- 您現在的位置：買賣IC網 > PDF目錄367724 > P80CL51HFH (NXP SEMICONDUCTORS) Low voltage 8-bit microcontrollers with UART PDF資料下載
參數資料
| 型號： | P80CL51HFH |
| 廠商： | NXP SEMICONDUCTORS |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | Low voltage 8-bit microcontrollers with UART |
| 中文描述： | 8-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP44 |
| 封裝： | 10 X 10 MM, 1.75 MM HEIGHT, PLASTIC, SOT-307-2, QFP-44 |
| 文件頁數： | 41/68頁 |
| 文件大?。?/td> | 305K |
| 代理商： | P80CL51HFH |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁當前第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁
1997 Apr 15
41
Philips Semiconductors
Product specification
Low voltage 8-bit microcontrollers with
UART
P80CL31; P80CL51
16 RESET
To initialize the P80CLx1 a reset is performed by either of
three methods:
Applying an external signal to the RST pin
Via Power-on-reset circuitry.
A reset leaves the internal registers as shown in
Chapter 18. The reset state of the port pins is
mask-programmable and can be defined by the user.
16.1
External reset using the RST pin
The reset input for the P80CLx1 is RST. A Schmitt trigger
is used at the input for noise rejection. The output of the
Schmitt trigger is sampled by the reset circuitry every
machine cycle. A reset is accomplished by holding the
RST pin HIGH for at least two machine cycles
(24 oscillator periods) while the oscillator is running.
The CPU responds by executing an internal reset. Port
pins adopt their reset state immediately after the RST goes
HIGH. During reset, ALE and PSEN are held HIGH.
The external reset is asynchronous to the internal clock.
The RST pin is sampled during state 5, phase 2 of every
machine cycle. After a HIGH is detected at the RST pin, an
internal reset is repeated until RST goes LOW.
The internal RAM is not affected by reset. When V
DD
is
turned on, the RAM contents are indeterminate.
16.2
Power-on-reset
The device contains on-chip circuitry which switches the
port pins to the customer defined logic level as soon as
V
DD
exceeds 1.3 V; if the mask option ‘ON’ has been
chosen. As soon as the minimum supply voltage is
reached, the oscillator will start up. However, to ensure
that the oscillator is stable before the controller starts, the
clock signals are gated away from the CPU for a further
1536 oscillator periods. During that time the CPU is held in
a reset state. A hysteresis of approximately 50 mV at a
typical power-on switching level of 1.3 V will ensure
correct operation (see Fig.27).
The on-chip Power-on-reset circuitry can also be switched
off via the mask option ‘OFF’. This option reduces the
Power-down current to typically 800 nA and can be
chosen if external reset circuitry is used. For applications
not requiring the internal reset, option ‘OFF’ should be
chosen.
An automatic reset can be obtained by connecting the RST
pin to V
DD
via a 10
μ
F capacitor. At power-on, the voltage
on the RST pin is equal to V
DD
minus the capacitor voltage,
and decreases from V
DD
as the capacitor charges through
the internal resistor (R
RST
) to ground. The larger the
capacitor, the more slowly V
RST
decreases. V
RST
must
remain above the lower threshold of the Schmitt trigger
long enough to effect a complete reset. The time required
is the oscillator start-up time, plus 2 machine cycles.
The Power-on-reset circuitry is shown in Fig.26.
Fig.25 Reset configuration.
handbook, halfpage
MLA580
SCHMITT
TRIGGER
RESET
CIRCUITRY
RST
Fig.26 Recommended Power-on-reset circuitry.
handbook, halfpage
VDD
RST
10
μ
F
RRST
MLA582
P80CL31
P80CL51
相關PDF資料 |
PDF描述 |
|---|---|
| P80CL31HFP | Low voltage 8-bit microcontrollers with UART |
| P80CL51HFP | Low voltage 8-bit microcontrollers with UART |
| P80CL31HFT | Low voltage 8-bit microcontrollers with UART |
| P80CL51 | Low voltage 8-bit microcontrollers with UART |
| P80CL51HFT | Low voltage 8-bit microcontrollers with UART |
相關代理商/技術參數 |
參數描述 |
|---|---|
| P80CL51HFHB | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Low-voltage single-chip 8-bit microcontrollers |
| P80CL51HFP | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Low voltage 8-bit microcontrollers with UART |
| P80CL51HFPN | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Low-voltage single-chip 8-bit microcontrollers |
| P80CL51HFT | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Low-voltage single-chip 8-bit microcontrollers |
| P80CL51HFTD | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Low-voltage single-chip 8-bit microcontrollers |
發布緊急采購，3分鐘左右您將得到回復。