- 您現在的位置：買賣IC網 > PDF目錄369939 > P28F001BX-B150 (INTEL CORP) 1-MBIT (128K x 8) BOOT BLOCK FLASH MEMORY PDF資料下載
參數資料
| 型號： | P28F001BX-B150 |
| 廠商： | INTEL CORP |
| 元件分類： | PROM |
| 英文描述： | 1-MBIT (128K x 8) BOOT BLOCK FLASH MEMORY |
| 中文描述： | 128K X 8 FLASH 12V PROM, 150 ns, PDIP32 |
| 封裝： | 0.620 X 1.640 INCH, PLASTIC, DIP-32 |
| 文件頁數： | 14/33頁 |
| 文件大小： | 436K |
| 代理商： | P28F001BX-B150 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁當前第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁
28F001BX-T/28F001BX-B
290406–9
Bus
Command
Comments
Operation
Write
Erase
Suspend
Data
e
B0H
Write
Erase
Data
e
70H
Status Register
Standby/
Read
Read Status Register
Check SR.7
1
e
Ready, 0
e
Busy
Toggle OE
Y
or CE
Y
to
Update Status Register
Standby
Check SR.6
1
e
Suspended
Write
Read Array
Data
e
FFH
Read
Read array data from
block other than that
being erased.
Write
Erase Resume
Data
e
D0H
Figure 11. 28F001BX Erase Suspend/Resume Flowchart
Programming Equipment
For PROM programming equipment that cannot
bring RP
Y
to high voltage, OE
Y
provides an alter-
nate boot block access mechanism. OE
Y
must tran-
sition to V
HH
a minimum of 480 ns before the initial
program/erase setup command and held at V
HH
at
least 480 ns after program or erase confirm com-
mands are issued to the device. After this interval,
OE
Y
can return to normal TTL levels.
DESIGN CONSIDERATIONS
Three-Line Output Control
Flash memories are often used in larger memory ar-
rays. Intel provides three control inputs to accommo-
date multiple memory connections. Three-line con-
trol provides for:
a) lowest possible memory power dissipation
b) complete assurance that data bus contention will
not occur
To efficiently use these control inputs, an address
decoder should enable CE
Y
, while OE
Y
should be
connected to all memory devices and the system’s
READ
Y
control line. This assures that only selected
memory devices have active outputs while deselect-
ed memory devices are in Standby Mode. RP
Y
should be connected to the system POWERGOOD
signal to prevent unintended writes during system
power transitions. POWERGOOD should also toggle
during system reset.
14
相關PDF資料 |
PDF描述 |
|---|---|
| P28F001BX-B70 | 1-MBIT (128K x 8) BOOT BLOCK FLASH MEMORY |
| P28F001BX-B90 | DB9 MALE TO DB9 FEMALE AME |
| P28F002BC-T120 | 28F002BC 2-MBIT (256K X 8) BOOT BLOCK FLASH MEMORY |
| P28F002BC-T80 | 28F002BC 2-MBIT (256K X 8) BOOT BLOCK FLASH MEMORY |
| P28F512-150 | 512K(64Kx8)CMOS FLASH MEMORY |
相關代理商/技術參數 |
參數描述 |
|---|---|
| P28F001BX-B70 | 制造商:INTEL 制造商全稱:Intel Corporation 功能描述:1-MBIT (128K x 8) BOOT BLOCK FLASH MEMORY |
| P28F001BX-B90 | 制造商:INTEL 制造商全稱:Intel Corporation 功能描述:1-MBIT (128K x 8) BOOT BLOCK FLASH MEMORY |
| P28F001BX-T120 | 制造商:INTEL 制造商全稱:Intel Corporation 功能描述:1-MBIT (128K x 8) BOOT BLOCK FLASH MEMORY |
| P28F001BX-T150 | 制造商:Intel 功能描述:NOR Flash, 128K x 8, 32 Pin, Plastic, DIP |
| P28F001BX-T70 | 制造商:INTEL 制造商全稱:Intel Corporation 功能描述:1-MBIT (128K x 8) BOOT BLOCK FLASH MEMORY |
發布緊急采購，3分鐘左右您將得到回復。