD
’
s Am79R79 from over-voltages and
the F1250T to protect against sustained power cross conditions. The Battrax was
designed specifically to protect SLIC
’
s that can not withstand potential differences
greater than V
REF
±10V.
Figure 3-22
shows how to protect a SLIC by utilizing 20
series resistors on both TIP
and RING in addition to Teccor
’
s Battrax (B1100CC) and a diode bridge (General
Semiconductor p/n EDF1BS). However, the overshoot caused by the diode bridge
must be considered. The series resistance (a minimum of 20
on TIP and 20
on
RING) limits the 100A simultaneous surge current from TIP to GND and RING to GND
(200A total) to within the surge current rating of the SIDACtor and Battrax. The diode
bridge shunts all positive voltages to GND and the B1100CC shunts all negative
voltages greater than |-V
REF
–
1.2V| to GND.
Some applications may require the use of 50
line feed resistors. In this instance,
Figure 3-23
shows how to replace multiple SLIC protectors using one B1160CC and
two EDF1BS diode bridges. The overshoot caused by the diode bridge must be
considered. The only caution in such an approach with regards to the Battrax is that it
is imperative that the sum of the loop currents does not exceed the Battrax
’
s holding
current. In
Figure 3-23
, the loop current would have to be limited to 80mA. For
applications that would require 4 twisted pair to be protected with one Battrax, the
B1200CC should be used and the loop current would have to be limited to 50mA.
相關PDF資料
PDF描述
P0602AARP 18LD 20MHZ .5K EPRM/128 EEPROM, -40C to +85C, 18-PDIP, TUBE
P0602AB 18LD 20MHZ .5K EPRM/128 EEPROM, -40C to +85C, 18-SOIC 300mil, TUBE
P0640SCRP SIDAC|77V V(BO) MAX|800MA I(S)|DO-214AA
P0641SARP 20LD 4MHZ 2K EPRM/128 EEPROM, 0C to +70C, 20-SSOP 208mil, TUBE
P0641SCRP 18LD 4MHZ 2K EPRM/128 EEPROM, -40C to +85C, 18-PDIP, TUBE
相關代理商/技術參數
參數描述
P0300EC 功能描述:硅對稱二端開關元件 500A 25V RoHS:否 制造商:Bourns 轉折電流 VBO:40 V 最大轉折電流 IBO:800 mA 不重復通態電流: 額定重復關閉狀態電壓 VDRM:25 V 關閉狀態漏泄電流（在 VDRM IDRM 下）: 保持電流（Ih 最大值）:50 mA 開啟狀態電壓:5 V 關閉狀態電容 CO:120 pF 最大工作溫度:+ 150 C 安裝風格:SMD/SMT 封裝 / 箱體:DO-214AA
P0300ECAP 功能描述:硅對稱二端開關元件 500A 22V RoHS:否 制造商:Bourns 轉折電流 VBO:40 V 最大轉折電流 IBO:800 mA 不重復通態電流: 額定重復關閉狀態電壓 VDRM:25 V 關閉狀態漏泄電流（在 VDRM IDRM 下）: 保持電流（Ih 最大值）:50 mA 開啟狀態電壓:5 V 關閉狀態電容 CO:120 pF 最大工作溫度:+ 150 C 安裝風格:SMD/SMT 封裝 / 箱體:DO-214AA
P0300ECL 功能描述:硅對稱二端開關元件 500A 22V RoHS:否 制造商:Bourns 轉折電流 VBO:40 V 最大轉折電流 IBO:800 mA 不重復通態電流: 額定重復關閉狀態電壓 VDRM:25 V 關閉狀態漏泄電流（在 VDRM IDRM 下）: 保持電流（Ih 最大值）:50 mA 開啟狀態電壓:5 V 關閉狀態電容 CO:120 pF 最大工作溫度:+ 150 C 安裝風格:SMD/SMT 封裝 / 箱體:DO-214AA
P0300ECLAP 功能描述:硅對稱二端開關元件 500A 22V RoHS:否 制造商:Bourns 轉折電流 VBO:40 V 最大轉折電流 IBO:800 mA 不重復通態電流: 額定重復關閉狀態電壓 VDRM:25 V 關閉狀態漏泄電流（在 VDRM IDRM 下）: 保持電流（Ih 最大值）:50 mA 開啟狀態電壓:5 V 關閉狀態電容 CO:120 pF 最大工作溫度:+ 150 C 安裝風格:SMD/SMT 封裝 / 箱體:DO-214AA
P0300ECLRP1 功能描述:硅對稱二端開關元件 500A 22V RoHS:否 制造商:Bourns 轉折電流 VBO:40 V 最大轉折電流 IBO:800 mA 不重復通態電流: 額定重復關閉狀態電壓 VDRM:25 V 關閉狀態漏泄電流（在 VDRM IDRM 下）: 保持電流（Ih 最大值）:50 mA 開啟狀態電壓:5 V 關閉狀態電容 CO:120 pF 最大工作溫度:+ 150 C 安裝風格:SMD/SMT 封裝 / 箱體:DO-214AA
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*