參數資料
型號: P0800EA
英文描述: 14 PIN BASELINE PIC W/1024 WORDS OF PROGRAM MEMORY & 72 BYTES OF SRAM, -40C to +125C, 14-SOIC 150mil, TUBE
中文描述: SIDAC的| 100V的五(公報)最大| 200UA我(縣)|到92
文件頁數: 5/6頁
文件大?。?/td> 114K
代理商: P0800EA
5
www.protekdevices.com
PP0640EA
thru
PP3500EC
05121.R1 4/02
APPLICATION NOTES
FIGURE 1: UL 1459 & FCC Part 68 - Metallic Protection
The TSS (Thyristor Surge Suppressor) device is located across the
tip-to-ring after a limiting resistor and fuse combination. R
TIP
and
R
resistors are optional depending upon the TSS device
selection. Without the resistors, the PP3100EB/EC is recommended.
However, with a resistance value of 7.5 Ohms for tip and ring, the
PP3100EA is recommended. Digital signals may use a lower TSS
device depending upon the total tip to ring voltage range. Selection
of the TSS device, either PPxxxxEA or EB/EC is based upon the
value of the tip and ring resistors. For the National Electric Code
(NEC) article 800, it is recommended that at least one fuse be used
in the tip or ring line for metallic surges. Fuses may be replaced with
a suitable Positive Temperature Coefficient (PTC) automatic
resettable current limiting device.
FIGURE 2 - UL 1459 & FCC Part 68 - Longitudinal Protection
There are two TSS devices, one located from tip-to-ground and one
ring-to-ground. For standard analog signals, the PP3100EA is
recommended with a typical resistor value for tip and ring of 15
Ohms. The PP3100EB/EC is recommended for resistor values of
7.5 Ohms each. The National Electric Code (NEC) article 800
requires two fuse elements when connecting to ground. Fuses or a
suitable Positive Temperature Coefficient (PTC) automatic resettable
current limiting device may be used. The purpose of this circuit is to
limit AC power current from getting on the ground line causing any
safety hazard.
FIGURE 3 - UL 1459 & FCC Part 68 - Metallic & Longitudinal
Protection
Three equal TSS devices are used in this application for metallic (tip-
to-ring) and longitudinal (tip-to-ground and ring-to-ground) protection.
For analog signals, the PP3100EB/EC is recommended. With a
resistance value of 15 Ohms for the tip and ring resistors, the
PP3100EA may be used. The National Electric Code (NEC) article
800 requires two fuse elements when connecting to ground. Fuses
or a suitable Positive Temperature Coefficient (PTC) automatic
resettable current limiting device may be used. This circuit is
recommended for protection against the Bellcore requirement: First
Level Lightning Surge Tests (Telecommunications Port), document #
GR-1089-CORE.
Fuse
TIP
R
Tip
RING
To
Protected
Equipment
R
Ring
FIGURE 1 - Metallic Protection
Tip
R
To
Protected
Equipment
Ring
R
TIP
RING
FIGURE 2 - Longitudinal Protection
Tip
R
To
Protected
Equipment
Ring
R
TIP
RING
FIGURE 3 - Metallic & Longitudinal Protection
相關PDF資料
PDF描述
P0800EB 14 PIN BASELINE PIC W/1024 WORDS OF PROGRAM MEMORY & 72 BYTES OF SRAM, -40C to +85C, 14-SOIC 150mil, TUBE
P0800EC 14 PIN Baseline PIC with 1024 words of program memory & 72 bytes of SRAM, -40C to +125C, 14-TSSOP , T/R
P0800SA 14 Pin, 1.5 KB Std Flash, 67 RAM, 12 I/O, Pb Free, -40C to +125C, 14-PDIP, TUBE
P0800SB 14 Pin, 1.5 KB Std Flash, 67 RAM, 12 I/O, Pb Free, -40C to +125C, 14-TSSOP, TUBE
P0800SC 14 PIN, 1.5KB STD FLASH, 67 RAM, 12 I/O, PB FREE, -40C to +85C, 14-TSSOP, TUBE
相關代理商/技術參數
參數描述
P0800EB 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Direct ProTek Replacement:PP0800EB
P0800EC 制造商:未知廠家 制造商全稱:未知廠家 功能描述:SIDAC|TO-92
P0800ECMC 功能描述:硅對稱二端開關元件 500A 75V RoHS:否 制造商:Bourns 轉折電流 VBO:40 V 最大轉折電流 IBO:800 mA 不重復通態電流: 額定重復關閉狀態電壓 VDRM:25 V 關閉狀態漏泄電流(在 VDRM IDRM 下): 保持電流(Ih 最大值):50 mA 開啟狀態電壓:5 V 關閉狀態電容 CO:120 pF 最大工作溫度:+ 150 C 安裝風格:SMD/SMT 封裝 / 箱體:DO-214AA
P0800SA 制造商:未知廠家 制造商全稱:未知廠家 功能描述:SIDAC|95V V(BO) MAX|10A I(S)|DO-214AA
P0800SARP 制造商:Teccor by Littelfuse 功能描述:20 A, SILICON SURGE PROTECTOR, DO-214AA